Hoover FH50005 Support Question
Hoover FH50005 Support Question
Find answers below for this question about Hoover FH50005.Need a Hoover FH50005 manual? We have 1 online manual for this item!
Question posted by digitdeeper on April 28th, 2016
How Do I Remove Clear Cover On Dirty Water Tank , After I Remove Screws On Sucti
I see there are screws at bottom suction edge and two under what I believe is float cap ? not sure how to remove and don't want to break this . Help would GREATLY be APPRECIATED , Regards, P. D .W. THANKS in Advance
Current Answers
Related Hoover FH50005 Manual Pages
Manual - Page 2
... Dirty Water Tank 9 Placing Dirty Water Tank in the spaces provided. Manufacturing code
(Label located on rear of vacuum)
Contents
Important Safety Instructions 3-4
Cleaner Assembly 5 Carton Contents 5 Attach Base and Midsection 5 Attach Handle 5
How To Use...6-10 Cleaner Description 6 Preparing The Carpet 7 Remove Clean Water Solution Tank 7 Preparing Clean Water Solution Tank...
Manual - Page 3
... side of stairs on cord, or pull cord around sharp edges or corners. Do not place cleaner on cord. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
When using an electrical appliance, basic precautions should , has been dropped, damaged, left outdoors, or dropped into water, take it may result in injury or damage. • Do...
Manual - Page 4
.... • To help prevent matting and resoiling, avoid contact with solution in tanks. • Sitting in the sketch above stepes, your cleaner to cause cancer, birth defects or reproductive harm. CAUTION: TO REDUCE THE RISK OF DAMAGE:
• Avoid picking up hard, sharp objects with all local codes and ordinances. Clear obstructions if present...
Manual - Page 5
...Dirty Water Tank E. Screws (4) G. One at a time, place nut into cord clip on the backside of midsection with the remaining two (2) nuts and screws
1.2
UPPER HANDLE
• NOTICE •
Make sure the power cord is out of the way to avoid pinching. Handle B. Clean Water Solution Tank F. Make sure... in back of midsection and tighten. Cleaner Base C. Repeat this process with the...
Manual - Page 6
HOW TO USE
Cleaner Description
2.1
FRONT
BACK
17
FRONT
1. Power Cord 13. Clean Water Solution Tank Latch 3. Cord Hook 17. Upper Handle Screw
BACK
12. Dirty Water Tank 8. Carry Handle 14. Solution Spray Trigger
• NOTICE •
Wrap the cord in a counter-clockwise direction around the two cord hooks. Power On/Off Switch 10. Clean Water Solution Tank 4. Handle ...
Manual - Page 7
... carpet with hot tap water. Helpful Hints for best results. • Thoroughly clean the dirty water tank with cleaning solution while using the carpet cleaner. • For heavily soiled areas, additional applications may be necessary. • Allow plenty of time to dry completely.
Remove Clean Water Solution Tank
2.2 Grasp Clean Water Solution Tank under the furniture to...
Manual - Page 8
...; Using other detergent will cause the float to put into cleaning position.
2.9 Turn on .
• Turn OFF when emptying and filling tank.
• Do NOT oversaturate the carpet.
8
2.8
2.9
POWER ON/OFF SWITCH Preparing Clean Water Solution Tank with Detergent
2.4 Unscrew measuring cap from back side of Clean Water Solution Tank into cleaner and rotate top into position until...
Manual - Page 9
..., THIS INDICATES THE DIRTY WATER TANK IS FULL AND MUST BE EMPTIED. unplug before storing to remove dirty water and solution from forming.
2.14
2.11
2.13
• IMPORTANT •
Do not use a steady, forward and backward motion. EMPTYING DIRTY WATER TANK
Your Carpet Cleaner is equipped with hot tap water. Replace dirty water tank lid.
2.12
2.14 Rinse dirty water tank and filter with...
Manual - Page 10
... the dirty water tank is activated, empty the dirty water tank.
• If the dirty water tank does not appear full, turn the power switch off the suction.
• Use two capfuls (4 ounces) of Hoover® Brand Carpet & Upholstery Detergents per fill up of the cleaner.
Failure to settle and reset.
• If the float repeatedly shuts off the suction, empty the dirty water tank.
•...
Manual - Page 11
... at www.Hoover.com or call 1-800-944-9200. PROBLEM Cleaner won't run
Cleaner won't pick-up or low suction
Water escaping from cleaner
Cleaner won't dispense solution
POSSIBLE REASON 1. Dirty Water Tank is not installed
correctly. 3.
Pg. 9.
2. Clean Water Solution Tank not
installed properly.
1. Emptying Dirty Water Tank - Service
To obtain approved Hoover® service and genuine...
Manual - Page 12
... Hoover® Sales and Service Center for a full one way.
This warranty does
not cover pick up, delivery, transportation or house calls. Military Exchanges and Canada. The Warranty Period ...from date of shipping will not be assigned. WHAT THIS WARRANTY DOES NOT COVER This Warranty does not cover: use outside the country in material and workmanship for warranty service, cost...
Similar Questions
Do You Have Part# Ro-700735? Sure Hope So.
I am in need of a replacement for the dirty water tank latch for my Hoover Quick & Light carpet ...
I am in need of a replacement for the dirty water tank latch for my Hoover Quick & Light carpet ...
(Posted by tadbush 1 year ago)
My Hoover Steam Vac Sucks Up But Wont Dispense To The Dirty Water Tank
(Posted by mdp913 9 years ago)
Why Does The Red Ball Pop Up When There Is No Water In The Dirty Water Tank
(Posted by islandgirl 12 years ago)