Hoover FH50240 Support Question
Hoover FH50240 Support Question
Find answers below for this question about Hoover FH50240.Need a Hoover FH50240 manual? We have 1 online manual for this item!
Question posted by decorene1 on February 13th, 2014
Turbo Handbrush Problems
I can't get the turbo handbrush to work on my hoover windtunnel vaccuum cleaner. Also, the suction on the hose is very weak. the model of handbrush It came with the vaccuum whick is a few years old.
Current Answers
Related Hoover FH50240 Manual Pages
Manual - Page 1
... USE ONLY. Questions or concerns? For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST. página E1
®
Deep Cleaner
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
Manual - Page 2
... of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...6
Cleaner Description 6 The Tanks...7 How to Clean...9 Tools...12 Maintenance...15 Nozzle...15 Brushes...15 Storage...16 Lubrication...16 Troubleshooting...17 Helpful Reminders 17 Service...18 Cleaning Products...19 Warranty...20
If you for warranty service of your product online at hoover.com. Model
MFG...
Manual - Page 3
.... To avoid personal injury or damage, and to prevent the cleaner from product, and do not allow to be
followed, including ...fine wood sandings, or use in .
Close supervision is not working as cigarettes, matches, or hot ashes. • Do not ... when cleaning on carpet moistened by cleaning process. • Use only HOOVER® cleaning products intended for use cord as a handle, close a...
Manual - Page 4
...circuit and has a grounding plug that is properly installed and grounded in doubt as to clean out hose as a properly grounded outlet box cover (Fig. 2). A temporary adapter (D) may cause damage. ... known to the State of a temporary adapter is well ventilated when using
detergents and other cleaners with this plug to reduce the risk of the equipment-grounding conductor can cause damage. &#...
Manual - Page 5
... for assembly. Store hose handle in place. 1. Solution Bottle
b
C
Carpet Upholstery
Cleaner
bare floor
E cleaner
PreCleaner
D
I . Clean Water Tank/ Carry
Handle
H. Accessories not included with bolt screwed in holster.
1.6
Cord storaGe
1.7 Wrap cord around back of tank to cord.
1.7
5 Actual model may be purchased separately by visiting hoover.com. Make sure...
Manual - Page 6
...Handle 11. SpinScrub® Mode Selector* 13. Edge Cleaners* 14. Nozzle 15. Hose 17. Non-Marring Wheels* 20. Accessories not included with your local HOOVER® service center. Store tools
(Tools may vary from images shown. 6 Upholstery Nozzle* B. Hard Floor
Squeegee Tool*
1.8
B
*Available on select models only. Detergent Container 10.
A
C
2. Wash/Rinse Setting...
Manual - Page 7
...and pull forward.
2.9
2.9 Fill tank (E) with Hoover® MaxExtractTM Carpet & Upholstery Detergent or any other hand.
2.8
2.10
F
G
2.11
WARNING Use only HOOVER® cleaning products intended for cleaning carpets GENTLE SCRUB..., put handle in upright and locked position, tilt cleaner back on most dirt and stains. continued >>
7 Actual model may vary from room to rinse the
carpet or ...
Manual - Page 8
...cleaner off will engage, suction will
B
A
damage your (A) detergent container, (B) Clean Water Tank or (C) Dirty Water
Tank. Certain oxygenated-type cleaners...16
C D
2.18 F CAUTION !
C
Use only HOOVER® Oxy detergent for 15 minutes. The Dirty Water ...model may be emptied (see Automatic Shut-Off section). In case of contact with eyes, flush with water. Do not carry cleaner...
Manual - Page 9
...Vacuum thoroughly - In a small, hidden area, gently rub the surface with HOOVER® Spot & Stain Spray Cleaner*- If broken or dislodged, take to protect wood or metal surfaces from staining carpet. If your model.
9 Actual model..., turn cleaner off the cleaner suction (suction will become noticeably higher in place. For carpet, use the carpet cleaner as a dry vacuum cleaner.
Manual - Page 10
...pull cleaner back toward you without ). Keep nozzle flat on select models only...suction (see "Automatic shut-off", Fig. 2.19). Continue to help prevent streaking.
Step 2
Release trigger and slowly push cleaner forward over the same area a minimum of the room farthest from images shown. 10 Continue using dry strokes until little water is a loss in faster drying of carpet, end with Hoover...
Manual - Page 11
... vary from moving parts,
unplug cleaner.
To prevent damage to squeeze solution trigger.
Do not use the carpet cleaner to exceed 1/8" in upright position, tilt cleaner back so 2. Repeat steps 7 & 8.
Fill clean water tank according to use , press Clean Surge® button while squeezing solution trigger. For models with HOOVER® Hard Floor
that handle...
Manual - Page 12
...carpet, place towels or white cloths on select models only)
B.
Empty tanks, rinse with clean water and let air dry.
TOOLS
A. Rinse it in suction (see "Automatic shut-off", Fig. 2....and there is completely dry. Unplug cleaner from electrical outlet and remove squeegee from the floor.
10. tools
4.1
A
B
SpinScrub® hand tool
(Available on select models only)
4.2
4.2 To remove the...
Manual - Page 13
...model may result in faster drying of injury from images shown. How to WASH.
Place handle in upright position and remove hose from electrical outlet.
Turn cleaner ON.
Position tool against riser.
Not to hose...cleaner before using the tool again. Dry hands and plug cleaner into carpet pile. End with HOOVER...handle is best to the hose in suction (see "Automatic Shut-Off...
Manual - Page 14
...with HOOVER® detergent according to instructions for additional information.
Dry hands and plug cleaner ... will not rotate while handle is in suction (see "Automatic Shut-Off", Fig.... Setting switch to end of hose.
Vacuum up the solution with the ...cleaner ON.
4.6 Gently press the tool onto the fabric. overlap each pass. See "After Cleaning" section (Page. 12) for Fig. 2.9. Actual model...
Manual - Page 15
...rear edge of brush assembly with the hole (D).
To reduce the risk of your cleaner will ensure continued cleaning effectiveness. The brushes can be done by an authorized service ...representative. Make sure that handle rests on nozzle to snap into place.
15 Actual model may vary from images shown. Slide tabs into hole. The nozzle must be cleaned under running ...
Manual - Page 16
... inside door (A) and plunger (B). Remove dirt and debris from lint screens (C).
5.5
A
B
Storage
Before storing: • Empty Clean Water Tank and let air dry. Replace on cleaner. • Empty Dirty Water Tank, rinse tank and lid
thoroughly with clean water and let air dry. • Verify door lid and plunger on a carpeted...
Manual - Page 17
... If hose does not spray, prime the pump by an authorized service representative.
! 6. Low suction.
Clean water won 't rotate during use. Blockage In tool on select models only....PROBLEM
Cleaner won't run. Clean Water Tank or detergent container empty.
3.
Pump is empty.
1. Check fuse or breaker in place.
2. Clean the door and verify it usually can be done by lowering the hose...
Manual - Page 18
...; Warranty Service Dealer (Depot) by the complete model number when requesting information or ordering parts. (Label located on lower handle of the following.
• Use HOOVER® brand detergents;
If you . • For an automated referral of the carpet.
• 6.1 Fill tank (A) with hot (under "Vacuum Cleaners" or "Household". • Visit our website at...
Manual - Page 19
... of fire and electric shock due to internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use Hoover® brand
detergents, wipes, and spot cleaners available at
Hoover.com and retailers nationwide.
3 When cleaning a hard surface, the optional Hoover® hard surface attachment below must be used: 6 Brush...
Manual - Page 20
... CLAIM If this Warranty. This warranty does not cover products purchased from date of Canada. This warranty does not apply to a Hoover® Sales and Service Center for a full two years from a party that vary from state to state.
20 This Warranty shall be assigned. Some states do not allow the exclusion...
Similar Questions
Vacuum Turning Off During Use
my vacuum is around 10 years old. It will run for 5-10 minutes, then shuts off by itself. You have t...
my vacuum is around 10 years old. It will run for 5-10 minutes, then shuts off by itself. You have t...
(Posted by sydneybear2000 4 years ago)
Hoover Fh50240 Clean Water Tank Starts Draining As Soon As Turned On
As soon as you push the red power button the clean water and detergent tanks start dispensing water ...
As soon as you push the red power button the clean water and detergent tanks start dispensing water ...
(Posted by chasefamily88 10 years ago)
My Hoover Turbo Power 3100 Front Wheel Panel
My hoover turbo power 3100 front wheel panel came off, can I replace it?
My hoover turbo power 3100 front wheel panel came off, can I replace it?
(Posted by harmani02 10 years ago)
My Vacuum Will Not Suck Anything Up. Belt Is Fine.
My vacuum will not suck anything up anymore. It is less than a year old. Any ideas? Belt is fine.
My vacuum will not suck anything up anymore. It is less than a year old. Any ideas? Belt is fine.
(Posted by bllandscapedesign 10 years ago)
Problems
The brushes are not moving and does not seem to be pushing out water...
The brushes are not moving and does not seem to be pushing out water...
(Posted by tnorkida 11 years ago)