Hoover FH40160 Support Question
Hoover FH40160 Support Question
Find answers below for this question about Hoover FH40160.Need a Hoover FH40160 manual? We have 1 online manual for this item!
Question posted by theoret69 on April 27th, 2023
Stopped Working Fh 40160
Last time I tried using it, it started for only a fraction of second... then dead. It has not started since. Is there a fuse? Help
Current Answers
Answer #1: Posted by SonuKumar on April 27th, 2023 11:06 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,633,680
Member since:
May 9th, 2021 Points: 16,633,680
It's possible that the Hoover FH40160 has a fuse that may have blown, causing it to not turn on. Here are some steps you can try to troubleshoot the issue:
- Check the Power Cord: Ensure that the power cord is properly connected to the vacuum and the power outlet. If it is not securely plugged in, the vacuum may not turn on.
- Check the Outlet: Try plugging another appliance into the outlet to ensure that it is working properly. If the outlet is not providing power, the vacuum will not turn on.
- Check the Fuse: Locate the fuse on the vacuum and check to see if it has blown. If it has, replace it with a new fuse of the same type and rating.
- Check the Motor: If the fuse is not blown and the vacuum still does not turn on, the motor may be damaged. In this case, you may need to take the vacuum to a repair shop or contact Hoover customer support for assistance.
I hope this helps you troubleshoot the issue with your Hoover FH40160 vacuum!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Hoover FH40160 Manual Pages
Product Manual - Page 1
... cleaner. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. Questions or concerns? All rights reserved. #961151072 ID106402-R0 IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
IF USED ...COMMERCIALLY WARRANTY IS VOID.
©2013 Techtronic Floor Care Technology Limited. OWNER'S
Manual
Operating and Servicing Instructions
www.hoover.com
FH40150 Series
FH40160 ...
Product Manual - Page 2
...174; authorized dealer locations (U.S. Please do not return this Hard Floor Cleaner.
CODE
Hint: Attach your product online at hoover.com for more ...cleaner)
Contents
Important Safeguards 3 Carton Contents...5 How To Assemble...6 General Operation...7
Clean Water/Solution Tank 7 How To Use...8
On-Off Switch...8 Handle Release Pedal 8 Transporting...8 Carry Handle...8 How To Use...
Product Manual - Page 3
...working as it should always be used near children. To avoid injury or damage, keep free of body away from product, and do not allow to be
followed, including the following: READ ALL INSTRUCTIONS BEFORE USING...before operating. • Operate cleaner only at bottom of this manual. Use only manufacturer's recommended attachments and products. • Do not use with this machine. (See
...
Product Manual - Page 4
... well ventilated when using
detergents and other cleaners with all local codes and ordinances. Do not expose machine to freezing
temperatures. • Do not use on a nominal 120-volt circuit and has a grounding plug that is equipped with the appliance - This appliance is properly installed and grounded in reducing drying time, be used to connect...
Product Manual - Page 6
... Brush
(assembled in unit)
D. Make sure all parts from carton and identify each item shown. Upper Handle
C.
D E
E F
2. FH40150 SERIES
Carton contents for assembly. Hard Floor Cleaner Base
(Floormate Deluxe
A
FH40160 Series)
B. Hard Floor Cleaning Detergent
D B
Remove all parts are located before disposing of packing materials. Hard Floor...
Product Manual - Page 7
...3.5 3.7
3.6
C
7
To reduce the risk of these conditions could lead to damaged flooring when using cleaner on non-carpeted floor surfaces such as a measuring cap. 3.5 For FloorMate FH40150 Series, fill measuring ... wood floors if any of personal injury, unplug before using, as these conditions exist. For FloorMate Deluxe FH40160 Series, fill measuring cap to be locked in upright,...
Product Manual - Page 8
.... 4. Push
A
switch again to the cord.
5.
Wrap the cord clockwise around the two cord handle hooks (C).
Do not use cleaner without tank in upright position, tilt cleaner back on rear wheels and push forward. How to empty
Dirty Water Tank (left side when facing unit) When to unlock the top portion of ...
Product Manual - Page 9
...How to clean
Recommended cleaning sequence
NOTE: Your HOOVER® FloorMate™ Hard Floor Cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be...the locked position.
5.7 Tilt tank straight into position until latch snaps in your cleaner. If using cleaner on sealed wood floors, inspect floor surface for debris before reassembly.
5.3 Pull...
Product Manual - Page 10
... areas are completely dry. Continue to move cleaner over the area to pick up the dirty solution.
6.12 Switch to dry mode to help prevent streaking.
Squeeze trigger to release solution as...of the floor and also stops the spinning of the product after use and may also be cleaned. Water will pick up flammable or combustible liquids or chemicals.
10
The cleaner's suction will drip from...
Product Manual - Page 11
... it is not working as it should be washed with hole (D) on nozzle release latch (A) upward.
7.2 Remove nozzle by an authorized service representative. Do not use a solvent based detergent...before servicing. CAUTION ! The addition of the floor. CAUTION !
Do not use cleaner without brushes in place. Do not use .
7.1
7.2
A
7.4
7.5
7.6 Remove both tanks to upright position....
Product Manual - Page 12
... pressing on the nozzle squeegee. • Do not store cleaner on absorbent material (such as a towel) to soak up drips.
12 To avoid damage to wood and laminate flooring and to avoid potential slip hazard, after use A) do not leave the product on wood and laminate surfaces and remove to freezing tempuratures...
Product Manual - Page 13
... cause is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it usually can be done by using the checklist below.... tank. Cleaner solution won 't pick up
1. In Dry Mode.
1. WARNING ! Check fuse or breaker in place.
1. Water puddling behind cleaner
1. Check fuse or breaker in home. (1) Push ON/OFF switch to turn cleaner ON. ...
Product Manual - Page 14
...
WARNING: To reduce the risk of fire and electric shock due to internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use HooverÆ brand
detergents, wipes, and spot cleaners available at
Hoover.com and retailers nationwide.
3 When cleaning a hard surface, the optional Hoover®...
Product Manual - Page 15
...; Follow the service center link to Hoover®, Inc., Company in delay. Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Customers) or hoover.ca (Canadian customers). If you . • For an automated referral of the vacuum...
Product Manual - Page 16
...in which the product was initially purchased and resales of Hoover®, owner's acts or omissions, use outside a U.S. This warranty does not cover products purchased from state to you specific rights;
... PURPOSE, ARE DISCLAIMED. WHAT THIS WARRANTY DOES NOT COVER This Warranty does not cover: use and in the United States, U.S. The Warranty Period will not be extended by the original...
Similar Questions
Hover Floormate Fh40160 Brushes Won't Spin.
Hover floormate FH40160 brushes won't spin. Just got it yesterday and was working, today brushes won...
Hover floormate FH40160 brushes won't spin. Just got it yesterday and was working, today brushes won...
(Posted by Timjdraper 3 years ago)
Anyone Have The Inline Fuse Part Number For The Hoover Fh40160?
Anyone have the inline fuse part number for the Hoover FH40160. There was a question earlier about t...
Anyone have the inline fuse part number for the Hoover FH40160. There was a question earlier about t...
(Posted by nettan 3 years ago)
My Steamer Stopped Working
it stopped working in the middle of cleaning is there any way to get it working again
it stopped working in the middle of cleaning is there any way to get it working again
(Posted by lvannorman200921371 5 years ago)
Floormate Fh40160 Won't Turn On
My Floormate FH40160 YJ35 won't turn on. It is plugged in to a working electrical outlet but it does...
My Floormate FH40160 YJ35 won't turn on. It is plugged in to a working electrical outlet but it does...
(Posted by CECILIALB15 7 years ago)
Rotating Brushes Stop Working
why did my rotating brushes stop working?
why did my rotating brushes stop working?
(Posted by steelers1gal 11 years ago)