Home » Hoover » Vacuums » Hoover FH40030

Hoover FH40030 Support Question

Find answers below for this question about Hoover FH40030.
Need a Hoover FH40030 manual? We have 1 online manual for this item!

Hoover Overview Questions Manuals Reviews Videos Research

Question posted by vickie6116 on June 5th, 2012

Handle

How to remove handle for repacking?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Hoover FH40030 Manual Pages

Manual - Page 2

... enter the complete model and Manufacturing Code in China Manufacturing code (Label located under cleaner) Contents Important Safeguards 3 Cleaner Assembly...5 Carton Contents 5 Attach Handle...5 Install Brushes and Nozzle 5 Unfold Handle...6 How to the store. 2 Model 1-800-944-9200 MFG. Follow the authorized dealer locator link to find the Hoover® authorized dealer...

Manual - Page 3

...run appliance over floor electrical outlets. • Do not use flammable or combustible materials such as a handle, close door on stairs. Do not run unattended at least a 16 gauge 3-wire cord which has... small spills. To unplug, grasp the plug, not the cord. • Never handle plug or appliance with any opening blocked; IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS When using...

Manual - Page 5

... (A) up to the upright position until post fits easily into place. Make sure all parts from squeegee area on upper handle (C) with slot in place. 5 1.3 C D B 1.5 1.7 Tool Bag Remove all parts are out. A 1.6 To install nozzle, make sure latches (C) are located before disposing of nozzle. 1.6 CD E 1.7 While holding nozzle in place, slide latches...

Manual - Page 6

...6 Cord Hooks: top hook rotates for 1 3 drying and vacuuming 5. Push switch again to operating position. Clean Water Solution Tank Release 4 5 4 20 6 8. Dirty Water Tank Release 7 9. Handle Release Pedal ON/OFF switch 2.2 Push switch (A) once to storage position. 1.9 A B 2. Unfold handle 1.8 Raise upper handle (A) to upright position until it locks in place...

Manual - Page 7

... raised off . 2.7 For dry debris pickup, turn the dial to room, put handle in upright position, tilt cleaner back on rear wheels and push forward. 2.5 The cleaner may also be lifted using... the carrying handle (A) on the front of the cleaner. 2.4 2.5 A Mode selector dial 2.6 The Mode selector dial (A)...

Manual - Page 8

...Cap must be dispersed onto the surface being cleaned. Carry tank to a sink. 2.9 Rotate tank cap counter-clockwise and lift up to remove cap (A). 2.10 Turn cap (B) upside down to prevent leaking. 2.14 Slide tank straight into tank (C). How to fill line (D) ... that contain solvent based ingredients. 2.9 A 2.11 C B D 2.13 F 8 Fill tank to Fill Place carpet cleaner handle in place.

Manual - Page 9

... lid (H). How to Clean Turn cleaner off and disconnect from electrical outlet. 2.17 Remove Dirty Water Tank and lid (Figs. 2.15 & 2.16). Allow filter to be emptied after dry vacuuming and before wet operation. Dry or loose debris will change. The filter screen may also be cleaned by tapping the filter or...

Manual - Page 10

...® FloorMate™ SpinScrub® Cleaner to: • VACUUM: Vacuum to wet clean sealed wood floors if any type of these ...off . Do not use FloorMate™ SpinScrub® cleaner to remove loose dirt, hair and debris. • WASH: Clean the ... How to clean wood floors that no water remains on handle release pedal and lower handle to the DRY position. Turn cleaner off " section)....

Manual - Page 11

... to Connect Hose 4.2 Open hose door (A) on stubborn grout stains B Attach hose and tool 4.2 ! Remove hose from moving parts, unplug cleaner. Snap wand over the area to pick up flammable or combustible liquids or...you and pull wand away from you do not extend the wand past this line. To remove wand: Push forward and up on non-carpeted floors. CAUTION ! Insert hose connector (B) ...

Manual - Page 12

... Tools may be in the upright position in the same manner. A IMPORTANT The handle must be necessary to remove air from the system (prime the pump) so the clean solution will flow to... the cleaner ON. Snap tool over same area to get cleaning solution through the hose. B To remove tool: Push forward and up dirty solution without putting down more solution. 4.6 A 12 After attaching the...

Manual - Page 13

... position for easy cleaning. ! 5. Any other servicing should be done by pulling straight out. 5.3 Rinse nozzle under running water. Align middle section (E) of nozzle with removable brushes for easier assembly of injury from squeegee (C) and wipe with these home maintenance tasks as proper use and care of your cleaner will ensure...

Manual - Page 14

...EF G E StorAGE Before storing cleaner: Turn cleaner OFF and disconnect from moving parts, unplug cleaner before servicing. Remove tanks to upright position. How to Replace 5.8 To replace brushes, align post (C) on brush block with hole...place. 5.9 Return cleaner to prevent leaking. Do not add lubricant to Remove Place handle in place. How to motor bearings. 14 Set aside. 5.6 Pull the...

Manual - Page 15

... properly. 3. Make sure Filter and Filter lid are properly positioned. 5. Nozzle not in home. Filter or Filter lid not in place. 5. Use recommended detergents to remove debris. 15 Empty Dirty Water Tank. 1. To reduce risk of personal injury - Dirty Water Tank full and the automatic shut-off engaged. 3. Filter or Filter...

Manual - Page 16

...: 1-800-944-9200, Mon-Fri 8am-7pm EST. Follow the service center link to Hoover®, Inc., Company in delay. Do not send your vacuum by : • Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. 7. If you . • For an automated referral of the...