Hoover FH40010 Support Question
Hoover FH40010 Support Question
Find answers below for this question about Hoover FH40010.Need a Hoover FH40010 manual? We have 1 online manual for this item!
Question posted by stewartjackjs on January 27th, 2014
Operation Modes
Is the vacuum on the machine supposed to shut off when put into wash mode?
Current Answers
Related Hoover FH40010 Manual Pages
Manual - Page 1
All rights reserved. #960009623 ID100507-R0 página E1
FloorMate™ SpinScrub® Hard Floor Cleaner
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE... WARRANTY IS VOID.
©2009 Techtronic Floor Care Technology Limited.
Questions or concerns? Owner's Manual
Operating and Servicing Instructions
Español -
Manual - Page 2
......5
Carton Contents 5 Attach Handle...5 Install Brushes and Nozzle 5 Unfold Handle...6 How to Fold Handle 6 How To Use...6 Cleaner Description 6 ON/OFF Switch...6 Handle Release Pedal 6 Transporting...7 Mode Selector Dial 7 The Tanks ...8 Filters...9 How To Clean...10 Recommended Cleaning Sequence 10 Cleaning Floors 10 Picking Up Spills 10 Maintenance...11 Nozzle...11 Brushes...
Manual - Page 3
... INSTRUCTIONS SAVE THESE INSTRUCTIONS
When using recommended chemicals with this machine, be present. • Avoid picking up chlorine bleach, drain cleaner, gasoline or any opening blocked; Do not run unattended ...• Always disconnect cord from openings and
moving parts. • Do not pick up operation. • Close supervision is used as a handle, close door on cord or pull ...
Manual - Page 4
... a Hoover Sales and Service Center or Authorized Hoover® Warranty Service Dealer. • Use cleaner only for its intended use as it must be connected to a permanent ground (G) such as... electric current to reduce the risk of wax with extractor. • Follow manufacturer's instructions for machine applica- The green colored rigid ear, lug, or the like the plug (A) illustrated in the...
Manual - Page 5
...
1.3 Align control rod (B) on upper handle (C) with hole (B) on the
floor. Tilt cleaner back so that it snap in place.
1.2
A
Install brushes and nozzle
1.4 To install brushes...1.6
DE C
1.7 While holding nozzle in place, slide latches inward to snap into place. Hard floor cleaner B. Hard Floor Cleaning Detergent
Remove all the way down until post fits easily into hole.
1.5 Press brush...
Manual - Page 6
... Wheels
cleaner.
16. Handle Release Pedal
ON/OFF switch
2.2 Push switch (A) once to turn cleaner ON. Mode Selector Dial: turns brushes
3
ON for wet washing and ...operating position. Clean Water Solution Tank
Release
6
8. Push switch again to turn cleaner OFF.
2.2
A
Handle release pedal
2.3 Step on bottom of
15. Dirty Water Tank Release
7
9. Bumper
Operate cleaner...
Manual - Page 7
....
2.6
2.7
A
VACUWUAMSDHRY
7 Refer to "How to the WASH position.
To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward.
2.5 The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner.
2.4
2.5
A
Mode selector dial
2.6 The Mode selector dial (A) turns the brushes on...
Manual - Page 8
...using , as vinyl, linoleum, marble, laminate wood, polyurethane sealed wood or other wood floors that is to Fill
Place carpet cleaner handle in place.
2.8
2.10
2.12
E
2.14
! The Clean Water Solution Tank holds detergent and water that can ...and pull tank straight out. The Tanks: Clean Water Solution Tank
(upper tank) Turn cleaner off and disconnect from electrical outlet.
CAUTION !
Manual - Page 9
...button (G) and pull tank straight out.
2.16 Remove tank lid (H). When the shut-off activates, the cleaner will not pick up debris and the sound of tank behind ledge (D) and push ...additional cleaning.
Reposition pleated filter in place. It may also be emptied after dry vacuuming and before wet operation. Allow filter to air dry between uses. Remove debris from electrical outlet.
Replace lid...
Manual - Page 10
... Solution Tank with brushes turned ON, turn the dial to WASH position. Turn Mode selector dial to the VACUUM position.
To greatly enhance drying of floor being cleaned, and water (see Figs. 2.8 through 2.14). Simply move cleaner forward and backward over the area to the WASH position. To wet clean with either Floor to be...
Manual - Page 11
... representative. Picking up spills
Your cleaner may also be done by pulling straight out.
4.3 Rinse nozzle under running water. Turn Mode selector dial to exceed 1/4 inch in depth) on cleaner.
4.5 While holding nozzle in ...-carpeted floors. CAUTION ! Continue to move cleaner over the area to pick up small liquid spills (1 quart or less, never to the WASH position and release the trigger.
Manual - Page 12
...CAUTION ! Set aside.
4.6 Pull the two nozzle release buttons (A) out. The brushes can be washed with a mild detergent and rinsed.
How to lower handle for the life of lubricant could cause ... handle release button to Remove
Place handle in place.
Remove nozzle.
Tilt cleaner back so handle rests on cleaner.
4.10 While holding nozzle in place, slide latches inward to lock in...
Manual - Page 13
... the automatic shut-off engaged.
2. Empty the Dirty Water Tank.
3. Tanks not in place.
5. Filter or Filter lid not in place. 4.
Water puddling behind cleaner
1.
Dirty ...4. Make sure Filter and Filter lid are properly positioned.
5. 5. PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Cleaner won 't rotate
1. Blown fuse or tripped breaker.
1. Clean Washable Filter.
2. Nozzle not...
Manual - Page 14
... call 1-800-944-9200. This will only result in Glenwillow for service. Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Always identify your vacuum to Hoover®, Inc., Company in delay. Follow the service center link to the store...
Manual - Page 15
... internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use Hoover® brand
detergents, wipes, and spot cleaners available at
Hoover.com and retailers nationwide.
15 7. For optimal performance use with the appliance as noted below.
®
Hoover Cleaning Product Guide
Hoover
Hoover...
Manual - Page 16
... warranty does not cover products purchased from a party that vary from date of Hoover®, owner's acts or omissions, use of the product in a commercial operation (such as warranted, take or send the product to either a Hoover® Sales and Service Center or Hoover® Authorized Warranty Service Dealer along with...
Similar Questions
Mode Selector Use
Is the FloorMate FH40010 supposed to vacuum as you try to scrub? Mode selector on WASH.
Is the FloorMate FH40010 supposed to vacuum as you try to scrub? Mode selector on WASH.
(Posted by jorgecarreras 10 years ago)
Hoover Floormate Fh40010 Making Noise.
My Hoover Floormate FH40010 is making a loud grinding noise. What could that be? Is it something I c...
My Hoover Floormate FH40010 is making a loud grinding noise. What could that be? Is it something I c...
(Posted by Traceywolkin 10 years ago)
Hoover Carpet Steam Cleaner Movel 7412-900 Has Stopped Extracting Water.
It puts out water and detergent, but doesn't suck up the water.
It puts out water and detergent, but doesn't suck up the water.
(Posted by rkbk 11 years ago)
Which Is The Newest Model? Model Fh40010 Or Model Fh40010b
which is the newest model? model FH40010 or model FH40010B
which is the newest model? model FH40010 or model FH40010B
(Posted by cxwillia87 11 years ago)