Hoover F7458-900 Support Question
Hoover F7458-900 Support Question
Find answers below for this question about Hoover F7458-900 - Widepath All Terrain Floor Cleaner.Need a Hoover F7458-900 manual? We have 1 online manual for this item!
Question posted by markvansickle on November 4th, 2012
Brushes Do Not Spin
The brushes are not spinning. What is the case of this problem, and how can I fix it?
Current Answers
Related Hoover F7458-900 Manual Pages
Product Manual - Page 2
... the complete model and Manufacturing Code in China
Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...7
Cleaner Description 7 The Tanks...8 How to Clean...10 Tools...13 Maintenance...17 Nozzle...17 Brushes...17 Valve...18 Storage...18 Lubrication...18 Troubleshooting...19 Helpful Reminders 19 Service...20 Cleaning...
Product Manual - Page 3
... the SpinScrub® hand tool. • Always disconnect cord from electrical outlet before servicing the carpet cleaner. • Do not unplug by Hoover®; Do not run unattended at least a 16 gauge... type plug and a 3-pole receptacle that is used as a toy or to run appliance over floor electrical outlets. • Do not use with this Appliance. (See Cleaning Products section of this ...
Product Manual - Page 4
...provided with the carpet cleaner. NOTE: In Canada, the use of electric shock. USING THIS MACHINE ON HARD FLOORS WITHOUT PROPER ATTACHMENT MAY SCRATCH OR DAMAGE YOUR FLOOR. The plug must ... plug (A) illustrated in . • DO NOT USE THIS EXTRACTOR ON HARD FLOORS UNLESS YOU HAVE THE PROPER
HARD FLOOR ATTACHMENT. if it must be installed by a qualified electrician. • Avoid...
Product Manual - Page 5
...A
A. SpinScrub® Brush Assembly
Remove all parts are located before disposing of packing materials. Make sure all parts from images shown. Cleaner B. Tighten with hose) D.
SpinScrub® Hand Tool*
*Available on select models only. NOTE: Phillips screwdriver needed for assembly. Cleaner ASSEMBLY
Carton contents
1.1
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner...
Product Manual - Page 6
... and solution tube (E and inset).
1.12
1.13
1.14
D
E
E
D
Actual model may vary from images shown. 6
1.11
C
B
Store tools
1.15 Store Tools on back side of cleaner with other hand.
1.8 Push up on hook (C). Notch (B) rests on handle to latch it is removable for storage on...
Product Manual - Page 7
...
22
16. Handle Release Pedal
!
Clean Water Tank Handle
8. Cord Hook: rotates for household use.
22. DAMAGE YOUR FLOOR. Detergent Container
9
10. Hose Connection Port
16
24
23
15
18.
To turn cleaner ON, push switch down. Dirty Water Tank Handle
8
11. Solution Tube Connection Port
11
15. Hose/Tool Caddy* 21...
Product Manual - Page 8
...
Use only HOOVER® SteamVac® detergents.
They are specially formulated for picking up spills or cleaning carpets and hard floors when brushing is permanently attached to Fill
Unplug cleaner from images shown. 8 brushes OFF for use with the water. Non-Hoover® cleaning solutions may vary from electrical outlet.
POWER SCRUB -
SPILL PICK...
Product Manual - Page 9
...Empty tank and reposition lid.
Check tank to make sure it onto cleaner. G
How to Empty
Turn cleaner off tank.
In case of tank) inward to lock tank in damage to the unit. ...Tank holds the dirty solution that the Dirty Water Tank lid is properly secured before putting cleaner in upright position.
Failure to secure properly may result in place.
9
Actual model may ...
Product Manual - Page 10
... your upholstery does not have a code, seek professional assistance. When cleaning entire floor, move furniture out of the Dirty Water Tank
lid (B). Automatic shut off
When the Dirty Water Tank (lower tank) is marked with the dampened cloth. The cleaner will prevent wood finishes
from images shown. 10 Pin up dirty solution...
Product Manual - Page 11
...
3.2
Rinse ON AUWTAOSRIHNSE OFF
Fill Clean Water Tank according to squeeze trigger and slowly pull cleaner back toward you (second wet stroke). It is a loss in faster drying of the ..."Before You Begin Cleaning" instructions above .
Then slowly pull cleaner back toward you without ).
In this setting, rinsing will be done on floor for Figs. 2.9.
Dry hands and plug cord into a ...
Product Manual - Page 12
...When brushes seem to SPILL PICK-UP in front of the carpet. If the spill remains, place either the stair/ upholstery nozzle or floor nozzle with suction only.
Do not use the SteamVac® cleaner to... surface until it . If it is dry, place plastic or aluminum foil under legs of cleaner. Although no
cleaning solution can completely remove all spots, they can be treated by following the...
Product Manual - Page 13
...from solution connection port.
SpinScrub® Hand Tool (Available on select models only) has rotating brushes for converting to Remove
4.2 Squeeze latches (C) on select models only)
B.
CAUTION ! tools
...top and bottom of tool storage area. For some spots may vary from moving parts, unplug cleaner.
4.1
A
How to snap free if it is designed with same-sized slots in place...
Product Manual - Page 14
... solution tube by sliding it onto connector until the tab (G) locks it securely. Disconnect hose and solution tube from moving parts, unplug cleaner.
CAUTION !
Place handle in sink and raising nozzle above your thumb, push forward and up for storage or placed back on a coat hanger for several ...
Product Manual - Page 15
...(dry stroke). Overlap strokes by holding the tool (A) or (B) about one inch above . Agitator brushes will not rotate while handle is a loss in Figs. 4.1 and 4.2. Fill clean water tank ...wet stroke).
Fill detergent container with dry strokes. WARNING ! Dry hands and plug cleaner into carpet pile. Turn cleaner ON.
4.9 Pre-spray the carpeted stair by 1/2 inch to 2.11.
Empty Dirty...
Product Manual - Page 16
...rotate while handle is not available during tool use hard floor cleaning solution when cleaning upholstery. Press the trigger and ... may be necessary to check the cleaning code on your cleaner only on upholstery marked "W" or "W/S". Fill detergent container ... in upright position. Attach tool to 2.11. Agitator brushes will only dispense water mixed with HOOVER® detergent according...
Product Manual - Page 17
... rear edge of nozzle. Press down on the floor.
5.3 Grab brush assembly and pull firmly. Replace Dirty Water Tank (Fig. 2.16). The nozzle must be done by an authorized service representative.
Make sure that handle rests on nozzle with holes (B) in cleaner housing. Turn brushes slightly until handle rests on nozzle to snap into...
Product Manual - Page 18
... opening.
Therefore, do not add lubricant to Unclog
Remove Clean Water Tank.
5.5-5.6 Turn valve cap (A) counter clockwise and remove.
Allow brushes and underside of lubricant could cause damage.
Replace on cleaner. • Empty Dirty Water Tank, rinse tank and lid
thoroughly with bearings that contain sufficient lubrication for at least 15 minutes...
Product Manual - Page 19
... and empty Dirty Water Tank. Clean water won 't rotate during floor cleaning.
1. Clean Water Tank not firmly in home. 3. Clean... SOLUTION
1. Remove tool and clear blockage.
3. Detergent won't dispense
Brushes/brush indicator won 't dispense.
2. Remove and clean valve cap (see ...
1. Do not put any of unit.
1. PROBLEM
POSSIBLE CAUSE
Cleaner won't run. 1. Dirty Water Tank full/ ...
Product Manual - Page 20
... on the bottom of authorized service outlet locations call 1-800-944-9200; Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. If you . • For an automated referral of the vacuum.) PLEASE DO NOT RETURN THIS PRODUCT...
Product Manual - Page 21
...;
Hoover® MaxExtractTM Dual V® All Terrain
Hoover
Platinum
Collection®
Hoover® FloorMate®
1 Allergens: pollen, pet dander, dirt, and dust.
2 When cleaning a hard surface, the Hoover® hard surface attachment below must be used (optional if not included): 5 Brush Hoover® part # 48417008. For...
Similar Questions
I Need A Beater Bar End Cap For Hoover Floor Cleaner Model Fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
(Posted by scottgrippa 1 year ago)
Brushes Won't Turn On Hoover Max Extract All Terrain Carpet Cleaner
(Posted by whh5an 9 years ago)
Hoover Maxextract All-terrain Carpet Cleaner Detergent Won't Come Out
(Posted by Hennnewma 9 years ago)
Hoover Steam Vac #6207-900-how Do I Change The Belt To The Brushes
how to change the belt that drives the brushes on hoover steam vac #6207-900
how to change the belt that drives the brushes on hoover steam vac #6207-900
(Posted by matflip93 12 years ago)
Brushes Won't Spin On Hoover Maxextract All Terrain Carpet Cleaner
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
(Posted by tsbequette 12 years ago)