Honeywell TH5320R Support Question
Honeywell TH5320R Support Question
Find answers below for this question about Honeywell TH5320R.Need a Honeywell TH5320R manual? We have 1 online manual for this item!
Question posted by Edoherty2558 on July 8th, 2021
It Says No Signal. I Changed Batteries
it says no signa
Current Answers
Answer #1: Posted by SonuKumar on July 8th, 2021 10:27 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,615,400
Member since:
May 9th, 2021 Points: 16,615,400
https://www.manualslib.com/products/Honeywell-Th5320-10494.html
Why Does My Honeywell thermostat say no signal?
Screen displays "No Signal" Thermostat has lost radio contact with the wireless network (usually because of a power outage). To restore power: Check circuit breaker and reset if necessary. Make sure power switch at heating & cooling system is on.
https://www.youtube.com/watch?v=4a1YCavMR4c
How do I troubleshoot my Honeywell thermostat?
First, head over to your electrical breaker box and turn off the power source to your thermostat. Next, turn the thermostat off and carefully remove the top cover of the unit. Look at the wiring and check if anything is loose, broken, or disconnected. Also, check to see if everything is clean.
Does Honeywell thermostat have a reset button?
Honeywell T5, T5+, and T6 Thermostats
These square Wi-Fi-enabled programmable thermostats can be reset to factory settings like this: Press and hold Menu. Scroll through the choices until Reset is displayed. Select Reset.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Honeywell TH5320R Manual Pages
Owner's Manual - Page 1
Operating Manual
FocusPRO® TH5320R Wireless Thermostat Termóstato inalámbrico Thermostat Sans Fil
Owner's Manual - Page 2
... HAZARD.
All rights reserved.
To prevent possible compressor damage, do not operate cooling system when outdoor temperature is below 50°F (10°C). Battery Holder Press down and pull to remove batteries. Need Help? Batteries should be replaced once a year (see page 11).
Registered Trademark. Patents pending. Copyright © 2008 Honeywell International Inc.
Owner's Manual - Page 3
...vea la página 15 • Français : voir la page 30
About your new thermostat Initial setup 2 Quick reference to controls ........3 Quick reference to display ..........4
Operation Fan settings (auto/on... outdoor climate 9 Find lost remote control 9 Compressor protection 10
Appendices Battery replacement 11 In case of difficulty 13 Limited warranty 14 Regulatory information 45
1
Owner's Manual - Page 4
About your new thermostat Your new wireless thermostat is choose the settings you prefer: 1 Select fan setting (Auto/On See page 5 2 Select system setting (Heat/Cool See page 6
2 All you have to do is pre-set for immediate use.
Owner's Manual - Page 5
Quick reference to controls
Digital display (see page 4)
Battery holder (see page 11)
Temperature buttons Press to adjust temperature
Function buttons Press to select the function displayed just above each button. (Functions change depending on the task.)
3
Owner's Manual - Page 6
Quick reference to display screen
Current inside temperature
Low battery warnings (see pages 11-12)
Indoor
75 °
Replace Battery
Aux Heat On
Fan Auto
System Heat
Heat Setting
75°
More
Temperature setting
Auxiliary heat (Only for heat pumps with auxiliary heat)
System status ...
Owner's Manual - Page 8
Compressor is locked out.
6
Press SYSTEM to select:
• Heat: Thermostat controls only the heating system.
• Cool: Thermostat controls only the cooling system.
• Off: All systems are off. • Auto: Thermostat automatically
selects heating or cooling depending on your heating/ cooling equipment. Select the system setting
Fan Auto
System Heat
More
Fan...
Owner's Manual - Page 9
... used in climates where both air conditioning and heating are often used on the same day. The thermostat will automatically adjust settings to Auto, the thermostat automatically selects heating or cooling depending on how your thermostat was installed. Auto Changeover (heat/cool)
Fan Auto
System Auto
More
Press until screen displays "Auto"
Note...
Owner's Manual - Page 10
... for more information.
8 Remote control
Temperature is responding to temperatures measured at Remote
Fan Auto
Cancel
More
The optional remote control can act as a mobile thermostat, to maintain a comfortable temperature as you move from room to room. When the system is measured at location of remote control
72
°
Remote has...
Owner's Manual - Page 13
... pull to be reset.
Note: If batteries are installed, the thermostat will automatically restore communication with the wireless network within t2 minutes, the time and day will not have to remove
Insert fresh AA alkaline batteries, then reinstall battery holder
Install fresh batteries when the REPLACE BATTERY warning begins flashing. After batteries are inserted within a few minutes...
Owner's Manual - Page 14
Remove the sensor from bracket
Remove cover and install 2 fresh AA lithium batteries
Replace outdoor sensor batteries when the REPLACE BATTERY OUTDOOR warning begins flashing on the thermostat. After batteries are depleted. The warning flashes about two months before the batteries are installed, the sensor will automatically restore communication with the wireless network within a few ...
Owner's Manual - Page 15
Screen displays Thermostat has lost radio contact with the wireless network (usually
"No Signal"
because of difficulty
Heating or
•
cooling system • does not respond
•
Check circuit ...furnace door is on. After power is closed securely. Make sure furnace door is restored, the thermostat will automatically restore wireless communication within a few minutes.
13
Owner's Manual - Page 16
... FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-YEAR DURATION OF THIS WARRANTY.
Up to 5-year limited warranty
Honeywell warrants this product, excluding battery, to be free from defects in the possession of a consumer. This warranty does not cover removal or reinstallation costs. Some states do not allow the...
Owner's Manual - Page 47
..., there is subject to operate the equipment. ence that to which the receiver is subject to radio communications. FCC Warning (Part 15.21) (USA only) Changes or modifications not expressly approved by one of the FCC Rules. Limites d'exposition Pour être conformes aux limites d'exposition aux radiofréquences é...
Similar Questions
Thermostat Will Not Connect
.I believe to the outside thermostat that hangs on the outside wall. It has new batteries; is there ...
.I believe to the outside thermostat that hangs on the outside wall. It has new batteries; is there ...
(Posted by aliceeschallier 3 years ago)
How To Change Batteries In Honeywell Thermostat Manual Th3110d1008
(Posted by bubbsim 10 years ago)
How To Change Battery In Honeywell Thermostat Manual Rth2310b
(Posted by colojw 10 years ago)
Screen On Touchscreen Thermostat Has Ee. Changed Battery And Flicked Circuit Bre
breaker but will not work. What to do? Model GH8320U1008
breaker but will not work. What to do? Model GH8320U1008
(Posted by ljones5706 10 years ago)
Magicstat Ct2400a1008 9528 Thermostat.changed Battery Now No Display.
Reversed polarity like manual says, still no display. It's HOT in AZ. Can I have an answer soon 4/30...
Reversed polarity like manual says, still no display. It's HOT in AZ. Can I have an answer soon 4/30...
(Posted by balaqua 11 years ago)