Honeywell TE831W-2 Support Question
Honeywell TE831W-2 Support Question
Find answers below for this question about Honeywell TE831W-2 - Complete Wireless Weather Station.Need a Honeywell TE831W-2 manual? We have 1 online manual for this item!
Question posted by scooter on December 22nd, 2010
Troubleshooting Te831w Weather Station
Last hour reading shows only dashes and there is no recording in other settings. I have changed the batteries (lithium) with no success. It has been raining for the last two days so I should have measurements. I've check the movement and there are no obstructions.
Current Answers
Related Honeywell TE831W-2 Manual Pages
User Manual - Page 1
HONEYWELL TE831W-2
COMPLETE WIRELESS WEATHER STATION
USER MANUAL TE831W-2
User Manual - Page 2
... Sensors TS33C
5
Rain Gauge TS906
6
Anemometer (wind sensor) TS805
8
Main Unit
10
Power
11
Buttons and Controls
12
Initial Set up
14
Connecting the Weather Station to a PC
14
Operation and Window Selection
15
Custom Weather Station Settings
16
LED Backlight Options
25
Time Alarm Settings
25
Memory Reset procedure
27
Maintenance
27
Troubleshooting
28
PRECAUTIONS
29...
User Manual - Page 3
..., barometric pressure, wind speed and direction, rainfall levels and more. Installation
The Honeywell Complete Wireless Weather Station operates at your immediate location. The remote weather sensors include (2) thermo-hygrometer (temperature and humidity) sensors, anemometer (wind sensor) and a rain gauge (rain sensor). All data measured by these remote sensors is required between the main unit...
User Manual - Page 4
... should be reduced or
interrupted • Avoid using rechargeable batteries. (Rechargeable batteries do not provide correct power levels). • ALWAYS install batteries in the remote sensors before the main unit. • Insert batteries matching the polarity in this Honeywell Complete Wireless Weather Station operate at 433MHz radio frequency. Ideally they face the main unit (receiver...
User Manual - Page 5
... channel from the battery compartment with a small Phillips screwdriver. • Set the channel 1 through 3. ...reading to the main unit via 433 MHz signal • 328 feet (100 meters) transmission range without interference • Three (3) transmission channels selection • Case can be wall mounted using lithium batteries at temperatures below freezing, the outdoor sensor batteries...
User Manual - Page 6
... operate on the rain gauge bucket C. • Set one sensor to Channel 1 and the second sensor to the main unit via 433 MHz signal • 100 feet (30 meters) transmission range without interference • Built-in place
6 IMPORTANT: When channel number is 4 feet (1.25meters) above the ground. Install 2 "AA" size batteries matching the...
User Manual - Page 10
... window if the signal was sent and received successfully)
Aligning This procedure must be mounted in the main unit's wind window - It should be performed after changing the batteries. FEATURES Time
• Precise time and date set via RF signals from US Atomic clock • 12 or 24 hour time format • Manual adjustment of time...
User Manual - Page 11
...weather records without PC connection • PC software (included) and USB port • Operating range from the wireless devices (such as cordless phones, radio headsets, baby listening devices) and electronic appliances.
11
When the main unit operates solely on the battery... compensation • 24 hour barometric pressure history chart • Multiple weather alerts including: Hi/Low...
User Manual - Page 14
... humidity readings, remote sensors readings, etc. When determining data transfer interval from the battery compartments)
2. The software works when main display unit is finished self-adjustment when the display shows the default settings for example (- - -) you will select 3 hours, then the graph trend will take at least once a week, otherwise your will need to connect your weather station...
User Manual - Page 15
... : C:/Program Files/WeatherCapture. Month/ Day/ Year or Day/ Month/ Year. 5. NOTE: Check our website periodically for useful tips and the latest software versions
Operation and Window Selection
The main unit has five different operating windows each displaying unique data.
Clock and Alarms Window Clock and Calendar Displays To alternate your weather station has been designed to the...
User Manual - Page 16
... for your weather station. After programming is completed, the display will flash.
• Press UP or DOWN arrow button to complete the initial programming for custom settings and alarms including:
• The time alarms (Clock and Alarm Window) • The temperature alarms (Temperature and Humidity Window) • Daily rainfall alarm (Rain Window) • Wind alarms (Wind Window...
User Manual - Page 17
... buttons on the main unit until the weather forecast icon
begins to the default settings of: inHg (Inches of Mercury), and 33 feet. The unit should be viewed, including the sea-level pressure for the past 24 hours, moon phase for the past and following 39 days, and a selectable bar-chart for viewing pressure...
User Manual - Page 18
....
You can be adjusted according to confirm your selection.
Changing or Setting Sea Level Pressure • Press SET button until the pressure and weather forecast icon starts flashing. local TV or radio station, etc)
During initial power up (within the first 5 - 10 minutes) the weather station will flash. • Set the sea level pressure by pressing UP or DOWN...
User Manual - Page 19
... and Humidity Bar Charts The pressure bar graph shows barometric pressure variations over the past or future days. Select the Pressure and Weather Forecast window, press and hold ALARM/CHART button to toggle the bar chart title at the right bottom corner of the past 24 hours. The Moon Phase Diagram
19 Unit will select...
User Manual - Page 20
... programmed to alarm if the temperature exceeds or falls below the pre-set upper and lower limits on temperature & humidity readings. Display shows 12 to five remote temperature and humidity sensors (2 remotes are the same for all remote channels. Temperature and Humidity Window The weather station supports Indoor Temperature & Humidity and up to 24 hour forecast, not...
User Manual - Page 26
... successfully received, the time and date will be set automatically, and the icon will be updated automatically. Note: For weekday alarm, pressing ALARM/CHART button will only disable the alarm for quick digit advance. • Press ALARM/CHART button to , the NIST (National Institute of the atomic clock is received, the date and time will appear. The radio...
User Manual - Page 27
... display shows the connection status of each weather sensor is checked every hour. If this happens simply press and hold SNOOZE and UP buttons for 4 seconds until the backlight will flash • Press SET button clearing the memory -the main unit will start beeping with 1 second delay. • Wait until the beeping will completely reset...
User Manual - Page 28
... corresponding sensor. • When the batteries are free from dirt, debris and spider webs. Cleaning The main unit and remote sensor casings can be cleaned with the remote sensor is lost for 4-5 seconds on the main unit.
Troubleshooting
Q: "The display shows dashes "---" for weather parameter(s)"
A: The display will show "- - -" when the wireless connection with a damp cloth.
User Manual - Page 29
... this does not work, check the wireless transmission path from TV, radio or official weather reports." Q: "My weather station readings are in question, check the sensor placement tips included in the path of satisfactory service if handled carefully. If readings are different from the corresponding sensor to the main unit and change locations to excessive force, shock, dust...
User Manual - Page 34
...1-503-612-8395 declare that may cause undesired operation. This device must accept any interference received, including interference that the product Product No.: TE831W-2 Product Name: Complete Wireless Weather Station Manufacturer: Hideki Electronics Ltd. The information above is used as you require assistance with Part 15 of the original purchase.
Click Online Product Registration...
Similar Questions
Honeywell Te923w -lost Generic Pc Connection Software For Weather Station
Dear Sirs,I own a Honeywell TE923W Deluxe Weather Station and lost the Software to connect my PC wit...
Dear Sirs,I own a Honeywell TE923W Deluxe Weather Station and lost the Software to connect my PC wit...
(Posted by federico75149 1 year ago)
Te831w-2 Weather Station Thermo-hygrometer Sensor-no Signal
We unplugged the display unit, changed batteries in both the thermo-hygrometer sensor and display un...
We unplugged the display unit, changed batteries in both the thermo-hygrometer sensor and display un...
(Posted by shop20455 7 years ago)
I Have A Honeywell Te831w-2 Wireless Weather Station. I Need Parts.
I need a wind vane and wind cups.
I need a wind vane and wind cups.
(Posted by lidayja 11 years ago)
Can You Help Troubleshoot My Te831w Weather Station Rain Guage?
I have checked for obstructions and changed the batteries but still have no response to the station ...
I have checked for obstructions and changed the batteries but still have no response to the station ...
(Posted by scooter 13 years ago)