Honeywell TE831W-2 Support Question
Honeywell TE831W-2 Support Question
Find answers below for this question about Honeywell TE831W-2 - Complete Wireless Weather Station.Need a Honeywell TE831W-2 manual? We have 1 online manual for this item!
Question posted by suhayda on November 28th, 2015
Te831w-2 Weather Station Will Not Register Wind Speed.
The batteries have been changed and everything else works, but the wind speed will not register, just says 00.
Current Answers
Related Honeywell TE831W-2 Manual Pages
User Manual - Page 1
HONEYWELL TE831W-2
COMPLETE WIRELESS WEATHER STATION
USER MANUAL TE831W-2
User Manual - Page 2
...
4
Thermo-Hygrometer Sensors TS33C
5
Rain Gauge TS906
6
Anemometer (wind sensor) TS805
8
Main Unit
10
Power
11
Buttons and Controls
12
Initial Set up
14
Connecting the Weather Station to a PC
14
Operation and Window Selection
15
Custom Weather Station Settings
16
LED Backlight Options
25
Time Alarm Settings
25
Memory Reset procedure
27
Maintenance
27
Troubleshooting...
User Manual - Page 3
... up to 100 feet (30 meters). Weather measurements include: air temperature, relative humidity, barometric pressure, wind speed and direction, rainfall levels and more. ...weather data right at 433MHz radio frequency, so no wire installation is transmitted to measure weather elements with wrench tool One User Manual Required for selecting the Honeywell Complete Wireless Weather Station...
User Manual - Page 4
... See placement tips in the battery compartment • Remove plastic sleeve from the battery compartment in this Honeywell Complete Wireless Weather Station operate at 433MHz radio frequency. otherwise the main unit... page in the following order: Anemometer (wind sensor) Rain Gauge (rain sensor) IMPORTANT: The Rain Gauge battery compartment locates inside the funnel assembly - please...
User Manual - Page 8
ANEMOMETER ARM Connects battery to the main unit via 433 MHz signal • Operating range 100 feet (30 meters) • Wall or pole mount
A. WIND CUPS Measures wind speed C. Anemometer (wind sensor) TS805
FEATURES • Wind speed and wind direction measurement • Remote wind speed and wind direction data transmission to the anemometer head assembly.
8 • Place the ...
User Manual - Page 10
...changing the batteries. Note: Repeat aligning procedure every time after main unit has been powered and all remote weather sensors were received successfully.
• Manually point the wind... from the US Atomic Clock and outdoor measurements from US Atomic clock • 12 or ... Dual crescendo alarms with a paper clip. unit (0.0 mph will be updated • Replace the battery compartment door ...
User Manual - Page 11
... control.
When the main unit operates solely on the battery power, the auto backlight control functions are disabled. &#...weather alerts including: Hi/Low temperature, Daily Rainfall, Hi wind gust and Hi wind speed alerts • Indoor/Outdoor Temperature & Humidity in the following areas: • Direct sunlight and surfaces emitting and radiating heat, such as cordless phones, radio...
User Manual - Page 14
...Pressure and Weather Forecast Window) • The time, the date and the weekday language (Clock and Alarm Window) ...on the main unit display
Connecting the Weather Station to a PC To collect and manipulate ... interval from the battery compartments)
2. Then power up
1. The software works when main display ... send them by selecting the weather parameters to be changed or customized to show the ...
User Manual - Page 15
..., Date and Language 15 Clock and Alarms Window Clock and Calendar Displays To alternate your view of the week 2. Time with the Seconds 4.
The basic operation of your computer hard drive in text file called RECORDS.txt. Press the UP arrow button on your weather station has been designed to work straight out of the box...
User Manual - Page 16
... do not complete this book, for your station, you with additional operational details and suggestions for custom settings and alarms including:
• The time alarms (Clock and Alarm Window) • The temperature alarms (Temperature and Humidity Window) • Daily rainfall alarm (Rain Window) • Wind alarms (Wind Window)
16 To use your location. Custom Weather Station Settings...
User Manual - Page 17
...changed as
17
Altitude is displayed inHg (English), hPa/mBar (scientific) or mmHg (metric).
Display:
Select Pressure and Weather Forecast Window
Press UP or DOWN arrow buttons on the main unit until the weather..., sea level pressure, weather forecast and moon phases. Pressure and Weather Forecast Window Your weather station is designed to view a pressure or altitude information.
User Manual - Page 18
... value can be selected. If you wish to GPS readings, Internet, etc. local TV or radio station, etc)
During initial power up (within the first 5 - 10 minutes) the weather station will automatically calculate altitude.
Changing Pressure and Altitude Parameters The weather station is flashing, inHg, mmHg or hPa/mBar • Set the pressure units by pressing the...
User Manual - Page 20
... be displayed in either Celsius (ºC) or Fahrenheit (ºF).
Temperature and Humidity Window The weather station supports Indoor Temperature & Humidity and up to 24 hour forecast, not current conditions. The main...the same for all remote channels. The main unit can be programmed to alarm if the temperature exceeds or falls below the pre-set upper and lower limits on temperature...
User Manual - Page 23
... rainfall alert value will be displayed; NW) or in either "inch/hr" or "mm/hr". The unit displays anemometer temperature or wind chill, average wind speed (over the past month.
Press and hold ALARM/CHART button until the rainfall alert "ALARM HI" will flash. • Set the desired value for fast digits advance. • Press...
User Manual - Page 24
... in km/h, mph, m/s or knots With the wind icon flashing, press and hold MEMORY button to recall a current wind speed, a wind speed alert with the "ALARM HI" displayed or gust alert with the "GUST ALARM HI" displayed.
24
Setting Wind Speed in km/h, mph, m/s or knots. Resetting the Wind Statistics Memory With the wind icon flashing, press and hold the SET...
User Manual - Page 27
... • Reinstall the batteries and reconnect the main unit to activate a new search. Memory Reset Procedure
These steps will completely reset all of the parameters... wall power outlet through the AC/DC adapter
Maintenance
Changing Batteries The battery status of each weather sensor is checked every hour.
However, occasionally other radio transmission sources (TV, Cordless or Cell Phones etc...
User Manual - Page 28
Changing Remote Sensor Batteries • Replace the batteries following periods:
Thermo-Hygrometer
15 minutes
Anemometer (Wind Sensor): 15 minutes
Rain Gauge (Rain Sensor) 30 minutes
28 Small parts can be cleaned with the remote sensor is lost for the following the setup instructions for the corresponding sensor. • When the batteries are free from dirt, debris...
User Manual - Page 29
...; Read the user's manual thoroughly before operating the product.
29 Q: "My weather station readings are in this does not work, check the wireless transmission path from TV, radio or official weather reports." A: The weather data may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts. • Do not tamper with the main unit. Doing so will invalidate...
User Manual - Page 32
... Threshold: 3mph (4.8 Km/h) Transmitting interval: 33 seconds Operating Range: 100 feet (30 m)
Wind Speed Range: 0 to 199.9mph (199.9 Km/h, 173.7 Knots, 89.3 m/s) Resolution: 0.1mph (0.16 Km/h) Accuracy: (2mph + 5%) Starting Threshold: 3mph (4.8 Km/h) Wind/Gust Speed Display Update Interval: 33 seconds Wind/Gust Sampling Interval: 11 seconds Operating Range: 100 feet (30 m)
Rainfall 1h/24h...
User Manual - Page 34
... INFORMATION
This product is in conformity with Part 15 of retail purchase. To register your original receipt as a contact for support or sales. Copyright (2008) ...97062 Telephone No.: 1-503-612-8395 declare that the product Product No.: TE831W-2 Product Name: Complete Wireless Weather Station Manufacturer: Hideki Electronics Ltd. The information above is subject to obtain a Return...
Similar Questions
Honeywell Te923w -lost Generic Pc Connection Software For Weather Station
Dear Sirs,I own a Honeywell TE923W Deluxe Weather Station and lost the Software to connect my PC wit...
Dear Sirs,I own a Honeywell TE923W Deluxe Weather Station and lost the Software to connect my PC wit...
(Posted by federico75149 1 year ago)
Te831w-2 Weather Station Thermo-hygrometer Sensor-no Signal
We unplugged the display unit, changed batteries in both the thermo-hygrometer sensor and display un...
We unplugged the display unit, changed batteries in both the thermo-hygrometer sensor and display un...
(Posted by shop20455 7 years ago)
Can You Help Troubleshoot My Te831w Weather Station Rain Guage?
I have checked for obstructions and changed the batteries but still have no response to the station ...
I have checked for obstructions and changed the batteries but still have no response to the station ...
(Posted by scooter 13 years ago)
Why Is My Main Unit Not Displaying The Wind Speed And Direction
It has been working fine for about a year now. I changed the batteries in the wind sensor and it sti...
It has been working fine for about a year now. I changed the batteries in the wind sensor and it sti...
(Posted by tracycain 14 years ago)