Honeywell HZ-2030 Support Question
Honeywell HZ-2030 Support Question
Find answers below for this question about Honeywell HZ-2030 - Safety Sensor Heater.Need a Honeywell HZ-2030 manual? We have 1 online manual for this item!
Question posted by allisonrome17 on December 23rd, 2022
Heater Not Heating
reset light keeps flashing. Now the reset light on the right is staying lit. Heater is not blowing or heating
Current Answers
Answer #1: Posted by SonuKumar on December 23rd, 2022 10:01 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,633,680
Member since:
May 9th, 2021 Points: 16,633,680
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Honeywell HZ-2030 Manual Pages
Owners Manual - Page 1
... HZ-707/HZ-708/HZ-709/HZ-710 Series HZ-707C/HZ-708C/HZ-709C/HZ-710C Series
IMPORTANT SAFETY INSTRUCTIONS
When using this manual. If provided, use of an extension cord because the extension cord may cause overheating and distortion of the heater and keep them away from the sides and rear.
3. Do not operate any heater with reduced sensitivity to heat...
Owners Manual - Page 2
...Incorrect
If the controls are located at 120 VAC, 60 Hz.
NOTE: THESE MODELS OF OIL-FILLED HEATERS MAY TAKE UP TO SEVERAL MINUTES TO REACH NORMAL OPERATIONAL ...heaters contain oil that is now ready for use.
• Place the heater on the heater and tighten using the wing nuts provided (Fig. 2).
• Turn heater right-side up. Oil-filled_OM_rev3.qx 5/1/06 10:17 AM Page 2
IMPORTANT SAFETY...
Owners Manual - Page 3
...HZ-605C/HZ-690 OPERATION
• With the power control knob in use.
• When the room reaches a comfortable temperature, slowly turn on a circuit when the heater is Power
in the High setting. The power light...unit on this setting, Fig. 4b the thermostat will illuminate, and the heater is 1000 watts of power. The maximum heat on and off . Press II for Fig. 4a
Medium setting and ...
Owners Manual - Page 4
...; Turn the power control knob OFF ( ) and unplug heater when finished using the heater.
Oil-filled_OM_rev3.qx 5/1/06 10:17 AM Page 4
HZ-690 OPERATION (Continued)
• When the room reaches ...is equipped with three different heat settings. Fig. 6
Desired Temperature Light
• To turn -off . Fig. 7
• To change your timer for up to set the heater operation time (Fig. 8)....
Owners Manual - Page 5
...burning odor and smoke (Fig. 10).
NOTE: THIS HEATER IS OIL FILLED AND WILL COOL DOWN SLOWLY AFTER THE POWER IS SHUT OFF. It will stay illuminated until you have elapsed.
• Check to ...the top of your display will illuminate (Fig. 9). TIP-OVER SWITCH FEATURE (HZ-707/708/709/710 SERIES ONLY)
This heater is equipped with a tip-over . For more troubleshooting tips, visit our website ...
Owners Manual - Page 6
... CHEMICAL SOLUTION.
5 YEAR LIMITED WARRANTY
You should be returned to repair or replacement of the heater. KAZ IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE. D. This 5 year... product if it . All Rights Reserved. You must prepay shipping charges. DO NOT ATTEMPT TO OPEN THE HEATER YOURSELF. IF YOU HAVE ANY QUESTIONS REGARDING THIS HEATER, PLEASE CALL OR WRITE:
...
Similar Questions
Heater Will Not Turn On. Electric Source Is Good.
my heater will not cut on. Any suggestions
my heater will not cut on. Any suggestions
(Posted by fryeboys3 2 years ago)
Hz 709 Heater Won't Hold The Set Temperature. Ex. When Set To 78, It May Go To 8
(Posted by nsaturnv 2 years ago)
Honeywell Space Heater Won't Turn On
(Posted by turandawnc 9 years ago)
Safety Sensor Shuts It Off For Know Reason
It is on for less than a minute and the sensor shuts it down,. there nothing in front of it. I have ...
It is on for less than a minute and the sensor shuts it down,. there nothing in front of it. I have ...
(Posted by jdmmoran 11 years ago)
My Heater Won't Come On.
I press the safty knob down and rotate to on, either low, fan or hi. I turn the temp from 1-10 and s...
I press the safty knob down and rotate to on, either low, fan or hi. I turn the temp from 1-10 and s...
(Posted by sbullock7 13 years ago)