Hitachi NV75AG Support Question
Hitachi NV75AG Support Question
Find answers below for this question about Hitachi NV75AG - 3" Utility Coil Nailer.Need a Hitachi NV75AG manual? We have 1 online manual for this item!
Question posted by daver8189 on January 27th, 2023
What's The Back Dial Knob On The Hitachi Nailer What's That For
What's the adjustment knob for on the back of the nail gun
Current Answers
Answer #1: Posted by SonuKumar on January 27th, 2023 6:45 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,622,280
Member since:
May 9th, 2021 Points: 16,622,280
The adjustment knob on the back of the Hitachi NV75AG nail gun is used to set the depth of the nails being fired. It allows the user to adjust the depth of the nails so they can be set to the desired level in the material being nailed.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Hitachi NV75AG Manual Pages
Instruction Manual - Page 3
...sections which contain the operation and maintenance instructions. English
IMPORTANT INFORMATION
Read and understand tool labels and all of the operating instructions, safety precautions and warnings in death or ... to prevent bodily injury or machine damage are caused by DANGERS and WARNINGS on the Nailer and in this Manual. NOTE emphasizes essential information.
- 3 - DEFINITIONS OF SIGNAL ...
Instruction Manual - Page 4
...Nailer by the Nailer operator and others , whether it can burst.
7. Never connect the Nailer... Nailer... Nailer, always wear safety glasses with the Nailer. EXPLOSION...carry the Nailer with ...implement.
4. Never point the Nailer at yourself toward yourself or ...Nailer.
CHOICE OF TRIGGERING METHOD IS IMPORTANT. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS. NEVER POINT TOOL...
Instruction Manual - Page 5
...are deflected by the workpiece, or are recommended when working outdoors. Never use the Nailer if parts are combustible or explosive.
11. All visitors should be driven. Wear .... Keep out of reach of unnecessary tools, debris, furniture, etc.
10. Clear all screws and covers tightly mounted. Do not let visitors handle the Nailer. KEEP VISITORS AWAY. Never place your...
Instruction Manual - Page 6
... if you are dangerous. IMPORTANT SAFETY INSTRUCTIONS FOR USING NV75AG COIL NAILER
WARNING
1. Continued
WARNING
23. Because of wire collating fasteners can be operated by a Hitachi authorized service center.
26. Handle the Nailer carefully.
32. NEVER USE NAILER WHICH IS DEFECTIVE OR OPERATING ABNORMALLY. HANDLE NAILER CORRECTLY. USE ONLY PARTS, ACCESSORIES OR FASTENERS SUPPLIED...
Instruction Manual - Page 7
... repair. Ensure that this MANUAL is available to operators and personnel performing maintenance.
2. Ensure that Nailers which require repair are wearing EYE PROTECTOR.
3. SAVE THIS MANUAL AND KEEP IT AVAILABLE FOR OTHERS!
- 7 - Maintain Nailers properly.
6. Keep Nailers in work area are not further used only when operators and others in safe working order...
Instruction Manual - Page 8
... details or attachments that differ from those on your own Nailer.
Feed Piston Feed Spring NAME OF PARTS
Top Cover
Exhaust Cover Piston
Piston O-Ring Driver Blade
Trigger
Body
Air Plug (Sold separately)
Nose Feeder
75
A
A Knob
Push Lever
Nail Guide
Dust Cover Firing Head (Outlet)
Cap Adjuster Nail Holder Magazine Assembly
Magazine Cover Section...
Instruction Manual - Page 9
...nails (1 coil)
.064 ft3/cycle at 100 psi (1.8 ltr/cycle at 6.9 bar) (1.8 ltr/cycle at 7 kgf/cm2)
3/8 NPT Thread
NAIL SELECTION
Only nails shown in the Table below can be driven with this Nailer....090" (2.3mm)
Dimensions of nails Nails are collated and coiled, as shown in the
1
magazine assembly)
- 9 - NOTE: Use only genuine Hitachi nails to malfunction and resulting injuries. Wire-collated...
Instruction Manual - Page 10
... Hitachi pneumatic tool lubricant. APPLICATIONS
⅜ Floor and wall framing ⅜ Siding, fencing, decking ⅜ Wall and roof sheathing ⅜ Mobile home and modular housing construction ⅜ Crate and pallet construction
NOTE: ⅜ .131" × 3" (3.3 mm × 76 mm) nails cannot be installed as a power source for the Nailer and extend the Nailer life. Nailer Side...
Instruction Manual - Page 11
... a warm area until beginning the work area MUST wear safety glasses with Hitachi pneumatic tool lubricant. ⅜ If a lubricator is required. REMOVE ALL NAILS FROM NAILER.
Ⅺ ALL SCREWS MUST BE TIGHTENED. This will be used. Keep the Nailer in work .
⅜ If the Nailer is operating properly.
English
Dust Cap
3/8 NPT Male Plug
⅜ A female...
Instruction Manual - Page 12
....
Trigger
Push Lever
Do not connect air hose
(2) Adjust the air pressure to the length of nails and the hardness of workpiece. Pull Trigger
(3) With finger off the workpiece, pull the trigger.
Connect the air hose. and 3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with finger. Do not pull Trigger Depress Push...
Instruction Manual - Page 13
...
(3) Place the nail coil into the driving hole and the second nail between the two pawls of the feeder. Fit the nail head and upper side of the plastic sheet in the magazine, adjust the plate. Wire collated nails
Insert the first nail into the magazine. Lift or lower the nail holder to accept different length nails.
3 Adjust the plate...
Instruction Manual - Page 14
... someone .
ⅷ Never drive nails from both sides of triggering method is not in work area; 3) moving it to drive a nail. 4 Remove finger from Nailer when:
1) it is desired
WARNING
ⅷ Keep your hands or feet closer than 8 inches (200 mm) from the trigger.
3
1
Previously pull
the trigger
This Hitachi nailer has a STANDARD CONTACT TRIP...
Instruction Manual - Page 15
... of the exhaust vent can spark out of Hitachi pneumatic tool
lubricant into the workpiece, adjust the nailing in the following order. 1 DISCONNECT AIR HOSE FROM NAILER. 2 If nails are driven too deep, turn the adjuster to the deep side.
( ) Shallow
( ) Deep Adjuster Flush Too deep Too shallow
3 Stop turning the adjuster when a suitable position is desired and must...
Instruction Manual - Page 16
...
Nose cap
Push lever
Nose cap can be stored on the magazine as shown below. Re-adjustment of nailing depth is required.
NOTE: ⅷ The nose cap may reduce nailing depth due to the toe of the push lever.
Push Lever Nose Cap
Nose
Hole Protrusion ... push lever, attach the accessory nose cap to the push lever. 1 DISCONNECT AIR HOSE FROM NAILER. 2 Put the nose cap to its
thickness.
Instruction Manual - Page 17
... AND INSPECTION
Read section titled "SAFETY" (pages 4 - 7).
Rod Outlet
1 Disconnect air hose
4 Remove the jammed nail with Hitachi pneumatic tool lubricant. Knob Nail Guide
1 Disconnect air hose
3 Open the nail guide and remove dust. Nail guide Nail Stopper (B)
Shaft Feeder Nose
4 Lubricate the feeding surfaces of the Nailer. This promotes smooth operation and prevents rust.
- 17 -
Instruction Manual - Page 18
...
ⅷ Repair, modification and inspection of HITACHI. All quality Nailers will be observed. MODIFICATIONS: Hitachi Power Tools are subject to avoid rust.
⅜ Do not store the Nailer in the magazine.
5.
English
CAUTION
ⅷ Check that nail stopper (A) and nail stopper (B) slide smoothly by pusing them with the tool to incorporate the latest technological advancements...
Instruction Manual - Page 19
... element -
Open petcock on air compressor tank. Check air pressure.
---
Check inside diameter of lubricant into the Nailer. Adjust nail holder to cycle. Use larger air hose.
- 19 - WHY Prevent accumulation of filter with Hitachi pneumatic tool lubricant. Drives too deep. Driver blade worn? Piston O-ring cut or heavily worn?
English
Maintenance chart
ACTION Drain...
Instruction Manual - Page 56
C99118063 N Printed in Japan Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo 108-6020, Japan
Distributed by
Hitachi Koki Co., Ltd. Norcross, GA 30093
Hitachi Koki Canada Co.
6395 Kestrel Road Mississauga ON L5T 1Z5
310 Code No. Issued by
Hitachi Koki U.S.A., Ltd.
3950 Steve Reynolds Blvd.
Similar Questions
Screeching Noise
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
(Posted by Rongowrie 2 years ago)
Instructions For Trip Mechanism
How do I install the trip mechanism for a Hitachi NV75AG nailer? The instructions that came with it ...
How do I install the trip mechanism for a Hitachi NV75AG nailer? The instructions that came with it ...
(Posted by annettemikew 6 years ago)
Why Does The Catch For Coil Magazine Sometimes Trip On Nv75 Ag When In Use?
(Posted by Anonymous-109111 11 years ago)
Hitachi Av65ah Jams
With wire-collated stainless steel siding nails my nailer jams constantly (every 5-10 nails). What i...
With wire-collated stainless steel siding nails my nailer jams constantly (every 5-10 nails). What i...
(Posted by robdaves 11 years ago)
My Nailer Won't Completely Sink A Nail
Is there an adjustment or could it be my compressor?
Is there an adjustment or could it be my compressor?
(Posted by jscrofford 13 years ago)