Hitachi NV45AES Support Question
Hitachi NV45AES Support Question
Find answers below for this question about Hitachi NV45AES - Coil Roofing Nailer.Need a Hitachi NV45AES manual? We have 2 online manuals for this item!
Question posted by jmartell83837 on January 6th, 2015
I Have An Hitachi 45ae Coil Roofing Nailer That Has Begun To Leak Continuously
thru the exhaust port. Can you help me solve this problem. The equipment is less than a year old and i am not sure what to do. Would appreciate any solution that you can offer. Thank you.
Current Answers
Answer #1: Posted by hzplj9 on January 6th, 2015 8:23 AM
hzplj9
Member since:
June 25th, 2012 Points: 4,874,710
Member since:
June 25th, 2012 Points: 4,874,710
This is the response I placed yesterday. Was it not helpful?
If it is a manufactureres fault then a recall should be available. You will need to contact the seller.
"Difficult to diagnose without inspection. Possibly a seal has failed or could be a symptom of over-oiling of the pneumatics. The oil is very thin and so could easily leak through. There are parts and user manuals available from Manual Owl, this is the link."
Related Hitachi NV45AES Manual Pages
Instruction Manual - Page 3
...Nailer for applications other than those specified in this manual before it occurs, and by the failure to observe basic safety rules or precautions.
English
IMPORTANT INFORMATION
Read and understand tool... be avoided by recognizing a potentially hazardous situation before operating or maintaining this nailer. An accident can often be avoided to follow warnings could result in minor...
Instruction Manual - Page 4
... in work area wear safety glasses, too. When operating the Nailer, always wear safety glasses with side shields, and make sure others , whether it can burst.
7. Safety glasses must enforce.... Use only clean, dry, regulated compressed air. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA. Respect the Nailer as the Nailer can lead to pressure which potentially exceeds 200 psi (13.7 ...
Instruction Manual - Page 5
... unnecessary tools, debris, furniture, etc.
10. NEVER CARRY NAILER BY HOSE.
- 5 - STORE NAILER PROPERLY. Do not let visitors handle the Nailer. NEVER USE NON RELIEVING COUPLER ON NAILER. English
SAFETY - Continued
WARNING
... or damaged.
16. The Nailer and air hose must have a hose coupling such that may be caught in a dry place. Make sure the push lever operates properly...
Instruction Manual - Page 6
... of alcohol, drugs or medication that makes you are dangerous. Only service personnel trained by a Hitachi authorized service center.
26. NEVER MODIFY OR ALTER A NAILER. Never attempt to be used by children, individuals unfamiliar with the Nailer might handle it immediately and arrange for better and safer performance.
33. Use common sense. and...
Instruction Manual - Page 7
... be ignited by a spark produced during nailing, which require repair are wearing EYE PROTECTOR.
3. IMPORTANT SAFETY INSTRUCTIONS FOR USING NV45AE(S) COIL NAILER
WARNING
1. English
SAFETY - Continued
IMPORTANT SAFETY INSTRUCTIONS FOR USING NV45AE COIL NAILER
WARNING
1. CLOSE NAIL GUIDE AND DO NOT OPEN IT DURING OPERATION. If driving fasteners with the nail guide open , the...
Instruction Manual - Page 8
...to assist you in this Manual may show details or attachments that differ from those on your own Nailer. NAME OF PARTS
Piston O-ring Piston
Driver blade
Exhaust cover
Trigger
Body
Cap Air plug (sold separately)
Magazine cover
Adjuster
A
Magazine assembly
A
Nose
Push...Magazine cover Shingle guide
- 8 - English
OPERATION
NOTE: The information contained in the safe operation of the Nailer.
Instruction Manual - Page 9
... sure to serious injuries.
The use only the genuine HITACHI nails for M4 screw
23
1 1 1
- 9 -
Only nails shown in the Table below can result in tool ...NV45AE/NV45AE(S). Wire-collated coil nails
Min.
.413" (10.5mm)
Max.
.413" (10.5mm)
7/8"(22mm) 1-3/4"(45mm)
.120" (3.05mm)
.120" (3.05mm)
ACCESSORIES
WARNING
ⅷ Accessories other nails can be driven with this Nailer...
Instruction Manual - Page 10
... coupler on Nailer.
1. Make sure of lubricant is higher.
4. sold separately
⅜ Sequential Trip Mechanism Kit (Code No. 878226)
(Single Shot Parts)
⅜ Pneumatic Tool Lubricant
1 oz...pressure from the Nailer when disconnected. Inspect the lubricator before operation. Install a 3/8 NPT male plug at worksite.
ⅷ Clear the area of HITACHI.
BEFORE OPERATION
Read...
Instruction Manual - Page 11
... consumption table and the Air compressor size formula, find a compressor providing 3.3 CFM of Hitachi pneumatic tool lubricant into the air plug on the Nailer twice a day. Without proper lubrication, the Nailer will not work area MUST wear safety glasses with Hitachi pneumatic tool lubricant. ⅜ If a lubricator is required. This will harm the O-rings and other...
Instruction Manual - Page 12
... not feed smoothly if the nail holder is the same type to align the plate of the nails being used in the Nailer. Ⅺ THE NAILER MUST NOT LEAK AIR. Using the Nailer at recommended operating pressure 70 - 120 psi (4.9 - 8.3 bar 5 - 8.5 kgf/cm2) according to the length of nails and the hardness of the...
Instruction Manual - Page 13
...correctly, the nail holder may be damaged.
(3) Place the nail coil in the magazine. Knob 4
4 Nail guide
(6) Lock the ...the nail holder according to the right After checking and making sure that the magazine cover is forcibly closed without adjusting the nail... nails in accordance with the guide surface.
Magazine cover
The Nailer is forcibly closed , hook your fingers on the holder shaft...
Instruction Manual - Page 14
... a person on workpiece with finger.
Magazine opening . Press the knob down and swing the nail guide open. NAILER OPERATION
Read section titled "SAFETY"(pages 4 - 7). Otherwise, the nail guide will not close correctly.
ⅷ NEVER point tool at the same time. and 4) handing it to the right, swing the nail guide closed.
(7) Lock...
Instruction Manual - Page 15
... desired number of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; Push lever 2
3 Trigger
(2) Continuous operation (Push lever fire) 1 Pull the trigger with a bouncing motion. The nailer with finger off ...with contact trip mechanism may bounce from the trigger. METHODS OF OPERATION
This Nailer is equipped with this procedure. After the each nail is less likely to drive an...
Instruction Manual - Page 16
... upward. socket hd. Adjust the shingle guide in the following order. 1 DISCONNECT AIR HOSE FROM NAILER 2 Loosen the hex. Furthermore, turn the adjuster until it reaches a position where it returns upward...used to control shingle spacing.
English
USING THE SHINGLE GUIDE
The shingle guide can be sure that each nail penetrates to the same depth, be fiexed each at 1/4 rotation. ...
Instruction Manual - Page 17
...nail stopper
Nail guide
Nail
Slotted screw driver 5 Cut the deformed collated wire with Hitachi pneumatic tool lubricant.
1 Knob
Disconnect air hose
Nail guide
3 Open the nail guide and...
Correct the deformation. 6 In case of the Nailer. Clearing a jam
Remove a jammed nail in the safe maintenance of frequent jam, contact a Hitachi
authorized service center.
If not smooth, nails can...
Instruction Manual - Page 18
.... Used D: Remarks
CAUTION
ⅷ Repair, modification and inspection of power tools, the safety regulations and standards prescribed in use , the Nailer should be accelerated. In the operation and maintenance of Hitachi Power Tools must be carried out by an Hitachi Authorized Service Center.
English
3.
Vapor of HITACHI.
- 18 - Do not immerse the magazine or body. Plastic...
Instruction Manual - Page 19
... METHOD Open nail guide. Check for replacement. Check position of air hose.
Check function of feeder per page 17.
--- Use Hitachi pneumatic tool lubricant.
Keep the Nailer lubricated. Prevent a jam. Blow clean daily. PROBLEM Nailer operates, but does not drive fully at faster nailing speeds. Drives too deep. Check function of nail feeder per page...
Instruction Manual - Page 64
Issued by
Hitachi Koki U.S.A., Ltd.
3950 Steve Reynolds Blvd.
Norcross, GA 30093
Hitachi Koki Canada Co.
450 Export Blvd. C99167461 N Printed in Japan Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo 108-6020, Japan
Distributed by
Hitachi Koki Co., Ltd. Unit B, Mississauga ON L5T 2A4
710 Code No.
Parts List - Page 3
... 949-662 HEX. SOCKET HD. USED
2
REMARKS
NV 45AE
2 876-179 TOP COVER
1
* 3 883-513 WARNING LABEL (A)
1 FOR USA, CAN
4 886-389 EXHAUST COVER (B)
1
5 949-757 HEX. SOCKET HD. BOLT...891 PROTECTOR
2
7 883-890 BODY GUARD
2
8 883-892 GASKET (F)
1
9 876-713 GASKET (G)
1
10 878-417 EXHAUST VALVE
1
11 876-711 HEAD CAP
1
12 876-174 PISTON O-RING
1
13 886-391 PISTON (H)
1
14 876-161 ...
Parts List - Page 4
... (10 PCS.)
3
54 872-035 DUST CAP
1
55 949-866 ROLL PIN D3X30 (10 PCS.)
2
56 886-342 HITACHI PLATE
1
57 872-645 O-RING (P-9)
1
58 877-763 FEED PISTON O-RING (I.D.14)
1
59 886-382 FEED PISTON
... (10 PCS.)
1
100 949-453 SPRING WASHER M4 (10 PCS.)
1
- 4 -
*ALTERNATIVE PARTS
NV 45AE 11 - 07 CODE NO.
51 877-131 GASKET (D)
DESCRIPTION
NO. PARTS
ITEM NO.
SOCKET HD. SOCKET HD.
Similar Questions
How Do You Install A Sequential Fire Mechanism In A Hitachi Nv65ah Nailer
(Posted by Anonymous-170890 2 years ago)
Screeching Noise
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
(Posted by Rongowrie 2 years ago)
Can't Get Air Out Of Quick Couplers.
Replaced the broken pressure reducer still no air and the working pressure Gage doesn't work. could ...
Replaced the broken pressure reducer still no air and the working pressure Gage doesn't work. could ...
(Posted by lstoner34 3 years ago)
Air Outlet
I put a new regulator on the compressor. I do not get any air out of air connections. advise what ma...
I put a new regulator on the compressor. I do not get any air out of air connections. advise what ma...
(Posted by w39dennis 6 years ago)
Both My Hitachi 45ae Are Leaking Through The Exhaust. Any Idea On How To Repair.
(Posted by jmartell83837 9 years ago)