Hitachi NT65GB Support Question
Hitachi NT65GB Support Question
Find answers below for this question about Hitachi NT65GB - 2-1/2 Inch Gas Powered Angled Finish Nailer.Need a Hitachi NT65GB manual? We have 1 online manual for this item!
Question posted by torenurra75 on July 13th, 2018
Nt65gb Vent Motor
in my nail gun, the vent, started to vibrate and fell off. I re-fitted it and now all the little pipe where the vent is fixed fell of (don't hold the connection with the motor)
Current Answers
Related Hitachi NT65GB Manual Pages
Instruction Manual - Page 5
... others in work area wear safety glasses, too. Do not touch with dispensers for combustible gas which are listed in this instruction manual. English
SAFETY
IMPORTANT SAFETY INSTRUCTIONS FOR USING NAILERS
READ ALL INSTRUCTIONS
This Nailer is powered by the Nailer operator and others in presence of flammable liquids or gases, e.g. lacquer, paint, benzine, thinner...
Instruction Manual - Page 6
... the fuel cell. No smoking. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA. Never engage in the fuel cell. This Nailer shall not be used in
explosion or fire.... carry the Nailer by the handle only.
7. The device may fail to a naked flame or any incandescent material.
Always wear head protection to follow instructions may burst, releasing flammable gas. Continued
DANGER...
Instruction Manual - Page 7
...position. Never use the Nailer unless the push lever is operating properly, otherwise the Nailer could drive a fastener unexpectedly. Never place your face, hands or feet closer than 8 inches (200 mm) from...the firing head. All visitors should be store in tool case and
in low temperatures and drive operations may be driven into the Nailer, 1) do not depress the trigger; 2) do not...
Instruction Manual - Page 9
... of contact with warm water and soap and apply a skin cream when dry. direct sunlight or in fire and explosion when handling dispensers for combustible gas for aerosol products.
WARNING
Do not inhale its contents.
English
SAFETY - Explosion / Fire Hazard
Failure to follow all instructions may result in a vehicle).
(50 °...
Instruction Manual - Page 11
...vents. ALWAYS operate charger on it, the battery and in this may cause an accident.
11 Use the battery charger correctly. The battery charger is connected... CHARGER
You must charge the battery before you use the Nailer. To avoid these instructions to charge.
11. NEVER 8.... battery or battery charger can explode in -car power source. charge when the temperature is completely worn out...
Instruction Manual - Page 13
...
OPERATION
NOTE: The information contained in the safe operation of the Nailer.
Gas Finish Nailer
Top cover
Actuator
Chamber
Handle
Top cover
Chamber
Actuator Handle Battery
Piston
Driver blade
Trigger
Battery Hook
Piston
Driver blade
Trigger
Firing head
(outlet)
Magazine
Push lever Nail feeder (B)
Top cover
Chamber
Actuator Handle
Magazine
Firing head (outlet...
Instruction Manual - Page 14
Gas Brad Nailer
Top cover
Chamber
Piston Driver blade
Actuator Handle
Battery
Trigger
Hook Stop lever
Firing head
(outlet)
Push lever
Magazine
Magazine cover
3. Battery Charger (UC3SML)
Strap
Battery installation hole
Connecting socket
Charger connecting plug
Pilot lamp
Nameplate (on the bottom side)
Charger connecting plug
Cigarette lighter connecting plug
Cord
14
AC adapter
...
Instruction Manual - Page 15
... current DC 1.5 A 0.4 lbs (0.2 kg)
NOTE: The charging time may vary according to temperature and power source voltage.
15 Gas Finish Nailer
Model Dimensions
Length × Height × Width Weight Includes battery and fuel cell Nail capacity
Cycle rate
Battery Fuel Cell
NT65GS
NT65GB
NT65GA
10-1/4" × 11" × 3-3/8"
10-5/8" × 11-1/8" × 3-3/8"
12" × 12" ×...
Instruction Manual - Page 16
The use only the genuine HITACHI nails for the NT65GS, NT65GB, NT65GA or the NT50GS. Only nails shown in tool malfunction and/or nail breakdown, leading to use of nails
16 Gauge finish nails (straight)
Min. .110" (2.8mm)
Max.
2-1/2" (65mm)
1" (25mm) .051" (1.3mm)
.055" (1.4mm)
.065" (1.65mm)
16 Gauge finish nails (Angle: 20°)
Min. .110" (2.8mm)
Max.
2-1/2" (65mm)
1-1/4" (...
Instruction Manual - Page 21
... max. 120°F (50°C). COLD WEATHER CARE
⅜ Do not store the Nailer, fuel cell and battery in a cold weather environment.
CAUTION ⅷ If the gas leaks from
face or skin. Do not inhale.
ⅷ Keep the Nailer,
120°F MAX fuel cell and
(50°C)
battery away from sunshine and
from...
Instruction Manual - Page 22
...gas is not dispersed, fuel cell is flashing green. Observe Safety Regulations.
CAUTION ⅷ Use caution not to insert into the Nailer.
If the battery indicator light is flashing red, the battery doesn't have enough power..., test the Nailer by using the Nailer and contact a Hitachi authorized service center immediately.
(1) REMOVE ALL NAILS, FUEL CELL AND BATTERY FROM NAILER.
Ⅺ ...
Instruction Manual - Page 24
... into the workpiece that position for 5 seconds or longer.
Ⅺ THE NAILER MUST NOT OPERATE.
Pull the trigger.
Ⅺ THE NAILER MUST OPERATE.
24
Magazine
(2) Slide the nail strip forward in the Nailer. and 3) keep Nailer pointed downward.
2-Action Nail Feeding! (1) Insert nail strip into Nailer, 1) do not pull trigger; 2) do not depress push lever; English
4 Close the...
Instruction Manual - Page 27
... edges of an angle; nails can not return correctly. ⅷ Make sure the nailing depth when the temperature is not in a separate location, move the nailer along the wood, repeating steps 1 - 4 as hammer. ⅷ Disconnect battery and fuel cell from firing head when using.
ⅷ Do not drive nails on the tool. NT65GS, NT65GA, NT65GB enter a state...
Instruction Manual - Page 29
... and the battery from the nailer. English
Nose Cap
Magazine
NT65GS, NT65GA, NT65GB
USING THE NOSE CAP
WARNING
ⅷ When attaching or detaching the nose cap, be sure to remove your finger from the trigger and remove the fuel cell and the battery from the Nailer.
2 Remove all nails.
29 If you like to...
Instruction Manual - Page 31
... of flammable liquids or gases.
ⅷ Keep away from Nailer when: 1) doing maintenance and inspection;
English
MAINTENANCE
NOTE: The information contained in this Manual may have accumulated in
a dry place.
ⅷ Store indoors at an irregular angle and hurt someone.
2. If not smooth, nails can be stored
in tool case and in the magazine.
Instruction Manual - Page 105
... NAME
56 CELL PIN
57 PIPE RUBBER
58 ACTUATER
59 TAPPING ... RIBBON SPRING
93 NAIL FEEDER (B)
94 PRISM
95 CONTROLLER
96 TAPPING SCREW (W/FLANGE) D4×12
97 NAIL RAIL
98 PUSHING SPRING
99 NAIL FEEDER (A)
100...
15 GASKET
1
16 CHAMBER
1
17 PISTON RING (B)
4
18 RETAINING RING FOR D40 HOLE
1
19A MOTOR ASS'Y
1
20 PACKING
1
21 ADAPTER
1
22 HEX. BOLT M4×12
3
33 LOCK PLATE...
Instruction Manual - Page 107
... RUBBER WASHER
23 SHAFT COVER
24 HEX.SHOULDER BOLT M5
25 MOTOR ASS'Y
26 PISTON RING (A)
27 PISTON
28 PISTON BUMPER
29...89 ROLL PIN D3×16
90 RIBBON SPRING
91 NAIL FEEDER (B)
92 NAIL FEEDER (A)
93 PUSHING SPRING
94 ROLL PIN D2.5×26...
501 CHARGER (UC3SML)
502 SAFETY GLASSES
503 HEX. PART NAME
56 PIPE RUBBER
57 ACTUATER
58 BATTERY EBM315
59 SUPPORT (B)
60 INTERNAL WIRE (A)...
Instruction Manual - Page 109
...NT65GB...NAIL FEEDER (B)
92 NAIL FEEDER (A)
93 STOPPER SPRING (C)
94 PRISM
95 CONTROLLER
96 TAPPING SCREW (W/FLANGE) D4×12
97 NAIL...SOCKET SET SCREW M4×5
2
22 SHAFT RUBBER WASHER
1
23A SHAFT COVER
1
24 HEX.SHOULDER BOLT M5
2
25A MOTOR ASS'Y
1
26 PISTON RING (A)
2
27 PISTON
1
28 PISTON BUMPER
1
29 NAME PLATE
1
30 HOUSING
1
31...PIPE RUBBER
1
ITEM NO.
SOCKET HD.
Instruction Manual - Page 111
...
1
ITEM NO. PART NAME
Q'TY
56 CELL PIN
1
57 PIPE RUBBER
1
58 ACTUATER
1
59 BATTERY EBM315
2
60 SUPPORT (B)
...CHAMBER
1
17 PISTON RING (B)
4
18 RETAINING RING FOR D30 HOLE
1
19 MOTOR ASS'Y
1
20 O-RING (S-12)
2
21 PACKING
1
22 ADAPTER
1
23...SPRING
1
94 PLATE
1
90 MAGAZINE
1
96 PRISM
1
97 NAIL FEEDER
1
98 NAIL PLATE
1
99 FEEDER PIECE
1
100 FEED SPRING
1
101 CYLINDER ...
Instruction Manual - Page 112
at 1-800-59-TOOLS (toll free), or HITACHI AUTHORIZED POWER TOOL SERVICE CENTER regarding COLLECTION. au 1-800-59-TOOLS (appel gratuit), ou UN SERVICE APRÈS-VENTE D'OUTILS ÉLECTRIQUE AGRÉ.... número 1-800-59-TOOLS (llamada gratis), o con HITACHI AUTHORIZED POWER TOOL SERVICE CENTER. Please contact HITACHI KOKI U.S.A. Norcross, GA 30093
Hitachi Koki Canada Co.
450 Export Blvd.
Similar Questions
Screeching Noise
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
(Posted by Rongowrie 2 years ago)
Nt65ga Will Not Fire
NT65GA Does not fire when trigger is pulled. Battery has full charge.
NT65GA Does not fire when trigger is pulled. Battery has full charge.
(Posted by dmcgeeoo6 7 years ago)
Change Motor Brushes
(Posted by jdwlds36794 10 years ago)
I Dont Have A Owners Manual
my gun wont shoot nails should adjust it some how
my gun wont shoot nails should adjust it some how
(Posted by moneyharm44 11 years ago)
How Do I Pull The Motor Stator To Replace The Bearings?
My C8FB2 bearing are shot from brick dust. I have the new bearings and the motor housing off but can...
My C8FB2 bearing are shot from brick dust. I have the new bearings and the motor housing off but can...
(Posted by jhraley 11 years ago)