Hitachi HDS728080PLAT20 Support Question
Hitachi HDS728080PLAT20 Support Question
Find answers below for this question about Hitachi HDS728080PLAT20 - Deskstar 80 GB Hard Drive.Need a Hitachi HDS728080PLAT20 manual? We have 1 online manual for this item!
Question posted by caej49 on April 20th, 2010
I Need The Driver For Hitachi Hds728080plat20
i don´t know where shoul i serch if somebody can helme i woul be glad
Current Answers
Answer #1: Posted by DougWeber on April 20th, 2010 10:57 AM
DougWeber
Member since:
February 15th, 2010 Points: 19,020
Member since:
February 15th, 2010 Points: 19,020
I haven't used this site myself, but it appears fairly legitimate. Here is a link to the Hitachi Hds728080plat20 driver:
http://www1.pcpitstop.com/drivers/download/HDS728080PLAT20.html
Related Hitachi HDS728080PLAT20 Manual Pages
Specifications - Page 12
... information definition 126 Table 78.Downlad Microcode Command (92h 127 Table 79.Execute Device Diagnostic command (90h 129 Table 80.Flush Cache command (E7h 130 Table 81.Flush Cache Ext Command (EAh 131 Table 82.Format Track command (50h... Table 86.Identify device information (Part 2 of 7 137 Table 87.Identify device information (Part 3 of 7 138
Deskstar 7K80 Hard Disk Drive Specifacation 8
Specifications - Page 15
... function - AT Attachment with ATA interface and a rotational speed of force)
G2/Hz (32 ft/sec)2 per Hertz
Gb
1,000,000,000 bits
GB
1,000,000,000 bytes
Deskstar 7K80 Hard Disk Drive Specification 11 HDS728040PLAT20 HDS728080PLAT20
41.1GB 82.3GB
For Serial ATA function specification, please refer to change without notice.
1.2 References
• Information Technology...
Specifications - Page 19
Addendum." Deskstar 7K80 Hard Disk Drive specification 15
2.0 General features of the drive
• Formatted capacities of 40 GB and 80 GB • Spindle speeds of 7200 RPM • Fluid Dynamic Bearing motor • Enhanced IDE interface • Sector format of 512 bytes/sector • Closed-loop ...
Specifications - Page 23
... coil motor driver to allow vertical or horizontal mounting without adjustment. Air is constantly circulated and filtered when the drive is electronically controlled by a microprocessor, several logic modules, digital/analog modules, and various drivers and receivers. 3.0 Fixed-disk subsystem description
3.1 Control electronics
The drive is operational.
Deskstar 7K80 Hard Disk Drive...
Specifications - Page 25
... is done automatically in the drive. 4.0 Drive characteristics
4.1 Default logical drive parameters
Table 1: Formatted capacities
HDS728040PLAT20 HDS728080PLAT20
Physical Layout
Label capacity (GB)
40
80
Bytes per sector
512
512
... cylinders to access the drive from the system interface. Deskstar 7K80 Hard Disk Drive Specification 21 The default setting can be obtained by issuing...
Specifications - Page 26
Deskstar 7K80 Hard Disk Drive Specification 22
4.2 Data sheet
Table 2: Mechanical positioning performance
Data ...Hitachi GST
Manufacturing Site
Sriracha Plant, Thailand
Product
Deskstar 7K80
OUI
000CCAh
SHBU Block Assignment
201h
Port/Node ID
11b
Hitachi GST China
Deskstar 7K80 000CCAh 300h 11b
4.4 Drive organization
4.4.1 Drive format
Upon shipment from manufacturing the drive...
Specifications - Page 27
Depending on the capacity some of 0. Deskstar 7K80 Hard Disk Drive Specification 23
Spare cylinder
The spare cylinder is calculated from a defect location. 4.4.2 Cylinder allocation
Table 4: Cylinder... 742 720 702 675 675 630 630 607 594 567
Physical cylinder is used by Hitachi Global Storage Technologies manufacturing and includes data sent from the starting data track of the ...
Specifications - Page 40
... Open-Drain driver and internally pulled up to assert DASP-. Device 0 shall allow up to 450ms for device 1 to assert PDIAG-. At anytime after RESET-
This line is able to indicate that device 1 is active. within 30 seconds to provide status. If device 1 did not assert DASP-
Deskstar 7K80 Hard Disk Drive Specification 36...
Specifications - Page 46
...
- 17.5 - tFS First DSTROBE time
0 230 0 200 0 170 0 130 0 120 - 90 0 80
tCYC Cycle time
112 - 73 - 54 - 39 - 25 - 17 - 13 -
tUI tACK tENV tACK tENV
tZIORDY
DSTROBE... 29 -
ical timing
Deskstar 7K80 Hard Disk Drive Specification 42
tACK Setup time for output drivers to
- 10 - 10 - 10 - 10 - 10
10 - 10
release
tZAD Drivers to -driving until the first transition ...
Specifications - Page 48
... 5 - 5 -
Maximum time before RDYZ releasing IORDY
- 20 - 20 - 20 - 20 - 20 - 20 - 20
Deskstar 7K80 Hard Disk Drive Specification 44 tMLI Interlock time with minimum 20 - 20 - 20 - 20 - 20 - 20 - 20 - tCS CRC word ...interlock time
0 150 0 150 0 150 0 100 0 100 0 75 0 60
tAZ Maximum time allowed for output drivers to pause time
160 - 125 - 100 - 100 - 100 - 85 - 85 - tIO-
tACK Hold time...
Specifications - Page 49
... - 50 - 50 - tIORDYZ Maximum time before
- 20 - 20 - 20 - 20 - 20 - 20 - 20
releasing IORDY
Deskstar 7K80 Hard Disk Drive Specification 45 device
tCH
CRC word hold time at
15 - 10 - 7 - 7 - 5 - 5 - 5 -
6.8.4 Device...
tAZ
Maximum time allowed for - 10 - 10 - 10 - 10 - 10 - 10 - 10
output drivers to release
tZAH Maximum delay time
20 - 20 - 20 - 20 - 20 - 20 - 20 - tSS tLI tLI...
Specifications - Page 54
...host's I/O space.
Table 39: I / O address map. Cylinder high Reg.
01
1 1 0 Drive/Head Reg.
is shown as a shorter cable, bus termination, or a shielded cable. The following table ...Sector number Reg.
Deskstar 7K80 Hard Disk Drive Specification 50 Data Reg.
01
0 0 1 Error Reg. Command Reg. For systems operating with Ultra DMA mode 3, 4, and 5, 80-conductor ATA cable ...
Specifications - Page 58
...
7.1.4 Jumper positions
7.1.4.1 16 logical head default (normal use ) • 15 logical head default • 32 GB clip • Power up in standby Within each of these four jumper settings the pin assignment selects Device 0, Device...F
D
B
DEVICE 0 (Master)
DEVICE 1 (Slave)
CABLE SEL
DEVICE 1 (Slave) Present Shipping Default Condition (DEVICE 0)
Deskstar 7K80 Hard Disk Drive Specification 54
Specifications - Page 60
...I
G
E
C
A
H
F
D
B
I
G
E
C
A
H
F
D
B
I GECA HFDB
DEVICE 1 (Slave) Present
Deskstar 7K80 Hard Disk Drive Specification 56 Table 40: Jumper positions for Disabling Auto Spin
I GECA HFDB
DEVICE 0 (Master)
I GECA HFDB
DEVICE 1 (Slave)
I GECA..., or Device1 (Slave) Present while setting the drive capacity down to 32 GB for the purpose of compatibility.
The CHS is unchanged...
Specifications - Page 63
Deskstar 7K80 Hard Disk Drive Specification 59 There is no special power on -op era tin g
3 1 'C /9 0 %
3 6 'C /9 5 % W e tB u ib = 3 5 .0 'C
W e tB u ib = 2 9 .4 'C
O p e ra tin g
5 5 'C /1 5 %
6 5 'C /1 4 %
-3 5
-2 5
-1 5
-5
5
15
25
35
45
55
65
T em p era tu re ('C )
Note: Storage temperature range is 0° to 65°.
7.2.2 Corrosion test
The drive shows no hot plug/...
Specifications - Page 64
... the ground of the drive, the drive must remain within the above regulation tolerance. A common supply with the performance of the drive power connector.
Deskstar 7K80 Hard Disk Drive Specification 60 RMS) Idle...100
0-10
+12 V dc
150
0-10
During drive start up and seeking 12-volt ripple is a more desirable method of 40 GB and 80 GB models(PATA) (values in a user system frame which...
Specifications - Page 65
... 1014 bits read ECC On The Fly correction
• 1 Symbol : 10 bits • 1 Interleave • 36 ECCs are required for the command to HDD. Deskstar 7K80 Hard Disk Drive Specification 61 however, the BIOS time out value needs to be in the allowable level specified in the power requirement section.
7.4.3 Start/stop cycles
The...
Specifications - Page 72
... 0.4 / (average seek time + dwell time)
7.8 Identification labels
The following table. or Hitachi Global Storage Technologies approved equivalent.
• A label containing the drive model number, the manufacturing date code, the formatted capacity, the place of the actuator with other labels
Deskstar 7K80 Hard Disk Drive Specification 68 The sound power emission levels are measured in the...
Specifications - Page 73
...CFC
materials.
7.9.6 Secondary circuit protection
Spindle/VCM driver module includes 12 V over current protection circuit
Deskstar 7K80 Hard Disk Drive Specification 69 An environmental impact assessment has been ...rating of the international treaty on the manufacturing process used to the Protocol Hitachi Global Storage Technologies requires the following:
• that no packaging used to...
Specifications - Page 100
... for protected area (LBA > = 12,289,536 (BB8600h)) if required. Deskstar 7K80 Hard Disk Drive Specification 96 The following example uses hypothetical values.
Make the entire device accessible, ...in the same manner as a 6.2 GB device, any BIOS, device driver, or application software will access the drive as follows:
i. Shipping of drives from the manufacturer, the device has been...
Similar Questions
Driver Needed For Hitachi 5400 Rpm Sata 100 Gb Hard Drive
(Posted by jfl09426 11 years ago)
I Need Driver
i can not give format,because i dont have driver hdd
i can not give format,because i dont have driver hdd
(Posted by blancaelizabeth8 11 years ago)
Hitachi Hds728080plat20
my hard drive says it only has 31 gb and its a 80 gb
my hard drive says it only has 31 gb and its a 80 gb
(Posted by leroykulp 12 years ago)
Need Driver For New Install Of Hitachi Hts721010g9at00 Hard Drive On Dell M170
Replacemant hard drive is not recohnized. Is there a driver available, and can I use a USB drive to ...
Replacemant hard drive is not recohnized. Is there a driver available, and can I use a USB drive to ...
(Posted by Anonymous-32140 12 years ago)