Home » Hitachi » Projection Televisions » Hitachi 60VG825

Hitachi 60VG825 Support Question

Find answers below for this question about Hitachi 60VG825 - 60" Rear Projection TV.
Need a Hitachi 60VG825 manual? We have 1 online manual for this item!

Hitachi Overview Questions Manuals Reviews Videos Research

Question posted by jimd56629 on October 27th, 2015

Power/picture Issues

I have a Hitachi 60VG825, that when I power it up the following occurs. Blue Power light comes on, I hear a fan start up. Then a RED Temp light and a RED Lamp light start flashing. No picture or sound at all.Where should I be looking at here?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on December 6th, 2015 3:37 AM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,813

1,100
points

Go here http://support.rm.com/technicalarticle.asp?cref=tec484108 for a solution.

Check if there is no blockage on the air passage aperture.
Check if the air filter is not dirty.
Check if the peripheral temperature does not exceed 35C.

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Hitachi 60VG825 Manual Pages

Owners Guide - Page 1

LCD REAR PROJECTION TELEVISION Operating Guide for energy efficiency. has determined that this product meets the Energy Star® guidelines for 50VG825, 55VG825, 60VG825 IMPORTANT SAFETY INSTRUCTIONS 2-3 FIRST TIME USE ...4-20 THE REMOTE CONTROL ...21-38 ON-SCREEN DISPLAY ...39-88 LAMP REPLACEMENT ...88-91 USEFUL INFORMATION...92-97 LICENSE AGREEMENT...98 APPENDIXES ...99-100 INDEX...

Owners Guide - Page 2

..., shelf or ceiling mounting as practical. Important Safety Instructions SAFETY POINTS YOU SHOULD KNOW ABOUT type plug has two blades and a third grounding YOUR HITACHI LCD REAR PROJECTION prong. Follow all servicing to the grounding 2 grounding-type plug. to the CATV system installer: This reminder is intended to alert the user to the presence...

Owners Guide - Page 5

... antenna may hear a "pop" sound when the lamp "goes out." If you hear the cooling fan, it should not be sure that is free from the fan is seen by...picture is normal and may appear on a flat surface. After extended use How to set up your new HITACHI Projection Television ANTENNA Unless your LCD Rear PTV against a wall, keep it at least 10cm (4 inches) from the side of the TV...

Owners Guide - Page 7

POWER BUTTON (TV, DVD, CBL, STB, PVR/VCR, AMP/CD) Turns the selected device on the wheel to adjust the audio level of your TV. ASPECT BUTTON (TV) Changes the aspect ratio of your HITACHI LCD Rear Projection TV, the new remote control is displayed. VOLUME WHEEL (TV, AMP/CD) Scroll up or down to mute. PIP CONTROL BUTTONS (TV) Press...

Owners Guide - Page 9

...) (TV CAN ACCEPT REMOTE CONTROL AND SIDE BUTTONS) 2. POWER TEMP LAMP 3. If this indicator is warming up. Consult your Hitachi dealer for lamp replacement procedure. Please make sure the Blue Power light indicator is not lit (OFF) when you do not watch the LCD Rear Projection Television for longer lamp life. ¹ PHOTO INPUT Insert USB cable from your digital still pictures (see...

Owners Guide - Page 19

... the external components you can use Connecting External Video Sources Your HITACHI LCD Rear Projection Television is setup, it allows your IR Mouse connector to control your equipment using your HITACHI LCD Rear PTV Remote Control. ACCESS THE AV NET SETUP WIZARD Press the MENU button. 5. Follow the Setup procedure on pages 76-83. This feature helps...

Owners Guide - Page 20

... use Connecting External Video Sources Your HITACHI LCD Rear Projection Television is necessary for the TV Guide On ScreenTM system to work . 20 Please see the following example of the Rear Panel. 3. Patent Nos. 4,631,603; 4,577,216; 4,819,098; 4,907,093; and 6,381,747 licensed for the AV Network to select. 7. Follow the Setup procedure on pages...

Owners Guide - Page 21

... operate your LCD Rear Projection TV, point the remote control at the remote sensor of the television and select the TV by pressing the ...HITACHI LCD Rear Projection TV, the new remote control is pressed. A/V NET / To operate your audio equipment (see page 33 for instructions on the remote. The AMP mode indicator will blink, indicating that the remote will light for 10 seconds. The TV...

Owners Guide - Page 31

...flash 3 times if the ቢ code was accepted. ባ 5. When this occurs..., the remote control is ባ programmed for your cable box (refer to instruction manual of the Cable Box for operation of your cable box. ቢ This remote is entered. MY CABLE BOX CODE IS: NOTE: Refer to pages 37-38 for operating the TV...4707; EXCLUSIVE TV buttons These ... light to operate ...

Owners Guide - Page 32

...- When this occurs, the remote ...topbox/satellite receiver. NOTE: 1. The remote control will ባ flash 3 times if the code was accepted. 5. To switch to...3. If the set -top-box/satellite receiver and press the POWER button. In the unlikely event that matches your set -top-...indicator light will remember the codes you have programmed until the batteries are for operating the TV. 32...

Owners Guide - Page 33

... your DVD player. ቢ 2. Turn ON your DVD player. ባ 3. The indicator light will now control your DVD player. 7. NOTE: 1. If your DVD player cannot be operated ...DVD player and press the POWER button. To switch to pages 37-38 for your DVD player operating guide. 3. When this occurs, the remote control is programmed for operating the TV. 33 In the unlikely...

Owners Guide - Page 34

...your VCR/PVR operating guide. 3. The remote will flash 3 times if ቢ the code was accepted... has not been precoded into the remote. 2. The indicator light will now control your VCR/PVR. If the VCR/PVR does...the VCR/PVR and press the ባ POWER button. If your VCR/PVR cannot be ...the batteries are for operating the TV. 34 When this occurs, the remote control is programmed for...

Owners Guide - Page 35

...ባ component. ቢ 3. The indicator light will remember the codes you wish to ባ...at the Audio component and press the POWER button. If your Audio component cannot...TV Buttons These buttons are removed from the from the remote control. Release the ENT button. When this occurs... into the remote. 2. The remote control will flash 3 times if the code was accepted. 5. ...

Owners Guide - Page 39

Press EXIT on the remote control to select. 3. Press the SELECT button to quickly exit from a menu. Lamp Temp Power On-Screen Display 39 Press MENU on your HITACHI LCD Rear Projection TV. 2. Press the CURSOR buttons to display the different features on the remote control to navigate and highlight a different feature of the On-Screen Display menu...

Owners Guide - Page 42

...with more blue, set ...TV experiences picture blocking. Black Enhancement Use this function to enhance Picture brightness in the level of 30 frames or 60...picture quality when using the settings off, low, middle and high. If CONTRAST is turned ON from the VIDEO menu, your Hitachi LCD Rear Projection Television...pictures per second, instead of Black and set to Black/White for more in light...

Owners Guide - Page 44

...hearing system, SRS technology delivers and exciting and realistic 3D Sound experience from just two external speakers (or) the two internal speakers of your HITACHI television...more complete and accurate reproduction of the Projection TV internal speakers. Balance This function will ... Audio Audio Select AUDIO to adjust the TV to your HITACHI television is connected to an external audio system,...

Owners Guide - Page 85

... Select AUDIO OUT FIXED to previous menu. Video Out Monitor Monitor Audio Out Fixed Variable TV Tuner Out Fixed Use To record currently viewed Video and Audio. Press EXIT to quit ...Saver Set The Inputs Set AV NET Set Closed Captions Set Monitor Out Upgrades Set Stand-by the LCD Rear Projection TV Volume Up/Down. You can be available (grayed out). 2. NOTE: 1. Setup Set Monitor Out ...

Owners Guide - Page 88

... lamp securely, otherwise the picture may become dark or it dirty which can cause injury. Turning on . To avoid injury, please observe the following precautions. • Do not open lamp compartment or attempt to cool for a new lamp unit. A "LAMP" indicator will not come on and off and A.C. If "LAMP" indicator is being replaced. • Unplug the product's power...

Owners Guide - Page 91

... will flash (see page 9). 7. Plug power cord into AC outlet and turn on , otherwise it may cause unusual colors. For lamp recycling and disposal information, go to install the lamp cover by re-engaging the two clips and tighten the screws before the Lamp Cover is connected before turning the power on the main power switch. 120V Lamp Temp Power...

Owners Guide - Page 92

... control in memory. Wait 30 seconds and plug the power cord back in a distorted picture.. Do not clean your HITACHI LCD Rear Projection Television. 92 Do not touch the screen too often. Excessive... dirty. IF YOUR TELEVISION SHOULD APPEAR TO HAVE A LOSS OF POWER, PLEASE FOLLOW THIS PROCEDURE: 1. A mild soap may cause the screen to external or internal voltage power surges. Replace the ...