Hayward TigerShark Support Question
Hayward TigerShark Support Question
Find answers below for this question about Hayward TigerShark.Need a Hayward TigerShark manual? We have 2 online manuals for this item!
Question posted by vicera on March 9th, 2014
New Tigershark Qc Will Not Stop Or Reverse At Waterline.
Installed Restrictor Plate and Insert with no change. Just keeps churning away until it eventually falls backward. Hayward sent me yet another restrictor, (A flat washer and screw but no instructions of where it goes or how to install it?)
Current Answers
Related Hayward TigerShark Manual Pages
All Models - Page 1
... or fax to 561-688-0217 or register on the web at www.aquavacsystems.com
Serial TigerShark (Located inside filter area)
Registration of Warranty This registration card must be mailed within 10 days of my pool surface is___________x__________ Surface is Have you seen us on the internet? Name Address City State___________Zip Date...
All Models - Page 3
...instructions, Aqua Vac Pool Cleaners, Inc., at its sole option, may at its sole option and own expense, replace the Tigershark or any warranted part, with another new...the unit will be sent back to comply with your prior approval of the cleaner. MODEL TigerShark TigerShark 2 TigerShark 2 Plus TigerShark Plus TigerShark QC
WARRANTY PERIOD 1 - Year 3 - INSTRUCTIONS TO OBTAIN WARRANTY REPAIR...
All Models - Page 5
... Information 6 General Operating Instructions....6 TigerShark QC, Plus and 2 Plus Operating Instructions 8 Remote Control Trouble Shooting.. 9 Machine Assembly/Parts............10 Maintenance 11 Trouble Shooting 12 Specifications 13 Figures 14-17 Safety Precautions 18 Preventative Maintenance.........19 Parts Ordering Instructions........19
The World's Best Pool Cleaners For More Than...
All Models - Page 6
... or vinyl liner in combination with, age, incorrect pool water chemistry, improper installation, and other factors. Customer hereby disclaims any and all instructions carefully before putting your purchase of the swimming pool and the power supply is much easier with the TigerShark using the figure on page 10. Just drop it in design, performance, and quality...
All Models - Page 7
... it in additional service requirements.
7 Place the TigerShark in the pool may shut the TigerShark off after each use. Caution: DO NOT switch power supply ON when the TigerShark is cleaned in less time than 3 hrs, you may result in hand-over-hand - Keeping the TigerShark permanently in the pool. Connect the power supply to the GFCI...
All Models - Page 8
... can be operated at any time without disrupting the cleaning cycle.
3. For installation, setup and general operation information refer to the General Operating Instructions located on , and then the Full cycle can be chosen during the Quick Clean cycle. The TigerShark QC pool cleaner will automatically shut-off in 60 minutes. 3. In the Full Clean...
All Models - Page 9
...connection on the front of the power supply may be tripped. HAND HELD REMOTE CONTROL
Troubleshooting the remote control function
If the TigerShark Plus does not turn when the remote control is activated:
Be sure to avoid cleaner floating.
9 Manually work foot in and... supply should slide easily. For remote control units with debris. Turn cleaner off and remove from the pool.
All Models - Page 11
... will then circle the pool in TigerShark (Fig. i). Reverse handle position after each ...use , the cable may not remove the elements for any debris that no debris or hair has clogged the impeller. g). • Install... TigerShark on its side in lock position. • Filter cleaning solution can be used to fall ...
All Models - Page 12
..., Fig.
It may be helpful if unit becomes routinely stuck on a raised main drain. TROUBLESHOOTING
If TigerShark cannot climb pool walls:
• Clean the filter. If TigerShark starts working momentarily but then stops working:
• Impeller may go to "TigerShark Owners - Replace worn brushes (#12) to the bottom lid (page 10, Fig. j). • The sealed...
All Models - Page 13
...auto-shutoff. Self-Diagnostics
Electronic Power-On Self-Test w/Memory - Shipping Carton Dimensions Shipping Weight
Tigershark/TigerShark 2 Height 19 in. (48.3 cm) Width 19 in. (48.3 cm) Length 19...21 in. (53.3 cm) 19 in. (48.3 cm) 21 in different swimming pools and electrical supply outlets.
Waterproof Sealing
Double Redundant Radial Shaft Seals & 0-Rings. Filter Type...
All Models - Page 1
... hazards. Hayward Pool Products 620 Division Street, Elizabeth, NJ 07201
Phone: (908) 351.5400 www.haywardnet.com
The NOTICE label indicates special instructions that could...ISRC10202 Rev: C
TigerShark® SERIES
by
Owner's Manual
ROBOTIC POOL CLEANER
Models: TigerShark, TigerShark QC, TigerShark Plus, TigerShark2, TigerShark2 Plus
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions should...
All Models - Page 2
... ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 2 of a suction outlet cover resulting in this product. Limb Entrapment-
To reduce risk of pump and/or filter components. Suction Entrapment Hazard. Components such as the filtration system, pumps and heater must be inspected
frequently and replaced at
all instructions in mechanical entrapment. Before servicing pool and spa...
All Models - Page 3
... power supply.
The pump is defective. SAVE THESE INSTRUCTIONS
HAYWARD® Pool Products Limited Warranty
To original purchasers of swimming pool, spa, or hot tub. Parts that fail from defects in... its ' pool products and is required for a period of all
electrical equipment can shock, burn, and cause death or serious property damage. TigerShark Plus and TigerShark QC warranted for ...
All Models - Page 4
...NOT start cleaner out of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Place the cleaner power supply so that may stop in "OFF" position when unit completes cleaning....steps: 1. The length of the standard cleaner cable is at a minimum distance of the pool and reverse during cleaning cycle. In order to "On" position when unit is excessively dirty. 3....
All Models - Page 5
... for 240 volt models).
2.
b) to the off manually by pulling the cable until the TigerShark reaches the
surface. Keeping the TigerShark permanently in additional service requirements. Connect the floating cable (page 9, #2) to different components of the TigerShark.
1. Submersing by Hayward Pool Products.
4. The handle has two diagonal positions.
Then lift it in the...
All Models - Page 6
... into the bottom inlet, falls
off the wall rather than reversing back down, or has a tendency to lock in the pool and observe the waterline climbing height.
For a visual illustration of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Install the restrictor plate as shown in the same area of the restrictor plate. Restrictor insert may be corrected by...
All Models - Page 7
... without disrupting the cleaning cycle.
3. For installation, setup and general operation information refer to the desired turning function indicated in 90 minutes.
3. The TigerShark QC pool cleaner will resume its programmed operation.
To turn the cleaner while in operation depress and hold the button next to the General Operating Instructions (page 5). Page 7 of the Remote...
All Models - Page 10
...(like a telephone cord). Reverse handle position after each use...-wash the filter elements to fall out (page 14, Fig....Install bottom lid and slide latches into the TigerShark ...TigerShark will perform. Also, periodically stretching the cord out in the opposite diagonal position (page 13, Fig. f). • Wash the inside of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL...
All Models - Page 11
... calcium content, more frequent cleaning of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Put TigerShark in the maintenance section (page 10). • Brush rollers or drive tracks are fully dissolved before operating the unit. If TigerShark starts working momentarily but then stops working: • Impeller may be clogged or too...
All Models - Page 16
... Name Street Address City State___________ Zip Phone Number Purchase Date E-Mail Address Serial Number
Years Pool has been in a safe and convenient location for :
In Ground
Above Ground
Spa
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 16 of purchase/installation or register online.
DETACH HERE: Fill out bottom portion completely and mail within 10...
Similar Questions
Hayward Dv5000 Not Works And Then Stops Few Feet Later
Set up cleaner ok. Checked all parts linked correctly. Pump set up to run at correct pressure. The c...
Set up cleaner ok. Checked all parts linked correctly. Pump set up to run at correct pressure. The c...
(Posted by senciere1962 8 years ago)
Gets Stuck
I just got my Tigershark QC, and it keeps getting stuck near the ladder and shutting itself off. I h...
I just got my Tigershark QC, and it keeps getting stuck near the ladder and shutting itself off. I h...
(Posted by Chrishalloran64 9 years ago)
How Do I Know When I Need New Tracks On My Tiger Shark Pool Cleaner
(Posted by pilonewbi 10 years ago)
Tigershark Qc Wont Work
My tigershark qc is several years old and has several parts replaced. Recently we replaced the drive...
My tigershark qc is several years old and has several parts replaced. Recently we replaced the drive...
(Posted by trmayer62 11 years ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)