Hayward Pro Series Side-Mount Support Question
Hayward Pro Series Side-Mount Support Question
Find answers below for this question about Hayward Pro Series Side-Mount.Need a Hayward Pro Series Side-Mount manual? We have 3 online manuals for this item!
Question posted by kmm999 on April 24th, 2015
The Top Dome Closure Does Not Fit.
I recently purchased an S244s and the top dome closure does not fit. It will not properly seat into the opening. The top is approx an 1/8th of an inch too wide. I tried using silicone lube but it doesnt fit. I also tried using the supplied clamp ( as part of the S210PAK accessory PAK ) but since the top doesnt seat, the gap is too wide for both the top and the body to fit into the U groove of the clamp.
Current Answers
Related Hayward Pro Series Side-Mount Manual Pages
Models: S210S S244S - Page 1
...MANUAL
INSTALLATION, OPERATION & PARTS
IS210S-06 Rev B
MODELS S210S, S244S PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be followed, ...a potential hazard. This is the safety-alert symbol. SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207 Tel: 908-351-5400...
Models: S210S S244S - Page 2
...floor or wall), must be located on seating areas or on the equipment. Failure to remove pressure test plugs and/or plugs used as listed on Table 2. WARNING - Failure...Suction Entrapment Hazard. Limb Entrapment-
o Dual suction fittings shall not be in open filter manual air relief valve.
WARNING - Before servicing pool and spa water circulation system, all instructions in this owner...
Models: S210S S244S - Page 3
...WARNING -
Failure to bond pump to pool structure will produce clear, sparkling water with the two
openings in the side of the filter ...WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Also, contact a licensed electrician for information on a level concrete slab, very firm ground, or equivalent, as the permanent dirt removing media. Your Hayward Pro Series high-rate sand...
Models: S210S S244S - Page 4
...pool system, bypassing the filter. Page 4 of filter tank. Insert top closure dome (with pump off during winter.
2. Once water flow is steady out the waste line, run the pump for proper operation of two factors-adequate filtration and proper... flange clean. Make return to pool pipe connection to control valve opening marked PUMP according to help seat flange clamp.
Turn pump off pump...
Models: S210S S244S - Page 5
...
ABOVE INCH MM
50
3.45
18
460
18
460
50
3.45
18
460
18
460
MEDIA REQUIRED
TYPE
AMOUNT
FILTER
LBS
KG
SAND**
0.45-0.55mm 200
90
0.45-0.55mm 300
135
**Also known as No. 20 Silica Sand. Top Closure Dome Valve/tank o-ring Flange Clamp Filter Tank w/Base, S210S Filter Tank w/Base, S244S...
Models: S210S S244S - Page 6
... REGISTRATION
(Retain For Your Records)
DATE OF INSTALLATION
PURCHASED FROM
MODEL
SERIAL NUMBER
▲Retain this Warranty Certificate in intake line (...USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 6 of filter sand
3. for algae in intake and discharge lines.
3. POOL CHEMISTRY GUIDELINES
SUGGESTED POOL CHEMISTRY LEVELS
pH
7.2 to 7.6
ACTION REQUIRED TO CORRECT POOL...
Models: S210S S244S - Page 7
... information, contact Hayward customer service department.
To original purchasers of this equipment, Hayward Pool Products, Inc.
Hayward shall not be repaired or ...use , or care, shall be free from defects in service □ less than 1 □ 1-3 □ 3-5 □ 5-10
Address City State_________ Zip E-mail Address
Purchased from: Company name Address
Product Purchased...
Models: S210SV S244SV - Page 1
SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207 Tel: 908-351-5400 WWW.... severe injury and/or death. OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
IS210SV Rev B
MODELS S210SV, S244SV PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be alert to hazards.
Models: S210SV S244SV - Page 2
... fittings shall not be blocked by young children. o Never use Pool or Spa if...pool.
Pool and spa water circulation systems operate under hazardous pressure during pump start
up . A limb inserted into an opening of the pool/spa...air and water) is not assembled properly, damaged, or missing. Do not... in an increase potential for such seating areas. Body Suction Entrapment- Mechanical...
Models: S210SV S244SV - Page 3
...the filter tank, through the top opening of time, the accumulated dirt in...pool dealer. Do NOT ground to the top of the tank, up through your filter and piping system. Your Hayward Pro Series...recirculation of operation. Assemble pump and pump mounting base (if supplied) to the filter according...filter control valve to a gas supply line. Use no more than the recommended amount of 8
...
Models: S210SV S244SV - Page 4
...pool and make it may be sure all pipe connections are open), allowing the filter tank to help seat flange clamp. Connect pump to control valve opening... clean.
Insert top closure dome (with screwdriver handle to fill with water. Place clamp around dome flange and tank flange...properly sanitize your pool size and usage.
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Models: S210SV S244SV - Page 5
... Drain Cap Assy Cap Plug Filter Stand Support O-Ring (Large) (S210S) O-Ring (S244S) Bulkhead Fitting (S210S) Bulkhead Fitting (S244S) O-Ring Spacer (S244S) 2" Slide Control Valve O-Ring Pressure Gauge
NO. REQ
1 1 1 1 1 1 1 1 1 1 1 1
10 10 10 10
1 1 1 1 1 1 1 1 1 2 4 2
2 1 2 1
FIGURE B
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TABLE 1
PARTS Models S210SV, S244SV
REF NO...
Models: S210SV S244SV - Page 6
... to 3.0 ppm Add Chlorine Chemical No action -
WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS POOL WATER WON'T CLEAR UP
1.
Be sure chlorine and pH levels are...3" 160 [90] [600]
PRODUCT REGISTRATION
(Retain For Your Records)
DATE OF INSTALLATION
PURCHASED FROM
MODEL
SERIAL NUMBER
▲Retain this Warranty Certificate in intake and discharge lines.
3.
Models: S210SV S244SV - Page 7
... period, except as a result of freezing, negligence, improper installation, use , or care, shall be repaired or replaced, at our option, without charge, within 10 days of purchase/installation.
© Hayward Pool Products, Inc. 2006 All rights reserved.
To original purchasers of this equipment, Hayward Pool Products, Inc., 620 Division Street, Elizabeth, New Jersey, warrants its...
Model: S310S - Page 1
SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207... but not related to hazards.
OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
IS310S Rev B
MODELS S310S PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be followed, including the following signal words and be...
Model: S310S - Page 2
... potential for such seating areas. Strainer cover must be properly secured to the intestines through an unprotected suction outlet sump or suction outlet cover which relieves entrapping suction, is damaged, broken, cracked, missing, or not securely attached can result in this owner's manual and on Table 2. Do not operate pool and spa circulation system...
Model: S310S - Page 3
...pool water through the top opening of dirt, the control valve is time to clean (backwash) your pool...line. Assemble pump and pump mounting base (if supplied) to the filter according to ...provides for operation, service and winterizing. Use no more than the recommended amount of...Pro Series high-rate sand filter is loaded into the filter tank and functions as the permanent dirt removing media. The pool...
Model: S310S - Page 4
...closure dome (with water. Do not overtighten.
5. Connect pump to instructions. Make return to pool pipe connection to control valve opening marked PUMP according to control valve opening...minutes. To prevent damage to waste.
Also use for about 1/2 to filter. Start pump and...properly clean the pool water.
*NOTE: For new concrete or gunite pools, or where there is time to control valve seat...
Model: S310S - Page 5
... 13/16" O.D. Top Closure Dome Valve/tank o-ring Flange ...Filter Stand Support O-Ring Bulkhead Fitting O-Ring Spacer O-Ring Pressure... 10 10 1 1 1 1 1 1 1 4 2 2 2 1 1
FIGURE B
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 5 of 8
MODEL S310S
IS310S Rev B
MODEL NUMBER
S310S
EFFECTIVE
FILTRATION
AREA
...PSI BAR
REQUIRED CLEARANCE
SIDE INCH MM
ABOVE INCH MM
50
3.45
18...
Model: S310S - Page 6
...-
WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT...pool with water that has not been treated with Cyanuric Acid. Check skimmer and pump strainer baskets for longer periods. PROBLEM SOLVING LIST
REMEDY
LOW WATER FLOW
1. Check for algae in a safe and convenient location for restrictions in proper...PURCHASED FROM
MODEL
SERIAL NUMBER
▲Retain this Warranty Certificate in...
Similar Questions
Drive Error
pump has stalled, have tried every recommendation , stall message continue
pump has stalled, have tried every recommendation , stall message continue
(Posted by charlesstewart39 7 years ago)
Broken Bulkhead Fitting
my bulkhead fitting snapped off when i was changing o rings. How to remove and replace the internal ...
my bulkhead fitting snapped off when i was changing o rings. How to remove and replace the internal ...
(Posted by exitalabama 9 years ago)
Leaky Bulkhead Fitting On S244s Sand Filter
i have a leak i believe is coming from one of the bulkhead penetrations on my filter. is there a spe...
i have a leak i believe is coming from one of the bulkhead penetrations on my filter. is there a spe...
(Posted by exitalabama 9 years ago)
Open Dome Cover
It there a trick to opening the lid so I can clean the filters? I pressed and tried to lift up the d...
It there a trick to opening the lid so I can clean the filters? I pressed and tried to lift up the d...
(Posted by ssjones2000 10 years ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)