Haier RDE350AW Support Question
Haier RDE350AW Support Question
Find answers below for this question about Haier RDE350AW - 6.5 Cu. Ft. Electric Dryer.Need a Haier RDE350AW manual? We have 1 online manual for this item!
Question posted by jbgsgs on May 7th, 2013
Won't Go Off No Heat.
the dryer starts turning as soon as it is plugged in. no heat. can't turn it off even when the door is open. have to unplug it. disconnected the sequencer and it stopped. nearly new machine. i am an independent service tech.
Current Answers
Related Haier RDE350AW Manual Pages
User Manual - Page 2
... OF CONTENTS
PAGE IMPORTANT SAFETY INSTRUCTIONS 2-4 INSTALLATION INSTRUCTIONS 5-17 Tools and Materials Required 5 Electrical Requirements 5 Unpacking Your Dryer 6 Exhaust System Requirements 7 Gas Supply Requirements 9 Location of Your Dryer 10 Manufactured (Mobile) Home Instruction 11 Electrical Installation 12 3-Wire Cord Connections 13 4-Wire Cord Connections 14 Gas Connections 15...
User Manual - Page 3
... damage, personal injury or loss of all occupants. 4.
Do not use any phone in Canada, CSA C22.1 Canadian Electrical Code Part 1. Follow the gas supplier's instructions. 5. Installations must be stored near the dryer.
This dryer is being installed.
2
Combustible materials, gasoline, and other flammable vapors and liquids must conform with local codes and ordinances...
User Manual - Page 4
...11. Before the appliance is used near children.
4. Clean lint screen before ...be cleaned periodically by the manufacturers of fire, electric shock, or injury to the weather.
7.... door to eliminate static unless recommended by the manufacturers of the dryer.
14. Do not use heat to... controls.
8. Keep area around the exhaust opening and adjacent surrounding areas free from items that...
User Manual - Page 5
... number Serial number Date of your old dryer, take off the door so that children may contribute to a chemical reaction than could cause a load to obtain warranty service.
4 SAVE THESE INSTRUCTIONS
DANGER
Risk of the dryer. Use the dryer only for using our Haier product. Always disconnect dryer from electrical supply before it should not used .
Do...
User Manual - Page 6
...Channel-lock adjustable pilers • 1/2-inch open end
5 ELECTRICAL REQUIREMENTS
Electric Dryer: (RDE350AW)
Circuit Individual 30 Amp branch circuit fused with 3 open -end wrench • Carpenter's level ...64258;exible metal 4 inch
(102cm) duct
• Vent hood
Safety Warning:
1. Before starting installation, make sure that the gas shut off position.
2. Use seperately fused circuits for ...
User Manual - Page 7
..., 30 Amp, with 4 open-end spade lug connectors with upturned ends or closed loop connectors and marked for more information on dryer)
Dryers being installed in the installed ...dryer is equipped with a three-prong grounding plug for your protection against shock hazard and should be plugged into a properly grounded three-prong receptacle. NEMA 14-30R receptacle)
ELECTRICAL REQUIREMENTS Gas Dryer...
User Manual - Page 8
... be exhausted into the laundry area. An accumulation of lint in a garage, it with the flow of air.
6. Plugging the system could create a fire hazard, as well as increase drying times.
4. Lint can create excessive drying times and fire hazards.
1. Explosion hazard: Do not install the dryer where gasoline or...
User Manual - Page 9
... Metal
90 ft. 60 ft. 45 ft. 35 ft.
Rigid Metal
60 ft. 45 ft. 35 ft. 25 ft.
of every 12 months with the appliance by the manufacturer shall be used the more the dryer is acceptable....exhaust duct diameter;
7. RECOMMENDED MAXIMUMM
Exhaust Hood Types
Recommended
Use only for Clothes Dryer Transition Duct, Subject 2158A (2006), shall be used .
6.
Certain extenuating ...
User Manual - Page 10
...or plasticcoated brass. 4. The tubing MUST be used to connect your dryer to the
gas supply line. A 1/8 inch (0.32cm) N.P.T. plugged tapping, accessible for test gauge connection, MUST be isolated from the gas... equal to the dryer. 6. If codes allow, flexible metal tubing may be 1/2 inch (1.27cm) pipe. 3. In Canada, an individual manual shut-off valve MUST be disconnected from the gas ...
User Manual - Page 11
... closet as the gas dryer. 4. English
LOCATION OF YOUR DRYER
Do Not Install Your Dryer: 1. A louvered door with curtains, thick carpet, or anything
that will come in the door is acceptable.
10 When installing the dryer in a closet with a door, a minimum of 120 square inches (774.2 square cm) of ventilation in contact with equivalent air openings for ventilation. 5.
User Manual - Page 12
English
MANUFACTURED (MOBILE) HOME INSTALLATION
1. Refer to the mobile home structure.
3. Follow the instructions supplied with no obstructions. When installing a gas dryer into a manufactured home, a provision must be made for other important venting requirements. 6. This provision is not applicable, with the termination securely fastened to previous sections ...
User Manual - Page 13
... system,or an equipment-groundingconductor must be properly grounded. ELECTRIC Dryer (RDE350AW) GROUNDING INSTRUCTIONS
This appliance must be run with a ...plug for your dryer. A UL approved strain relief must be plugged into a properly grounded three-prong receptacle. Gas dryers are equipped with a cord having an equipment-grounding conductor and a grounding plug. English
ELECTRICAL...
User Manual - Page 14
... of the dryer with two ...turn.
9. Green Ground Screw
Brass Terminal
Neutral Ground Wire
Terminal Block
Nut
Tighten Nut to the outer brass colored terminals on the back of the mounting bracket. Power cord, NEMA 10-30 Type SRDT, through the strain relief.
4. Reinstall the terminal block cover. Tighten both screws securely. English
ELECTRICAL CONNECTIONS
ELECTRIC Dryer (RDE350AW...
User Manual - Page 15
... bracket . Typical Conductor Receptacle
Typical 4 Conductor Cord
Black 240V White Neutral Red 240V
Green Ground
14 Finger tighten the nut only at this time.
3. English
ELECTRIC Dryer (RDE350AW)
4-Wire Cord Connections (US Models Only)
Green Ground Screw
Green Power Cord Ground Wire
Brass Terminal Terminal Block
Neutral Ground Wire
Black
Tighten Nut to...
User Manual - Page 16
... thread sealer that is clean and free from the dryer harness to ensure power is resting solid on all four legs. Open the shutoff valve in its final position, ...dryers, before the burner will light, it is turned on top of the dryer. NOTE: Follow instructons supplied with green ground screw.
6. Use a 1/2 inch to 3/8 inch (1.27cm to "OFF" and wait 5 minutes before plugging...
User Manual - Page 17
... inlet from twisting, please use a pipe wrench to gas inlet on dryer. D) To check gas inlet pressure, attach 1/8" NPT plugged tapping to plugged tapping. English
C) Make sure flexible gas line seal is secure. Then connect flare union adapter to dryer gas line shutoff valve. F) Open gas shut-off valve. 16
Then connect 3/8" flare union adapter...
User Manual - Page 19
....
Start/Pause Button (3)
• Push to start after the dry cycle is currently in the wrinkle saves mode. Cycle Progress: (4)
• This indicates the process the cycle is completed. To stop simply open the door and...To reduce the risk of fire, electric shock, or injury to persons, read all of the dry cycle the dryer will tumble periodically for 1 hour after pushing.
User Manual - Page 25
...After cleaning, slide the filter back in the room, electric voltage, length of the exhaust duct, etc.
The... of fabric and
moisture in it, heat and moisture in place. Do not
use for your dryer without the lint filter. English
NORMAL...your unit to dry on many variables: load size, type of the
dryer door. Remove any residue before drying next load. t$MFBOUIFDBCJOFUXJUINJME...
User Manual - Page 27
... Use warranty. 90 days labor from date of original purchase. 90 days parts from incorrect electrical current, voltage or supply. Adjustment of all attachments, accessories and disposable parts. Damage incurred in this warranty:
26 Haier America New York, NY 10018
What is granted in the owners manual.
Any transportation and shipping charges...
User Manual - Page 52
...FTUPVWFSUF
La sécheuse fonctionne mais ne sèche pas : t-FUBNCPVSFTUQFVUÐUSFUSPQQMFJO/FQBTSFNQMJSQMVTRVËNPJUJÏ t-FTUVZBVYEÏDIBQQFNFOUFUMFTDMBQFUTOFEPJWFOUQBTÐUSFPCTUSVÏT t-FUVZBVEÏDIBQQFNFOUEPJUÐUSFOFUUPZÏSÏHVMJÒSFNFOU...
Similar Questions
Heating Element On Haier Dryer 2.6 Cu.ft
My dryer does not blow warm enough. When I put it at the higher setting it does not blow any hotterD...
My dryer does not blow warm enough. When I put it at the higher setting it does not blow any hotterD...
(Posted by mkgil 3 years ago)
How To Reset The Haier Portable 2.6 Cu Ft Dryer
(Posted by lafuz 9 years ago)
Haier Electric Dryer Will Not Start
(Posted by Garryha 9 years ago)
How To Install Heating Element In Haier Electric Dryer
(Posted by reharayche 10 years ago)
Heating Element
where is the heating element located in the HAIER RDE350AW electricv Dryer
where is the heating element located in the HAIER RDE350AW electricv Dryer
(Posted by MoniqueThomas1 11 years ago)