Graco 1757845 Support Question
Graco 1757845 Support Question
Find answers below for this question about Graco 1757845 - Comfort Sport - Marissa.Need a Graco 1757845 manual? We have 1 online manual for this item!
Question posted by Debdifferding on October 14th, 2017
How To Assemble Buckle To Straps
how do you assemble the straps to the safety buckle in the infant sea
Current Answers
Answer #1: Posted by BusterDoogen on October 14th, 2017 12:33 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Go here for the buckle latch procedure.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Graco 1757845 Manual Pages
Instruction Manual - Page 2
...Toddler Child Restraint • ComfortSport Overhead Shield Newborn/Toddler
Child Restraint
Operations and Adjustments 18
• Harness Straps • Harness Tie • Buckle • Recline / Upright Positions
Instructions for these models are the same unless otherwise noted.
• 5-Point Crotch Strap... With
Vehicle Seat Belts 12
Forward-facing Installation With
Vehicle Seat Belts 14...
Instruction Manual - Page 5
...result in injury or ejection.
• Too upright can cause unseen damage and using vehicle seat belt to one vehicle lower anchor point unless specifically allowed by Graco. DO NOT use could ...manufacturer.
3 DO NOT remove LATCH system from child restraint.
Insert the harness straps in harness straps and suffocate or strangle. A crash can result in a crash, it again could alter the...
Instruction Manual - Page 8
... Points
(Fig. As a manufacturer, we do not recommend using the LATCH system in a seating Top Tether
position recommended
Anchor
by vehicle manufacturer.
a). LATCH SYSTEM
LATCH System:
LATCH consists of a permanently attached lower anchorage belt and a top tether strap (Fig.
a) 6
Child Restraint Lower Anchorage
Belt Vehicle
ONLY use LATCH in the center position...
Instruction Manual - Page 9
... children should use car seat forward-facing only if child is certified for use rear-facing.
• Toddlers 30 to 40 lbs. (13.6 to 18 kg) and up to 13.6 kg) who weigh less than 20 lbs. (9 kg) MUST be rear-facing.
• Infants or toddlers 20 to 30 lbs. (9 to fit comfortably rear-facing. IMPORTANT...
Instruction Manual - Page 12
... center of child restraint (fig. d).
10 If it does not stay tight, try another seating position or contact Customer Service (see back cover).
7
Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to vehicle lower anchors
(fig.
c)....
FORWARD-FACING INSTALLATION WITH LATCH
1 LATCH belt must be twisted.
2 Adjust car seat to upright position (see fig.
Instruction Manual - Page 14
...car seat to
compress vehicle seat cushion while tightening vehicle seat belt (fig. If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is securely installed and properly leveled; REAR-FACING INSTALLATION WITH VEHICLE SEAT... slack by attaching to connectors
through openings and
buckle belt.
5 Pull front to back and left to right to storage bar ...
Instruction Manual - Page 16
...Buckle belt (fig. c).
4 Press down in center of child restraint (fig. FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS
WARNING
LATCH belt MUST be stored when using vehicle seat...Seat Belts" page 26.
1 Store LATCH belt by pulling adjustment belt.
2 Adjust car seat to
compress vehicle seat cushion while tightening vehicle seat...seat pad flap (available on vehicle seat.
6 Attach tether strap ...
Instruction Manual - Page 18
... not allow any slack. Check that does not interfere with buckling the harness. Be sure towels do not interfere with child's back flat
against back of child restraint.
2 Place harness straps over 30 lbs. (13.6 kg).
16
5-Point Models Only: • Crotch strap must be placed under child. It lies in a relatively straight...
Instruction Manual - Page 20
... locked by pulling out on tongues to be sure it is facing away from crotch strap loop.
• From top of child restraint, re-attach clip to child. b). Harness straps MUST move freely. Overhead Shield Models
• To buckle: Push tongue into child restraint (fig. MUST use Upright position
Upright Position: Rotate stand...
Instruction Manual - Page 22
... first, then attach Top left strap loop. D Re-attach harness strap loops to remove seat pad from Splitter Plate on Splitter Plate first, then attach left strap loop. NOTE: Make sure ends of straps are threaded through matching slot of child restraint.
e):
• For Infants or Small Toddlers:
Put Top right strap loop on Splitter Plate first, then...
Instruction Manual - Page 30
... have an Emergency Locking Retractor which may be used with a child restraint. 28
Retractor VEHICLE SEAT BELTS (continued)
c Lap Belts - Remember, when installing a child restraint, pull belt all...may slip and loosen after being buckled on child restraint if positioned at a certain angle. If this works. Allow belt to another seating position. Manually Adjustable
The locking ...
Instruction Manual - Page 32
... converted into an "automatic locking mode" that will allow use without a locking clip. Test installation again to another seating position.
30
Pull (fig. b) If not, move child restraint to see Pg. 31 "Locking Clip" section). a).
b) and re-buckle.
c Combination Lap/Shoulder Belt with Locking Latch Plate
The locking latch plate on some...
Instruction Manual - Page 33
... and remove locking clip.
• Shorten length of lap belt portion slightly by pulling belt through latch plate.
• Re-attach locking clip.
• Buckle vehicle seat belt.
If not secure, repeat above step until secure. You MUST use locking clip provided with child restraint with child restraint.
• DO NOT use...
Instruction Manual - Page 34
... with tether anchors.
For storage of tether hook:
• Attach tether hook to back of child restraint as shown.
• Pull loose end of adjustment strap to remove any slack.
• Roll loose end of Child Restraint
32
Tether hook must be attached to the vehicle when using child restraint rear...
Instruction Manual - Page 36
WARNING
To prevent ejection in between harness straps and fit into seat exactly as shown. ADDITIONAL INFORMATION (continued)
c Body Pillow (available on some models)
Push top of body pillow in sudden stop or crash:
• Make sure that the harness system is properly secured and shoulder straps are threaded through slots and properly positioned...
Instruction Manual - Page 37
To prevent ejection in center of car seat with the harness. Position Head Support in a sudden stop or crash:
• Use proper harness strap
shoulder slots.
• Keep harness straps positioned
on some models)
WARNING
For use strap covers,
blankets, cushions, or padding under harness straps or child unless provided by Graco.
ADDITIONAL INFORMATION (continued)
c Head Support...
Instruction Manual - Page 38
Unsnap the sides and resnap them with the harness straps threaded through slots and properly positionned on some models) WARNING
To prevent ejection in sudden stop or crash: • shoulder straps must be threaded through the slots in the cushion. 36
ADDITIONAL INFORMATION (continued)
c Head Support (available on shoulders.
Instruction Manual - Page 39
Harness Covers
37
ADDITIONAL INFORMATION (continued)
c Harness Covers (available on some models)
WARNING
• Make sure the harness system is properly secured. • Check that harness straps are not twisted. • Make sure that harness covers do not interfere with placement of the chest clip.
Instruction Manual - Page 40
.... Reverse above steps for replacing seat pad,
overhead shield pad and harness system.
3
38 Removing Overhead Shield Pad:
3 Pull both harness strap loops from child restraint shell.
...2 Pull three 2-button clips out of lower front
edge of child restraint shell and inside center
2
of pad. Open harness tie,
release tongues from buckle. (...
Instruction Manual - Page 41
...Surface wash only with mild solution of soap and water. If harness straps or belt are frayed or heavily soiled, they can weaken plastic.
Contact... same way it is installed in a vehicle when using a vehicle seat belt. Machine-wash separately on forward-facing aircraft seats. Avoid wetting labels.
Never lubricate buckle.
39
c Second Hand Child Restraint
Graco Children's Products Inc.
Never...
Similar Questions
Missing 3 1/4' Bolt To Complete Assembly
I am missing a 3 1/4 inch bolt to complete assembly of the Graco convertible crib. Baby is due in 3 ...
I am missing a 3 1/4 inch bolt to complete assembly of the Graco convertible crib. Baby is due in 3 ...
(Posted by esqjackiemark 9 years ago)
How To Adjust The Shoulder Straps Up On The Graco 8j00mtx?
How do I adjust the shoulder straps up on the graco 8j00mtx?
How do I adjust the shoulder straps up on the graco 8j00mtx?
(Posted by nishiaklein 11 years ago)
Graco Snugride Carseat Base Model 1750726
How can i order more bases for the Graco Snugride carseat?
How can i order more bases for the Graco Snugride carseat?
(Posted by hannahures 12 years ago)
How Do I Get A Manual To Snugride Model #8402l04 For The Strap System On Thesea
(Posted by babyz 12 years ago)
Harness Straps In The Back Of The Seat Model #1750726
the harness straps in the back of the carseat are hooked onto a clamp - do they stay in that positi...
the harness straps in the back of the carseat are hooked onto a clamp - do they stay in that positi...
(Posted by ankafan2 13 years ago)