GE WSLP1500JWW Support Question
GE WSLP1500JWW Support Question
Find answers below for this question about GE WSLP1500JWW.Need a GE WSLP1500JWW manual? We have 3 online manuals for this item!
Question posted by Shambee76 on May 17th, 2015
What Does The Ff Code Mean
My washer keeps stopping mid cycle with the error code FF what does that mean and do I need to have my washer checked out by a repair man.
Current Answers
Related GE WSLP1500JWW Manual Pages
Installation Instructions - Page 1
... Features 4
Installation Instructions
Alcove or Closet Installation 12 Electrical Requirements 10 Grounding Instructions 10 Installation Requirements 9 Leveling the Washer 10 Washer Connections for Portable Model 13-16 Washer Connections for Stationary Model 11, 12
Troubleshooting Tips
Before You Call For Service . . . . . 17-20 Status Indicators 17
Consumer Support
Consumer Support Back...
Installation Instructions - Page 2
...INSTALLATION
This washer must be explosive under these circumstances. Do not allow any appliance. WARNING!
If the hot water has not been used by turning on all governing codes and ordinances... more , prevent the possibility of life.
YOUR LAUNDRY AREA
■ Keep the area underneath and around your safety, the information in this washer are not meant to the hot water system. WATER...
Installation Instructions - Page 3
...
around your washer or dryer during operation.
■ The laundry process can ...the washer at the building's
■ Do not mix chlorine bleach with controls. Check ...stopped
unplug this appliance if it
■ Do not tamper with ammonia or acids such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.) which may ignite or
■ Never attempt to repair...
Installation Instructions - Page 4
... the wall of the filter and pull out. To remove: Press the tab at
the proper time during the cycle. Cleaning the Detergent and Fabric Softener Dispenser Drawer
1. If necessary use a soft cloth to the dispenser. Installation... filter with water. It may stain them. Operating Instructions Safety Instructions
Special washer features.
Before starting the washer: • Load the laundry in .
Installation Instructions - Page 5
... the dispenser drawer. MINUTES REMAINING
TEMP
LOAD
LOCK
HOLD 3 SECS TO LOCK/UNLOCK
CONTROLS
OPTIONS
ULTRA CLEAN
LOAD SENSING COLORS WHITES
DELICATES SPEED WASH
CUSTOM CYCLE
START
PAUSE
POWER
CYCLES
D1EtoL1A8YHWOUARSSH
Before starting the washer: • Load the laundry in the washer. • Add the detergent and fabric softener to include are lit.
Installation Instructions - Page 6
...washer basket.
4 WASH CYCLE
These wash cycles control the length of water temperature, load size, and wash options saved for the wash and rinse cycles. When a cycle is complete the control panel will help match the WASH CYCLE.... NOTE: When the cycle is selected, the automatic temperature that are needed quickly.
WARM / COLD...laundry needs.
It will also display Status Indicators.
Installation Instructions - Page 7
... cover the clothes. Long Vacations: Be sure water supply is a common cause of holes in the display.
Loading the Washer
Load dry items loosely, no higher than the top row of laundry problems.
Use less detergent if you set the load/water level high enough to allow moisture to move freely. Safety...
Installation Instructions - Page 8
Operating Instructions Safety Instructions
Loading and using the washer.
WASH LABELS
Machine wash cycle
Normal Permanent Press/ wrinkle resistant
Gentle/ delicate
Hand wash Do not wash
Do not wring
Water temperature
Hot (50°C/120°F)
Warm (40°C/...
Installation Instructions - Page 9
... (faucets) should not be supplied with local codes and ordinances and the latest edition of the installer. • Product failure due to the weather. TOOLS REQUIRED
Pliers
9 The standpipe must be 11⁄2" minimum inside diameter and must be open to minimize vibration during spin cycles.
Keep these instructions
for future reference. •...
Installation Instructions - Page 10
... current. If the electric supply provided does not meet the above requirements, call a licensed electrician. LEVELING THE WASHER- In the event of a malfunction or breakdown, grounding will automatically level itself. Check with all local codes and ordinances. or 20-amp circuit breaker or time-delay fuse.
This appliance is equipped with this appliance...
Installation Instructions - Page 11
... a siphoning action could occur. Turn the water on the end of the drain hose with pliers.
Cable Tie Laundry Tub
3 CAREFULLY MOVE THE WASHER TO ITS FINAL LOCATION
Cable Tie Stand Pipe
Cable Tie
5 PLUG THE POWER CORD INTO A GROUNDED OUTLET
Insure ... up the water valve screens.
4 CONNECT DRAIN HOSE
Form a U shape on and check for leaks. There must be an air gap around the drain hose.
Installation Instructions - Page 12
...; The unit is level. ❏ The drain hose is properly tied up. ❏ There are no leaks at the faucet, drain line
or washer.
7 RUN THE WASHER THROUGH A COMPLETE CYCLE
Check for installation and servicing.
60 sq. NOTE: The clearances stated on this label are minimums. Consideration must be louvered or otherwise ventilated and...
Installation Instructions - Page 13
...the plastic cap from the HOT water inlet for kinks or binding of the hose. Make sure the washer is in place. Inspect for uni-coupler connections as leakage may occur. Plastic Cap
2 CONNECT TO WATER... the locking collar while lifting up on the drain hose and tighten to prevent leakage of the washer. Locking Collar
5 CONNECT DRAIN HOSE
Attach the drain hose to the COLD water valve inlet (...
Installation Instructions - Page 14
Installation Instructions
WASHER CONNECTIONS FOR PORTABLE MODEL WSLP1500- Insure proper ground exists before use
14
ONE-FAUCET ...PRONG GROUNDED OUTLET
The electrical power cord is on the back of the washer.
10 INSTALLATION CHECKLIST
Before starting the washer, check to make sure: ❏ Main power is turned on. ❏ The washer is plugged in. ❏ The water faucets are turned on.
&#...
Installation Instructions - Page 15
...
2 UNPLUG POWER CORD AND RETURN IT TO THE STORAGE AREA
Hose Connector
5 DRAIN WATER
Drain water from the faucet adapter.
Installation Instructions
TO DISCONNECT THE WASHER:
1 TURN WATER FAUCET OFF
4 DISCONNECT FROM WATER LINE
Move the locking collar down and pull the hose connector down to disengage from the hoses through...
Installation Instructions - Page 16
...washer can be connected to both the hot and cold water faucets. TO DISCONNECT THE WASHER:...faucets are no leaks at the faucet, drain line
or washer. TWO-FAUCET CONNECTIONS
If you have two separate water connections... INTO A 3-PRONG GROUNDED OUTLET
TO CONNECT THE WASHER:
1 CONNECT TO WATER LINE
Connect HOT and... power is turned on. ❏ The washer is properly tied up. ❏ There are turned...
Installation Instructions - Page 17
... open. Ub
■ Indicates the laundry load is not clogged or kinked.
ge.com
FF
■ Indicates washer failed to call service. dr
■ Indicates water has not drained from washer. OE
■ Indicates water has overflowed. Safety Instructions Operating Instructions
Installation Instructions
Before you may not need to fill. Check the drain hose connection.
Restart...
Installation Instructions - Page 18
... and remove the water connection hoses from the upper back of the washer.
Use less soap if you have soft water, a smaller load ...the water off or improperly connected
Water valve screens are stopped up
Water won't drain
House water heater is not ...8226; Measure your detergent carefully. they may need replacement after each use.
• Check condition of the drain hose is kinked or improperly ...
Quick Specs - Page 1
... grounding-type receptacle, protected by Underwriters Laboratories
Specification Revised 10/09
360429
WSLP1500JWW
Listed by a 15 or 20 amp circuit breaker or a time-delay fuse, is required. Wall outlet must be located behind dryer. WSLP1500J
GE Spacemaker® Portable Washer
Dimensions and Installation Information (in inches)
Circuit Requirements: An individual, properly-grounded...
Quick Specs - Page 3
...Washer
Dimensions and Installation Information (in inches)
Features and Benefits
• Electronic One-Touch Controls with LED Read-Out - It resists rust and won't chip, peel or snag
clothes • Model WSLP1500JWW - White
WSLP1500JWW...
• Five Water Levels - Simplify cycle selection and provide accurate cycle times
• One-Touch Loading Sensing - Eliminates guesswork and helps reduce ...
Similar Questions
Error Code En
at the end rinse cycle unit shuts down and the display shows EN unit would Beep and then shut down, ...
at the end rinse cycle unit shuts down and the display shows EN unit would Beep and then shut down, ...
(Posted by ramfromchag 8 years ago)
The Display Doesn't Read Anything And Won't Go Into Spin.water Drains But No Spi
(Posted by Anonymous-138739 9 years ago)
Why Does My Ge Profile Washer Model Gtwn4250dws Keeps Stopping
(Posted by tkc6895Tre 10 years ago)
Washer Stops Mid Cycle
Washer will stop mid cycle and the start/pause light will blink. I tried to enter test mode but cann...
Washer will stop mid cycle and the start/pause light will blink. I tried to enter test mode but cann...
(Posted by Vthokies97 12 years ago)