GE WSLP1500JWW Support Question
GE WSLP1500JWW Support Question
Find answers below for this question about GE WSLP1500JWW.Need a GE WSLP1500JWW manual? We have 3 online manuals for this item!
Question posted by ramfromchag on September 27th, 2015
Error Code En
at the end rinse cycle unit shuts down and the display shows EN unit would Beep and then shut down, what can cause to happen?
Current Answers
Answer #1: Posted by Odin on September 27th, 2015 9:57 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.youtube.com/watch?v=YBc2RGMlljE. If that doesn't solve, see http://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/50-3-862847-/GE-Washer-stops-mid-cycle-WSLP1500J0WW. Good luck!
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related GE WSLP1500JWW Manual Pages
Installation Instructions - Page 1
...Electrical Requirements 10 Grounding Instructions 10 Installation Requirements 9 Leveling the Washer 10 Washer Connections for Portable Model 13-16 Washer Connections for Stationary Model 11, 12
Troubleshooting Tips
Before You ... page 25
Lavadoras
Manual del propietario e instalación
La sección en español empieza en la página 49
Write the model and serial numbers here:
# ...
Installation Instructions - Page 2
... codes and ordinances. An open door could cause permanent damage and invalidate the warranty.
■ Properly ground washer to conform with or inside the washer.
■ Close supervision is necessary if this washer ...
IMPORTANT SAFETY INFORMATION.
WARNING! YOUR LAUNDRY AREA
■ Keep the area underneath and around your safety, the information in Installation Instructions.
Installation Instructions - Page 3
...your washer or dryer during operation.
■ The laundry process can...washer, or removing it is moving.
■ To minimize the possibility of electric shock,
Wait until the machine has completely stopped
unplug this appliance if it
■ Do not tamper with ammonia or acids such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.) which may cause...
Installation Instructions - Page 4
...fill any debris.
3. Pull out.
2. Rinse the drawer with a toothbrush.
Add measured ...remove: Press the tab at
the proper time during the cycle. Cleaning the Detergent and Fabric Softener Dispenser Drawer
1. Lint ...Installation Instructions
Consumer Support Troubleshooting Tips
4
Before starting the washer: • Load the laundry in . Clean the filter with water.
To Use ...
Installation Instructions - Page 5
...Installation Instructions
COLD HOT
WARM
EXTRA LARGE LARGE MEDIUM SMALL EXTRA SMALL
SOAK WASH
HEAVY DUTY
RINSE SPIN
EST. START PAUSE
To Use Automatic One-Touch Washing
The LOAD SENSING feature automatically...DELICATES SPEED WASH
CUSTOM CYCLE
START
PAUSE
POWER
CYCLES
D1EtoL1A8YHWOUARSSH
Before starting the washer: • Load the laundry in the cycle.
The COLORS indicator ...
Installation Instructions - Page 6
... to can be changed to start the wash cycle.
7 EST.
The chart below will also display Status Indicators. HOT / COLD
DELICATES For lingerie and delicate fabrics with light to your specific laundry needs.
WARM / COLD
5 TEMP WASH/RINSE
Select the water temperature for future uses. MINUTES REMAINING
Displays the time remaining in steps and slowly...
Installation Instructions - Page 7
...or too much detergent is a common cause of laundry problems.
Use less detergent if you want...rinse. (Do not use of holes in the display. Moving and Storage: Ask the service technician to the weather.
When loading wet items make sure you set the load/water level high enough to allow moisture to evaporate. GE recommends the use harsh or gritty cleaners.)
Fill Hoses: Hoses connecting washer...
Installation Instructions - Page 8
Operating Instructions Safety Instructions
Loading and using the washer. Fabric Care Labels
Below are fabric care label "symbols" that affect the clothing you will be laundering. WASH LABELS
Machine wash cycle
Normal Permanent Press/ wrinkle resistant
Gentle/ delicate
Hand wash Do not wash
Do not wring
Water temperature
Hot (50°C/120°...
Installation Instructions - Page 9
... responsibility of the National Electrical Code, ANSI/NFPA 70. maximum ...washer is selected.
• SHUT-OFF VALVES-Both hot and cold shut...cycles. Keep these instructions
for future reference. • Skill level -
PARTS SUPPLIED
Water Hoses (2)
Rubber Washers (4)
ELECTRICAL
Drain Hose
This appliance must be installed on the back of the washer. Installation Instructions
Washers...
Installation Instructions - Page 10
... remove the third grounding prong from the power cord. If the electric supply provided does not meet the above requirements, call a licensed electrician. LEVELING THE WASHER- Check with all local codes and ordinances. This appliance must be supplied with a cord having an equipment grounding conductor and a grounding plug. The...
Installation Instructions - Page 11
...: Make sure the washer is placed in a laundry tub or stand pipe and secure it with a cable tie (not included). Place the hose in a stand pipe without forming a U shape, a siphoning action could occur.
A snug hose fit can also cause a siphoning action.
2 CONNECT TO WATER LINES
Connect the inlet hose ends to flush the water...
Installation Instructions - Page 12
... ❏ The unit is level. ❏ The drain hose is properly tied up. ❏ There are no leaks at the faucet, drain line
or washer.
7 RUN THE WASHER THROUGH A COMPLETE CYCLE
Check for water...at least 120 square inches of the machine describing requirements.
• Minimum clearances between washer and adjacent walls or other surfaces are minimums. Consideration must contain at least 60 ...
Installation Instructions - Page 13
...on the connector until it snaps into place.
TO CONNECT THE WASHER:
1 REMOVE THE UNI-COUPLE® HOSE FROM INSIDE THE WASHER BASKET
3 CONNECT TO VALVE INLET
Attach the COLD water supply...coupler connections as leakage may occur.
ONE-FAUCET CONNECTIONS
Use the hose connector provided with the washer for tightest fit. Locking Collar
5 CONNECT DRAIN HOSE
Attach the drain hose to the COLD...
Installation Instructions - Page 14
Installation Instructions
WASHER CONNECTIONS FOR PORTABLE MODEL WSLP1500- Insure proper ground exists before use
14
ONE-FAUCET CONNECTIONS ...on the back of the washer.
10 INSTALLATION CHECKLIST
Before starting the washer, check to make sure: ❏ Main power is turned on. ❏ The washer is plugged in. ❏ The water faucets are turned on.
❏ The unit is level.
❏ ...
Installation Instructions - Page 15
...
2 UNPLUG POWER CORD AND RETURN IT TO THE STORAGE AREA
Hose Connector
5 DRAIN WATER
Drain water from the faucet adapter.
Installation Instructions
TO DISCONNECT THE WASHER:
1 TURN WATER FAUCET OFF
4 DISCONNECT FROM WATER LINE
Move the locking collar down and pull the hose connector down to disengage from the hoses through...
Installation Instructions - Page 16
... be connected to both the hot and cold water faucets. Insure proper ground exists before use
4 INSTALLATION CHECKLIST
Before starting the washer, check to the sink or stand pipe. In the United States, call 800.626.2002.
In Canada, consult the yellow pages for your dealer or from your local Camco number...
Installation Instructions - Page 17
... the drain hose connection. OE
■ Indicates water has overflowed.
Ub
■ Indicates the laundry load is level. Reposition laundry evenly in basket, and ensure washer is unbalanced. LE
■ Indicates washer has leakage.
Restart after spinning. Ensure the drain hose is open.
Close the lid.
Troubleshooting Tips Save time and money!
Lo
■...
Installation Instructions - Page 18
... call a plumber.
• Tighten hoses at faucets and the washing machine. Make sure the end of the drain hose is correctly inserted and secured to correct faucets.
• Turn off after... they may be less than 8 ft.
Troubleshooting Tips
WATER Too many suds
POSSIBLE CAUSES
Type of the washer. Reinstall screens, reconnect the hoses and turn the water off the water source and ...
Quick Specs - Page 1
WSLP1500JWW
Listed by a 15 or 20 amp circuit breaker or a time-delay fuse, is required. Electrical Rating: 120V; 60Hz
Washer Note: Washer wall outlet must not be located within 36" of service cord entry. Installation Information: For complete information, see installation instructions packed with a three-prong grounding-...
Quick Specs - Page 3
... Levels - It resists rust and won't chip, peel or snag
clothes • Model WSLP1500JWW - Offers water and energy savings • Stainless Steel Basket - Eliminates guesswork and helps reduce water waste
• 14 Wash Cycles - WSLP1500J
GE Spacemaker® Portable Washer
Dimensions and Installation Information (in inches)
Features and Benefits
• Electronic One-Touch...
Similar Questions
Error Codes?
How do I get this model to provide the error codes? And how an I get an error code list?
How do I get this model to provide the error codes? And how an I get an error code list?
(Posted by paulabbott4975 3 years ago)
Error Code De
I have the error code dE I'm not sure as to what parts to replace
I have the error code dE I'm not sure as to what parts to replace
(Posted by jboogiejrjw 4 years ago)
What Does The Ff Code Mean
My washer keeps stopping mid cycle with the error code FF what does that mean and do I need to have ...
My washer keeps stopping mid cycle with the error code FF what does that mean and do I need to have ...
(Posted by Shambee76 8 years ago)
How Do I Fix The Lid Open Error Code For My Ge Wslp1500jww Washing Machine?
(Posted by kburke4287 9 years ago)
Error Code: Ff
The water isnot staying in the washer and filling up to do a load of laundry. it's just cycling thro...
The water isnot staying in the washer and filling up to do a load of laundry. it's just cycling thro...
(Posted by dnlep 11 years ago)