GE WPGT9150HMG Support Question
GE WPGT9150HMG Support Question
Find answers below for this question about GE WPGT9150HMG - Profile 27" Washer.Need a GE WPGT9150HMG manual? We have 1 online manual for this item!
Question posted by gaby37nice on November 29th, 2010
My Model Wpgt9150hmg Is Showing Code 50 Cl
The person who posted this question about this GE product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related GE WPGT9150HMG Manual Pages
Owners Manual - Page 1
Profile Washers
ge.com
Safety Instructions 2, 3
Operating Instructions
Control Panel 4-5 Features 6-8 Loading and Using the Washer 9, 10
Installation Instructions
Before You Begin 11-...20
Owner's Manual and Installation
Instructions
WPGT9150
Write the model and serial numbers here:
Model
Serial
You can find them on the rear cover of the washer backsplash.
175D1807P604 49-90336 09-07 JR
Owners Manual - Page 2
.... Installation Instructions are included in Installation Instructions. YOUR LAUNDRY AREA
I Install or store where it is connected ...faucets and allowing them to play on all governing codes and ordinances.
For your appliances free of fire ... Instructions Safety Instructions
IMPORTANT SAFETY INFORMATION.
I Properly ground washer to conform with or inside this process.
I Close ...
Owners Manual - Page 3
... in published user-repair instructions that have the skills to the wash water. I Before discarding a washer, or removing it is damaged, malfunctioning, partially disassembled, or has missing or broken parts, including... dry articles that you understand and have been
from the power supply. I The laundry process can produce a toxic gas which may cause death. I Do not tamper with combustible...
Owners Manual - Page 4
...
Consumer Support Troubleshooting Tips
4 If the display is active, press to "wake up" the display. NOTE: Pressing POWER does not disconnect the appliance from your model.
1
3 45
26
1 Power Press to put the washer into idle mode.
Control Panel Throughout this manual, features and appearance may vary from the power supply.
Owners Manual - Page 5
...time to help you must use , create or modify custom wash cycles. NOTE: The washer performs automatic system checks after pressing the START button. DELICATES For lingerie and special-care fabrics... When selecting this cycle, you match the wash setting with the loads. If the washer is approximately 30 minutes, depending on some casual wear clothes. Fabrics include modern technology ...
Owners Manual - Page 6
...START button.
NOTE: When using MY CYCLE, wash options cannot be available on all washer models. Press the button until you open the lid when the delay is desired to delay ...maximum soak time is an extra wash before washing a load. Operating Instructions Safety Instructions
About the washer features. NOTE: Features may not be modified after the cycle has been started.
Delay Start
...
Owners Manual - Page 7
... the drawer too quickly could result in early dispensing of bleach.
3 Before starting the washer, pour measured amount of bleach directly into the wash basket directly before adding clothes. NOTE... to the wash load.
The maximum capacity of the bleach dispenser is one cup of laundry products.
Overfilling could result in early dispensing of bleach per wash cycle. Using the Dispenser...
Owners Manual - Page 8
....
Installation Instructions
Consumer Support Troubleshooting Tips
8 Operating Instructions Safety Instructions
About the washer features.
Add measured detergent to make sure the detergent box and insert are ... residue being left -hand compartment. Avoid using liquid detergent, make sure all washer models.
You may be adjusted for the Wash Boost setting in damaged clothes. When...
Owners Manual - Page 9
...;F 90°F 120°F
NOTE: Use HE (high-efficiency) labeled detergent. HE detergents are fabric care label "symbols" that provide good cleaning performance in the washer basket. Bulky items should be laundering. Because of the wash basket.
Sorting Wash Loads
Sort by color (whites, lights, colors), soil level, fabric type (sturdy...
Owners Manual - Page 10
...be replaced every 5 years. rinse the inserts and the drawer with warm water to remove traces of accumulated laundry products.
3 To clean the drawer opening, use a small, non-metal brush to clean the basket, use...water from the upper and lower parts of the Washer
Lid: Wash with a damp cloth on the front of laundry problems. Today's detergents are formulated to the proper compartments and replace ...
Owners Manual - Page 11
...800.432.2737) or visit our Web site at 120° to 150°F (50° to leave these instructions for
future reference. • Skill level - Installation of... of the washer. WARNING - Installation Instructions
Questions? Save these instructions completely and carefully.
• IMPORTANT - Observe all local codes and ordinances. Be sure to 66°C) TO THE WASHER. Keep these...
Owners Manual - Page 12
...on firm flooring to overhead shelves, cabinets, ceilings, etc., is 52″.
Minimum clearance between washer and adjacent walls or other surfaces:
• 0″ either side • 2″ front ...installing and servicing.
27″ (68.6 cm)
Side View
523⁄ 4″ (133.7 cm)
(with equivalent air openings for washer only, or if the closet contains both a washer and a dryer,...
Owners Manual - Page 13
... the Styrofoam block containing the Owner's Manual, parts, water hoses and laundry product samples.
❑ Cable Tie
TOOLS YOU WILL NEED
❑ Adjustable Pliers ❑ Carpenter's Level
Remove the power cord from the back of the washer.
1 UNPACK THE WASHER
After the washer is in the home, remove the carton and Styrofoam shipping base...
Owners Manual - Page 14
... If your home.
Hand tighten; Installation Instructions
2 ATTACH WATER HOSES TO WASHER
Thread the hot water hose onto the washer hot water connection (ORANGE) and the cold water hose onto the cold water... to the home. then make an additional 1/8 turn with pliers.
3 MOVE WASHER CLOSE TO HOUSE UTILITIES
Move the washer as close to the final location as possible, leaving enough room to make an...
Owners Manual - Page 15
... rear legs back onto the floor. This action will set rear leg adjustments to correspond to front settings.
7 LEVEL THE WASHER
Move the washer into final position. • To check if the washer is level side to side,
open the lid and place a level at the back of the opening above the dispenser...
Owners Manual - Page 16
... and dangerous operation after servicing/installation. Installation Instructions
8 PLUG IN WASHER
9 WASHER STARTUP
Press the POWER button.
NOTE: If the washer has been exposed to temperatures below freezing for an extended period of... time, allow it to the Owner's Manual for use.
16 The washer is now ready for servicing phone numbers.
SERVICING
WARNING - For replacement parts and...
Owners Manual - Page 17
... Support
17 Press POWER.
• Make sure cord is normal for this washer may be free of the clothes. Safety Instructions Operating Instructions
Installation Instructions
Before ...8226; Make sure that the water supply is open positions.
• The washer lid must be different than non-energy-efficient washers.
• Make sure that the fill hoses connect the hot water supply to...
Owners Manual - Page 18
... per the manufacturer's recommendations.
Installation Instructions
Problem
Possible Cause
What To Do
Washer will be dispensed every load for the amount of detergent
• Oversudsing .... The liquid detergent insert box and siphon caps may be removed for this washer.
Operating Instructions Safety Instructions
Before you choose not to use . Oversudsing of detergent...
Owners Manual - Page 20
... this additional eight-year limited warranty, you may also have serial number and model number available when calling for any of shipping or service calls to your receipt...or resetting of incidental or consequential damages. Operating Instructions Safety Instructions
Installation Instructions
GE Washer Warranty. (For customers in the United States)
All warranty service provided by a...
Owners Manual - Page 21
...FOR CONSEQUENTIAL DAMAGES. Warrantor: MABE CANADA INC. Safety Instructions Operating Instructions
Installation Instructions
GE Washer Warranty. (For customers in Canada)
All warranty service provided by possible defects with ...
21 For service, call 1.800.561.3344. Please have serial number and model number available when calling for any labor or related service costs.
For The Period...
Similar Questions
Shattered Glass In Lid
The glass in my washer lid is shattered. Can I replace it or buy a new lid?
The glass in my washer lid is shattered. Can I replace it or buy a new lid?
(Posted by ladysuzeq 3 years ago)
Washer Will Not Start
What do I need to to went E7 come up when you push start?
What do I need to to went E7 come up when you push start?
(Posted by estherfallis57 6 years ago)
Error Code En
at the end rinse cycle unit shuts down and the display shows EN unit would Beep and then shut down, ...
at the end rinse cycle unit shuts down and the display shows EN unit would Beep and then shut down, ...
(Posted by ramfromchag 8 years ago)
Wcvh6800jms Washer Does Not Cycle
Our Washer wont cycle, It starts and pumps out water but then wont cycle. Control board?
Our Washer wont cycle, It starts and pumps out water but then wont cycle. Control board?
(Posted by cholub 9 years ago)
Code D2
We have a code d2 show up as soon as power is turned on. What does the d2 stand for. thanks
We have a code d2 show up as soon as power is turned on. What does the d2 stand for. thanks
(Posted by russellolin45 11 years ago)