GE SE50T12TAH Support Question
GE SE50T12TAH Support Question
Find answers below for this question about GE SE50T12TAH.Need a GE SE50T12TAH manual? We have 2 online manuals for this item!
Question posted by sedonaursulasam on March 3rd, 2012
Drain Valve Removaleiru
WANT TO KNOW HOW TO REMOVE DRAIN VALVE FROM THE TANK SO I CAN INSERT A NIPPLE/TEE
I THINK IT'S A 3/4IN THREADED FITTING BUT I WANT TO
MAKE SURE BEFORE I PUT A PIPE WRENCH ON IT
Current Answers
Related GE SE50T12TAH Manual Pages
Use and Care Manual - Page 1
... to explain the features, operation, safety precautions, maintenance and trouble shooting of the water heater. If you do not understand these operations. Please read the instructions carefully so that...with basic directions and recommendations for the proper installation and adjustment of the water heater; AP12168-7 (01/05) Pub. Box 244020, Montgomery, AL 36124-4020
Part No...
Use and Care Manual - Page 2
... a specific condition. Recognize this manual and on your water heater.
DANGER !
Attention is the safety alert symbol.
You...appliance. A potentially hazardous situation that can relax knowing help is in the back of Troubleshooting Tips first...Water Connections 6 Electrical Connections . . . . . 8
Operating Instructions Safety Controls 12 Water Temperature 13
Care and Cleaning Draining...
Use and Care Manual - Page 3
...water lines.
Be sure to be used for reducing point of water heater's thermostat. Feel water before setting temperature at water heater.
Refer to adjust the thermostat(s). This label is regulated by mixing hot and cold water in this manual for Hot Water...at 120°F before the water heater was shipped from the factory. Temperature limiting valves are at highest risk of ...
Use and Care Manual - Page 4
... INFORMATION. WARNING!
Care and Cleaning
FOR INSTALLATIONS IN THE STATE OF CALIFORNIA
California Law requires that residential water heaters must be referred to shut it is specifically recommended in this Use and Care Manual.
● Be sure your safety, the information in accordance with generic earthquake bracing instructions can be braced, anchored or...
Use and Care Manual - Page 5
... pan, adequately drained, be at least 3/4″ ID and pitched for possible damage. Place the water heater in the absence of local codes, the latest edition of the water heater to be removed to the water heater requirements.
5 Do not install the water heater in a clean dry area as near as removal of greatest heated water demand.
Location
Locate the water heater in outdoor...
Use and Care Manual - Page 6
... of controlling thermal expansion is to install an expansion tank in the inlet water line. Water Supply Connections
NOTICE: Do not apply heat Refer to the water supply fittings will not correct the problem!
Any heat applied to the illustration below ). A check valve located in the water heater and piping system can cause what is designed with no check...
Use and Care Manual - Page 7
... should be full of the water heater as marked on this subject may be installed in the opening provided and marked for complete terms and conditions.)
Make certain the drain valve is not unusual, and will disappear after the water becomes heated. If, however, the condensation continues, examine the piping and fittings for hot water distribution. Safety Instructions Installation...
Use and Care Manual - Page 8
...diagrams in the piping and water heater does not provide sufficient conduction for the water heater are specified on the rating plate on the front of the water heater and the ...branch circuit with fittings approved for use as a ground conductor shall include a separate conductor for grounding. can cause the water heater to the ground terminals of the water heater.
All wiring...
Use and Care Manual - Page 9
... and temperature relief valve.
CAUTION: If local codes require the application of an external insulation blanket to this could interfere with respect to insulation and standby loss requirements making an insulation blanket unnecessary.
Do not cover the jacket access panel(s) to relocate them on electric water heaters are not necessary. Typical horizontal piping arrangement
Please...
Use and Care Manual - Page 10
... the water connections on heater. If sweat connections are used, sweat tubing to adapter before fitting adapter to the water supply fittings will permanently damage the dip tube and/or heat traps. Relief Valve Insulation Installation
CAUTION: Ensure the T&P Valve opening of pipe insulation.
Operating Instructions Installation Instructions Safety Instructions
Installing the water heater.
Use and Care Manual - Page 11
...Service
11 Water Supply
■ Water heater completely filled with water heater rating plate.
■ Branch circuit wire and fusing or circuit breaker of water heater. Safety Instructions Installation Instructions Operating Instructions
Installation checklist. Relief Valve
■ Temperature and Pressure Relief Valve properly installed and discharge line run to open drain.
■ Discharge...
Use and Care Manual - Page 12
... the work. To reset the temperature limiting control:
Turn off valve is filled with the tank surface.
Remove the jacket access panel(s) and insulation.
Safety Precautions
Do turn on water heater unless it has been subjected to flow. Do Not turn off power to water heater if it is closed.
If hydrogen is open flame near the...
Use and Care Manual - Page 13
...heaters have two thermostats. Mixing valves for reducing point of use water...and on the label on the water heater.
If adjustment is the recommended starting point.
Be sure to read and follow the warnings... access panel(s).
Water Temperature Setting
The temperature of the water heater's thermostat(s). Safety and energy conservation are factors to be removed.
Turn off...
Use and Care Manual - Page 14
...Operating Instructions. Make sure the cold water supply is therefore not uncommon for solids suspended in the water.It is turned off power to correct this may be drained from the tank may require cleaning.
A water heater's tank can cause a banging noise heard in a water pipe.
NOTICE: Refer to an open drain. DANGER: Before manually operating the relief valve, make certain no...
Use and Care Manual - Page 15
... Not enough or no hot water
Water is normal for the water heater to recover after an abnormal demand.
● Replace fuse or reset circuit breaker.
● Make sure electric supply to qualified service personnel. Electric supply may not need for service.
Cold water inlet temperature may be corrected. Internal heat trap fittings in operation and does not...
Use and Care Manual - Page 16
... access panel
Thermostat bracket
Drain valve
Cavity insulation
Customer Service CAUTION: For your safety DO NOT attempt repair of electrical wiring, thermostat(s), heating elements or other operating controls. Relief valve **Heat Trap
**Nipple
**Heat Trap **Nipple
Dip tube Dip tube ...-1549. Specify voltage and wattage as noted below) and number of the water heater from the rating plate.
Use and Care Manual - Page 17
... crossbar up and down until it breaks away from the remainder of the water heater.
17
Care and Cleaning
Troubleshooting Tips
Customer Service NOTICE: The cavity insert crossbar is necessary for qualified service personnel ONLY, and should
only be replaced. The removal of the crossbar will not interfere with the operation of the cavity...
Use and Care Manual - Page 20
Water Heater
Model Number
Serial Number
Mr. ■ First Name
Ms. ■
Mrs. ■
Miss ■
Last Name
Street Address
Apt. #
City
State
Date Placed In Use
...
Energy Guide - Page 1
U.S. °comment
Federal law prohibits removal of 10.65 cents per kWh.
• For more information, visit wwwitc.govrappliances,
Van No ax - ELECTRIC Capacity (1st hour rating) : 67 GALLONS
Model SE50T12TAH 000001
Estimated Yearly Operating Cost
$497
5I7Y
5531
Cost Range... on a 2007 national average electricity cost of this label before consumer purchase
BERG GUIDE
Water Healer -
Similar Questions
What Replacement Element Do I Buy For Water Heater Se50t12tah
(Posted by bobcgregg 4 years ago)
My Water Heater Keeps Going Into System Lockout /
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
(Posted by rmjozwiak 8 years ago)
Ge Power Vent Water Heater
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
(Posted by miller19602003 9 years ago)
Witch Water Heater To Purchase.
Se50T12tah/408603 or SE50T12aah/487-876 or se80t12tah/488-106. Which one uses the least electrici...
Se50T12tah/408603 or SE50T12aah/487-876 or se80t12tah/488-106. Which one uses the least electrici...
(Posted by neldaprn 12 years ago)