GE PTDN805GMMS Support Question
GE PTDN805GMMS Support Question
Find answers below for this question about GE PTDN805GMMS.Need a GE PTDN805GMMS manual? We have 2 online manuals for this item!
Question posted by jav16547 on September 9th, 2013
How To Install Electric Cord In A Ge Ptdn800 Dryer With Strain Relief
how to install electric cable 3 wire on a GEPTDN800
machine did not come with electric cable did not come w/electric cable
did not have a Strain Relief - the connector is located in the top of the dryer
Current Answers
Related GE PTDN805GMMS Manual Pages
Use and Care Manual - Page 1
....com
Safety Instructions 2-5
Operating Instructions
Controls 6-8 Cycle Options 9-10 Dryer Features 11 Loading and Using the Dryer 12, 13
Installation Instructions
Before You Begin 14-16 Connecting a Gas Dryer 17-20 Connecting an Electric Dryer 21-23 Exhausting the Dryer 24-30 Final Setup 31 Reversing the Door Swing 32-33
Troubleshooting Tips 34
Consumer Support
Warranty...
Use and Care Manual - Page 2
... minimize the risk of fire or explosion, electric shock, or to the outdoors.
n Do not store or use any electrical switch;
Properly adjusted dryers will minimize incomplete combustion. Exposure to these ...information in this or any other appliance.
Installation Instructions
Consumer Support Troubleshooting Tips
2
Operating Instructions Safety Instructions
IMPORTANT SAFETy INFORMATION. READ All ...
Use and Care Manual - Page 3
... Installation Instructions
Troubleshooting Tips Consumer Support
3 If you did not receive an Installation Instructions sheet, you can receive one by visiting GEAppliances.com, or by calling 800.GE....INSTALLATION
This dryer must be properly installed and located in Installation Instructions. n Pull the protector out and down to its lowest position and connect the exhaust duct to avoid electrical...
Use and Care Manual - Page 4
...preferably in a locked cabinet.
YOUR LAUNDRY AREA
n Keep the area underneath ...dryer until the drum has completely stopped. n To minimize the possibility of electric shock, unplug this appliance from Heat or Do Not Tumble Dry (such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.) which you have used a cleaning solvent or that may melt or burn. Installation...
Use and Care Manual - Page 5
... Operating Instructions
Installation Instructions
GEAppliances.com...electricity in your dryer.
Items contaminated with an automatic electric ignition and does not have the skills to the cord...dryer-added product for which the manufacturer gives written assurance on . n Do not attempt to repair or replace any servicing unless specifically recommended in the vicinity of the machine...
Use and Care Manual - Page 6
... Safety Instructions
About the dryer control panel. To reduce the risk of fire, electric shock, or injury to persons, read the ImPORTANT SAfETY INSTRUCTIONS before operating this manual, features and appearance may vary from your model.
*Applied Model : PTDS850/PTDS855
2
7
8
1
*Applied Model : PTDN800/PTDN805
2
3 4 56 7
1
3 4 56
Installation Instructions
Consumer Support Troubleshooting...
Use and Care Manual - Page 14
... be performed by a barrier from service or discarded, remove the dryer door.
• Service information and the wiring diagram are located in the control console.
• Do not allow children on or in the appliance. Observe all governing codes and ordinances.
• Install the clothes dryer according to the manufacturer's instructions and local codes.
•...
Use and Care Manual - Page 16
...Installation Instructions LOCATION OF YOUR DRYER (cont.)
REQUIREMENTS FOR ALCOVE OR CLOSET INSTALLATION
• Your dryer is approved for installation in an alcove or closet, as stated on a label on the dryer back.
• The dryer... ELECTRICAL CODE, ANSI/NFPA NO. 70 (for electric dryers) or NATIONAL FUEL GAS CODE, ANSI Z223 (for gas dryers). See EXHAUST INFORMATION.
• The installation ...
Use and Care Manual - Page 17
... Valve
Disconnect and discard old flexible gas connector and ducting material.
Safety glasses
17
Installation Instructions CONNECTING A GAS DRYER (skip for tightening connections
Gloves
Turn the dryer's gas shutoff valve in the supply line to the OFF position. or straight-blade screwdriver (may be needed for cord strain relief)
Flexible stainless steel or plastic...
Use and Care Manual - Page 18
...use with propane (LP) gas. For operation at elevations above sea level.
• Installation must conform to floor.
DRYER GAS SUPPLY CONNECTION
31⁄4" (8.2 cm)
23⁄8" (6 cm) 3/8" NPT MALE...need not be adjusted for use Teflon® tape.
• Connect flexible metal connector to dryer and gas supply. ALL CONVERSIONS MUST BE MADE BY PROPERLY TRAINED AND QUALIFIED PERSONNEL AND...
Use and Care Manual - Page 20
.../NFPA NO. 70.
Never use an extension cord or an adapter plug with 120V, 60Hz, and connected to the brass fittings. ELECTRICAL REQUIREMENTS FOR GAS DRYERS
This appliance must not contain ammonia, which could cause damage to a properly grounded branch circuit, protected by a 15- Installation Instructions CONNECTING A GAS DRYER (cont.)
TEST FOR LEAKS
WARNING - If...
Use and Care Manual - Page 21
.... 70.
21 Installation Instructions CONNECTING AN ELECTRIC DRYER (skip for gas dryers)
TOOLS AND MATERIALS YOU WILL NEED FOR CONNECTING THE ELECTRICAL SUPPLY
Flat- To reduce the risk of
fire, electric shock and personal injury:
• Do not use an extension cord or an adapter plug with this appliance.
• The dryer must be needed for cord strain relief)
...
Use and Care Manual - Page 22
... block. Strain Relief
CONNECTING DRYER POWER CORD
NOTE: Since January 1, 1996, the National Electrical Code requires that new constructions utilize a 4-wire connection to an electric dryer. WARNING - A Remove the terminal block access cover located at connections. or four-wire, single phase, 120/240V or 120/208V, 60Hz, 30-amp circuit is NOT for use on the appliance.
Installation...
Use and Care Manual - Page 28
... pull or damage
the electrical wires and do not remove the vinyl cover from the electrical components inside the dryer exhaust duct and save
Left Bottom
Remove desired knockout (one only)
Detach and remove the bottom, right or left of cabinet for Electric models only. Installation Instructions
EXHAUSTING THE DRYER (cont.)
SIDE VENTING:
Dryer Exhaust to right of...
Use and Care Manual - Page 30
Installation Instructions
EXHAUSTING THE DRYER (cont.)
BOTTOM VENTING (cont.)
ADDING A NEW DUCT
• Reconnect the cut
Portion "A"
portion A of cabinet for Gas and Electric...
or damage the electrical wires inside the dryer when inserting the ...through the elbow and pipe. Place dryer in a 90-degree position to complete...using your local service provider. Dryer Exhaust to the bottom of the...
Use and Care Manual - Page 31
...dryer will not come on.
Raise Lower
2 PLUG IN DRYER
Ensure proper ground exists before pressing POWER.
SERVICING
WARNING - Wiring errors can cause improper and dangerous operation after servicing/installation...first installed, this test should be performed to warm up before use .
31
FINAL SETUP
Installation Instructions
1 LEVEL THE DRYER
Stand the dryer near the final location. ...
Use and Care Manual - Page 34
...Electric dryers use . Press START.
• If the dryer has been exposed to temperatures below first and you may not need to be reset START was not pressed after use two fuses or breakers.
• Unplug dryer...ducts, wall caps and around turns.
Installation Instructions
Troubleshooting Tips Consumer Support
34 Press POWER.
• Make sure cord is normal. Replace fuses or reset ...
Use and Care Manual - Page 36
...limited Warranty. Installation Instructions
Consumer...General.
Dryer Drum ...Safety Instructions
GE Dryer Warranty. ...GE Service location for any labor or related service costs. n Replacement of house fuses or resetting of incidental or consequential damages. n Improper installation.
n Incidental or consequential damage caused by a GE...GE.CARES (800.432.2737). This warranty is located...the dryer ...
Quick Specs - Page 1
...for proper installation. See dryer ducting information for natural gas. Note: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted ... is shipped exhausted to your dryer. Check installation instructions for LP gas. Tested for correct kit and have a qualified gas technician install a conversion kit.
Gas Dryer Electric Rating: 120V, 60Hz, 6A...
Quick Specs - Page 2
...dryer. Specification Revised 12/10 270173 PTDN800GM/PTDN805GM
GE Profile Harmony™ 7.3 Cu. Ft. Stainless Steel Capacity Gas Dryer
For complete information, see installation instruction packed with the National Electric... and a dryer, doors must be located at additional cost. If this dryer should be treated as a 90° elbow.
A A
4
B
Domestic 2-1/2 dryer models
7.5 ...
Similar Questions
How To Disassemble A Ge Gfdr270eh1ww Dryer
How to disassemble a GE gfdr270h1ww dr
How to disassemble a GE gfdr270h1ww dr
(Posted by sbasscc 2 years ago)
Ge Profile Dryer Dpvh880ejww Coil Part #
I am looking for the coil part # for a GE Profile front load dryer, model # DPVH880EJWW. I do not ne...
I am looking for the coil part # for a GE Profile front load dryer, model # DPVH880EJWW. I do not ne...
(Posted by jmaples1 7 years ago)
Ge Gas Dryer
Won't heat-just stopped cleaned all the vents and inside heats up sometimes. I can hear the ignator ...
Won't heat-just stopped cleaned all the vents and inside heats up sometimes. I can hear the ignator ...
(Posted by Dmommas 8 years ago)
How Do I Remove Top To My Ge Gfdn120gdww Dryer?
How do I remove top to my GE GFDN120GDWW dryer?
How do I remove top to my GE GFDN120GDWW dryer?
(Posted by rolandpineda 8 years ago)
Ge Dsk333e Dryer Won't Run Though When The Start Button Is Pushed It Buzzes
The unit is getting power and the start button works. No wires appear to disconnected inside the uni...
The unit is getting power and the start button works. No wires appear to disconnected inside the uni...
(Posted by dmsearles 12 years ago)