GE PFWS4605LMG Support Question
GE PFWS4605LMG Support Question
Find answers below for this question about GE PFWS4605LMG.Need a GE PFWS4605LMG manual? We have 3 online manuals for this item!
Current Answers
Related GE PFWS4605LMG Manual Pages
Quick Specs - Page 1
... Steam
Dimensions and Installation Information (in inches)
Electric Rating
27"
120V 12.0A, 60Hz
Installation Information: For complete information, see installation instructions packed with your washer.
39-3/4"
34 3/8"
39-3/4"
34 3/8"
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or...
Quick Specs - Page 2
... Dimensions (in . Feet on 15" pedestal allow it to adjust to combustible surfaces 0" both a washer and a dryer, doors must conform with a gas dryer. White This optional 15" pedestal raises the...rear
• Minimum vertical space from floor to your dryer is approved for stacking dryer over washer is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a ...
Quick Specs - Page 3
... problem! AVC adapts and optimizes spin patterns reducing vibration and sound no matter where your laundry room is washed and ready to six months of specialty loads including performance fabrics, fleece,... from the washer to the dryer
• Steam Refresh/Steam Assist - Fast spin speeds remove water efficiently and minimize dry time
• ADA Compliant
• Model PFWS4605LMG - Steam ...
Use and Care Manual - Page 2
...This simple procedure will not be exposed to temperatures below freezing or exposed
„ Properly ground washer to cover every possible condition and situation that may be produced in a water heater that ... entice children to play on, with or inside the washer.
„ Close supervision is used for two weeks or more .
YOUR LAUNDRY AREA
„ Keep the area underneath and around your...
Use and Care Manual - Page 3
... the possibility of the fill hoses; NOTE: Pressing the power button does NOT disconnect the appliance from the power supply or disconnect the washer at the building's distribution panel by removing the fuse or switching off
around your washer or dryer during this time.
„ The laundry process can produce a toxic gas to carry out...
Use and Care Manual - Page 4
..., choose between Rinse and Spin, Garments, Bed and Bath, and Other Specialty for each cycle. NOTE: Pressing POWER does not disconnect the appliance from the power supply.
4 About the washer control panel. PFWS4600, PFWS4605 - Profile HA Steam Washer w/ SmartDispense™
2
16
10
17
5
3
1
6
8
12
7
9
13
15
11 14
4
PFWH4400, PFWS4405 - These default settings can...
Use and Care Manual - Page 5
... for washing wool. For lightly soiled items that may need special treatment. Specialty Cycles
Rinse & SPIN
Quickly rinse out any items at any time. The washer will beep upon completion of once per month.
WHITES/HEAVY
DUTY
For heavily to select the cycle.
Press ENTER to lightly soiled white cottons, household...
Use and Care Manual - Page 6
... will display, "RECEIVING CYCLE INFORMATION TO THE DRYER". End-of the cycles.
Display Brightness:
The washer will display, "TRANSFERRING CYCLE INFORMATION TO THE DRYER" and the dryer will be cancelled. When "DISPLAY BRIGHTNESS" appears in home laundry. The prewash and rinse water is always cold.
To change the SOIL LEVEL, press the...
Use and Care Manual - Page 7
... selections from soiled loads.
A sound is made . To lock the washer, press and hold the LOCK button for 3
NOTE: The POWER button can lock or unlock the controls
the lock/unlock status. The...and T(up to fully close the door and press START again in order to select the delay time. washer by touching pads with a care label the clothes, drain and spin.
Press the
the door, a ...
Use and Care Manual - Page 9
... pressing pause. smaller loads only. After use :
1. optional accessory (on some models)
in the flow-through dispenser drawer
If you have bulk-dispensing capability. Turn power ON and select a wash cycle.
High wear or delicate articles are not
OVERNIGHT READY is only available on WHITES/HEAVY DUTY, COLORS/NORMAL, WRINKLE FREE...
Use and Care Manual - Page 10
...added.
„Detergent usage may see water in the top right portion of the the washer gasket. Use only HE High-Efficiency detergent.
For best performance, clean this location Detergent
selection...for water temperature, water hardness, size and soil level of the cycle. After adding laundry products, slowly close the dispenser drawer. Replace the filter after every Overnight Ready cycle...
Use and Care Manual - Page 11
... could extend wash times.
„ Do not put clumped detergent in this front-load washer.
Place the Detergent selection insert in damaged clothes. Make sure to push the insert to... location depending on the wash load.
11 Do not exceed the maximum fill line. About the washer features. Overfilling can cause a leak.
GEAppliances.com
The Detergent Compartment
Adjustment „ Only use...
Use and Care Manual - Page 14
... it stops. Rinse the inserts and the drawer with hot water to remove traces of accumulated laundry products.
„ To clean the drawer opening, use a small brush to the proper compartments. Loading and using the washer.
Dispenser Drawer Area: Detergent and fabric softener may build up in the Dispenser Drawer area: Use...
Use and Care Manual - Page 15
...laundry detergent out of this dispense system. GEAppliances.com
Fabric Care Labels
Below are fabric care label "symbols" that allows you will be dispensed automatically during the wash and rinse cycles of sight. This pedestal gives the washer more height and gives storage for your washer... NO BLEACH may be used in this washer. See the pedestal installation instructions.
Always follow...
Use and Care Manual - Page 16
... to maximize energy savings. Check with your utility company to see if your smart washer to Critical Rate information by pressing and holding the "e"WASH Button for full details.... has been deactivated or disconnected.
16 GEAppliances.com/smart-appliances to the module are 4 power levels available: Critical, High, Normal and Low. GEAppliances.com
SETTINGS MENU
Press SETTINGS; The...
Use and Care Manual - Page 19
..., call a licensed electrician. ELECTRICAL REQUIREMENTS
Read these instructions completely and carefully. CIRCUIT - OUTLET RECEPTACLE - The washer MUST be located so the power supply cord is accessible when the washer is in the carton, carefully lay the washer on the power supply cord. Make materials inaccessible to an upright position and remove the carton. 5. Cartons covered...
Use and Care Manual - Page 21
....3344.
Place the hose in a laundry tub or standpipe and secure it with a wrench. Plug the power cord into an outlet.
9. NOTE: Check to make sure:
† Main power is turned on the power at a minimum to prevent excessive vibration. Before starting the washer, check to be sure the power is off at the faucet, drain...
Use and Care Manual - Page 24
...135; Push and pull on how to reduce vibrations. Replace fuses or reset breaker. the machine will not open and close the door firmly; Washer should correct this happens, the estimated time is plugged in pockets This ... To Do
‡ Timer adds 3 minutes to check the system. vibration or shaking
No power/ washer not working outlet. ‡ Turn both hot and cold faucets fully on how to the...
Use and Care Manual - Page 27
...„ Failure of these parts should fail due to a defect in materials or workmanship. GE Washer Warranty. (For customers in the United States)
All warranty service provided by possible defects with this...purpose or used commercially. „ Damage after delivery.
„ Replacement of house fuses or resetting of circuit breakers.
„ Damage to the product caused by accident, fire, floods or...
Use and Care Manual - Page 28
...fuses or resetting of circuit breakers.
„ Damage to the product caused by accident, fire, floods or acts of the washer which fails due to a defect in materials or workmanship.
GE Washer Warranty. ... Product not accessible to provide required service.
(;&/86,212),03/,(':$55$17,(6³ The washer basket if it is abused, misused, or used for any labour or related service costs...
Similar Questions
I Need Help On How To Connect All Of The Wires Back To The Controls On My Ge Was
(Posted by Sarahannek45 1 year ago)
All Of The Washer Controls Will Not Lite Up.machine Will Not Run.
Installed WH12X10469 Control Board and WH12X10486 Power Board ,display Board will not lite up and ca...
Installed WH12X10469 Control Board and WH12X10486 Power Board ,display Board will not lite up and ca...
(Posted by jimhancock82117 8 years ago)
