GE PE50M09AAH Support Question
GE PE50M09AAH Support Question
Find answers below for this question about GE PE50M09AAH.Need a GE PE50M09AAH manual? We have 2 online manuals for this item!
Question posted by gmfinc on December 20th, 2011
Clicking Noise
we hear a clicking clocklike noise fromm our heater now and then; thermostat opening and closing? Need to be re3placed?
Current Answers
Related GE PE50M09AAH Manual Pages
Use and Care Manual - Page 1
...water heater; It is imperative that all persons who are expected to install, operate or adjust this water heater...Instructions for the Installer
Electric Residential
Water Heaters
Single and Double Element Models, Residential...and trouble shooting of the water heater. Please read the instructions ... maintenance, service or warranty of this water heater should be directed to the seller from...
Use and Care Manual - Page 2
... preventive care on your water heater properly.
For service call away. READ THE SAFETY INFORMATION
Your safety and the safety of your part can relax knowing help is only a phone call 800-431-1549. This is needed to potential hazards that may not need service, you can save you do need to use and maintain...
Use and Care Manual - Page 3
... valves are at the left shows the temperature adjustment dial used as a guide in how to read and follow the warnings outlined on the water heater near the thermostat access panel.
! Time/Temperature Relationship in Scalds
Temperature
Time To Produce a Serious Burn
120°F 125°F 130°F 135°F 140°F 145...
Use and Care Manual - Page 4
...procedures.
Pay particular attention to prevent property damage, personal injury, or loss of your water heater unless it off .
● Read this manual entirely before attempting to a qualified technician...; Be sure your safety, the information in serious bodily injury or death.
For residential water heaters of the State Architect, 400 P Street, Sacramento, CA 95814 or you may save ...
Use and Care Manual - Page 5
..., Batterymarch park, Quincy, MA 02269 as removal of greatest heated water demand.
It is recommended that the thermostat and element access panels can waste energy and water.
The location chosen for the water heater must take into consideration the following:
Local Installation Regulations
This water heater must be installed in accordance with these instructions, local codes...
Use and Care Manual - Page 6
...refer to as an "open " water system, expanding water which exceeds the capacity of the water heater flows back into the main supply line, and the result of "thermal expansion" can cause premature failure of controlling thermal expansion are used,
necessary. A "closed water system".
A check valve located in the cold water line near the water heater. This rapid pressure increase...
Use and Care Manual - Page 7
... the Certificate of the water heater as indicated on the rating label located on the tank when it is completely closed.
Relief Valve
WARNING: The...heater (1 watt=3.412 BTUH). To Fill the Water Heater
WARNING: The tank must not be installed in the cold water supply line.
The end of water before heater is not unusual, and will disappear after the water becomes heated.
Open...
Use and Care Manual - Page 8
... recommends minimum branch circuit sizing and wire size based on N.E.C. Operating Instructions Installation Instructions Safety Instructions
Installing the water heater.
An opening for field wiring connections.
CAUTION: The presence of the water heater. The water heater is provided for 1/2″ or 3/4″ electrical fitting is completely wired to local codes or latest edition of...
Use and Care Manual - Page 9
... to restrict the proper function and operation of the water heater:
Do not cover the operating or warning labels attached to the water heater or attempt to relocate them on electric water heaters are not necessary. Typical horizontal piping arrangement
Please install the insulation, according to the thermostat(s) and heating element(s), or pressure and temperature relief valve...
Use and Care Manual - Page 10
... permanently damage the dip tube and/or heat traps.
Operating Instructions Installation Instructions Safety Instructions
Installing the water heater. NOTICE: Do not apply heat to the water connections on heater.
Relief Valve Insulation Installation
CAUTION: Ensure the T&P Valve opening of pipe insulation. If sweat connections are used, sweat tubing to adapter before fitting adapter to...
Use and Care Manual - Page 11
... fresh air supply for
proper operation of proper size.
■ Electrical connections tight and unit properly grounded. Water Heater Location
■ Close to service heater.
Relief Valve
■ Temperature and Pressure Relief Valve properly installed and discharge line run to open drain.
■ Discharge line protected from freezing.
■ Provisions made to protect area from...
Use and Care Manual - Page 12
... Precautions
Do turn off valve is closed.
The thermostat protective cover should not be an unusual sound such as air escaping through the pipe as the water begins to the hot water system.
Care and Cleaning
Troubleshooting Tips
Customer Service
12 To dissipate such gas and to the water heater. If hydrogen is equipped with the...
Use and Care Manual - Page 13
Safety and energy conservation are factory set at 120°F or less where local codes require. To comply with safety regulations the thermostat(s) are factors to the water heater.
13
Customer Service
Water temperatures above 125°F can be used as a guide in this manual and on the label on the power to be removed...
Use and Care Manual - Page 14
... make some sound when in the water pipe system or water hammer arresting devices can cause a banging noise heard in a water pipe. It is turned off the cold water supply. Rapid closing of the tank.
Make sure the cold water supply is suggested that a few quarts of water be drained from the water heater's tank annually for an extended period...
Use and Care Manual - Page 15
.... The thermostat may be interrupted. The colder inlet water takes longer to heat.
● See the Temperature regulation of the water heater section of this .
Contact the water supplier or plumbing contractor on how to your home may be corrected. Water usage may not need for heat trap fittings when in operation. Leaking or open hot water faucets. Electric...
Use and Care Manual - Page 16
All parts orders should include:
The model and serial number of electrical wiring, thermostat(s), heating elements or other operating controls.
CAUTION: For your safety DO NOT attempt repair of the water heater from the rating plate. For 20-120 gallon models with single and double elements. Instructions For Placing a Parts Order
To place orders...
Use and Care Manual - Page 17
... away from the remainder of the water heater.
17
Care and Cleaning
Troubleshooting Tips
Customer Service It cannot and need not be done when necessary. NOTICE: The cavity insert crossbar is necessary for qualified service personnel ONLY, and should
only be replaced. In order to replace the thermostat or heating element, remove the cavity...
Use and Care Manual - Page 18
Operating Instructions Installation Instructions Safety Instructions
Wiring diagrams.
Wiring Diagrams for Type-59T Therm-o-disc Thermostats
Single Element Models
L1
G* L2
BRANCH CIRCUIT TO ELECTRICAL DISTRIBUTION PANEL 240 V.
BLACK RED JUNCTION BOX
1
3
THERMOSTAT
& HIGH TEMP.
2
4
LIMIT (ECO)
1
2
HEATING ELEMENT
Double Element Models
L1
G* L2
BRANCH CIRCUIT TO ELECTRICAL ...
Use and Care Manual - Page 20
It will need should you require service.
3 Read your Owner's Manual carefully.
Water Heater
Model Number
Serial Number
Mr. ■ First Name
Ms. ■
Mrs. ■
Miss ■
Last Name
Street Address
Apt. #
City
State
Date Placed In Use
...
Energy Guide - Page 1
rod No. AX -4258 U.S, Governmerd
Federal law prohibits removal 01 this label before consumer purchase
ErIERG UlDE
Water Heater - ELECTRIC Capacity list hear rating) : 62 GALLONS
Model PE50M09AIIH 000001
Estimated Yearly Operating Cost
$520
$492
Cost Range of Similar Models
5520
4879kwh
Estimated Yearly Electricity Use
Your cost ...
Similar Questions
What Is The Part Number For The Anode Rod For The Ge Water Heater: Model # Pe50
What is the part number for the anode rod for the GE water heater: Model # PE50M09AAH - SERIAL # GE1...
What is the part number for the anode rod for the GE water heater: Model # PE50M09AAH - SERIAL # GE1...
(Posted by dries13644 4 years ago)
My Water Heater Keeps Going Into System Lockout /
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
(Posted by rmjozwiak 8 years ago)
How Do You Turn Off This Water Heater
how do you turn off this water heater
how do you turn off this water heater
(Posted by Anonymous-151411 9 years ago)
Ge Power Vent Water Heater
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
(Posted by miller19602003 9 years ago)
Ge Hot Water Heater Model Pe50m09aah How To Repair Top Pressure Valve
(Posted by lawanch 9 years ago)