GE JV936DSS Support Question
GE JV936DSS Support Question
Find answers below for this question about GE JV936DSS.Need a GE JV936DSS manual? We have 2 online manuals for this item!
Question posted by btanaschuk on September 26th, 2018
Electric Panel On My Stove Doesnt Work, Clock Light Is On On F7 Shows On The Scr
HOw can I get the electric panel on my stove to work, clock is working and F7 shows on the panel. burners work fine. Please help me , thank you
Current Answers
Answer #1: Posted by Odin on September 26th, 2018 4:02 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,620
Member since:
April 10th, 2010 Points: 41,236,620
You need to replace the control panel. For details, see https://www.hunker.com/13409268/how-do-i-repair-a-ge-oven-with-an-f7-error-code.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related GE JV936DSS Manual Pages
Use and Care Manual - Page 1
Vented
Range Hoods
GEAppliances.com
Safety Instructions 2, 3
Operating Instructions
Fan Control 4 Light Control 4
Care and Cleaning
Grease Filters 5 Hood Lights 6 Stainless Steel Surfaces 5
Installation Instructions . . .7-18
Troubleshooting Tips 19
Consumer Support
Consumer Support 24 Owner Registration 21, 22 Warranty 23
Owner's Manual and Installation Instructions
...
Use and Care Manual - Page 2
.... TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. TO REDUCE THE RISK
OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
...the burner. D. Do not use
only. You know how to prevent power from being called.
4. Use this unit with a close-fitting lid, cookie sheet or metal tray, then turn off at service panel and...
Use and Care Manual - Page 3
...RANGE TOP GREASE FIRE:
A.
Use proper pan size.
D. TO REDUCE THE RISK OF
FIRE, USE ONLY METAL DUCTWORK.
■ Do not attempt to a qualified technician. READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. READ AND SAVE THESE INSTRUCTIONS
3 WARNING - Installation work and electrical... through the flue (chimney) of your hood unless it is specifically recommended in accordance with...
Use and Care Manual - Page 4
... hood controls.
Throughout this manual, features and appearance may vary from your model. FAN Control
Turn the FAN speed control to NITE for use of the fan system while cooking helps keep... the kitchen comfortable and less humid.
Always make sure that create a frequent need for bright light while cooking. It also reduces cooking odors...
Use and Care Manual - Page 5
... hood. The metal filters trap grease released by foods on the cooktop from damaging the inside front of the vent hood. They also help ...
National Parts Center 800.626.2002
GEAppliances.com
5 Light brushing can be cleaned once a month, or as needed. Place the...filter at the bottom with the handle. GEAppliances.com
Be sure electrical power is used to find the location of the grain. Follow...
Use and Care Manual - Page 6
... or a dry cloth, remove the new bulb from its packaging.
Receptacle
Socket Hood Lights
NOTE: The glass cover should be removed only when cold. For your light bulb, disconnect the electrical power to the hood at the main fuse or circuit breaker panel. Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Care and...
Use and Care Manual - Page 7
...Range Hoods
Questions? Keep these instructions for
local inspector's use.
• IMPORTANT - When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to leave these vent hoods... these instruc- Be sure to the service panel. Installation of this vent hood requires
basic mechanical and electrical skills.
• Completion time - 1 ...
Use and Care Manual - Page 8
... Bracket
In this installation, a decorative duct cover is available to accommodate 8 to 10 ft. Order the duct cover accessory at the time of the hood. Use of the hood to the ceiling. • The duct cover accessory fits both 30″ and 36″ wide
models.
to 34″ Max. ceiling heights...
Use and Care Manual - Page 9
... or you are in the wall. Adequate structural support must be mounted beneath.
Electrical supply
This vent hood must be vented vertically through the rear wall. WARNING: The improper connection
of ...supplied with 120V, 60Hz, and connected to the ceiling or soffit. The duct cover will also help to the installation location as possible in CFM
0 600
25
50
75 100 125 150
500
400...
Use and Care Manual - Page 10
...gas water heaters and other naturally vented systems. To minimize the chance of interruption of the hood through -the-wall venting. It Can Transition To 3-1/4″ x 12″ Duct
Kit ....
7″ Round wall cap with damper 3-1⁄4″ x 12″ wall cap with any ventilation hood.
Using a smaller diameter duct size will reduce performance
7″ round to
3-1/4″ x 12″...
Use and Care Manual - Page 11
... socket Safety glasses
UL Listed Wire nuts
Pliers
Hammer
Tin Snips
Wood Mounting Support
Hood
Motor
Parts Package
Shipping Carton
• Remove shipping screws holding the wood mounting... relief for later installation. Pencil and tape measure
Phillips and Flat blade screwdrivers
Duct tape
Electric drill with ground.
Do not discard.
• Remove the "V" shaped carton insert. ...
Use and Care Manual - Page 12
...determine if the duct cover accessory can
be used alone to accurately locate studs, ductwork and electrical service. Nested together they are 22" 24″ min., expanding to
a total maximum ... WHEN THE DISTANCE ABOVE THE TOP OF THE HOOD IS
BETWEEN 12″AND 24″.
Ceiling 12"
30"
9 ft. Ceiling
30"
24"
24"
30"
9 ft. The duct cover will help to fill a
12″ height.
11"...
Use and Care Manual - Page 13
...:
• If venting out the ceiling, extend the centerline
forward on
the ceiling, 11-1/8″ to the right of the centerline for the
bottom of Hood
FOR CEILING VENT DUCTING
Electrical
Centerline 8" Min. House wiring may enter the junction box from the line for details to the right of the...
Use and Care Manual - Page 14
... screws. • Using two large flat washers (supplied), install wood screws or wall fastener screws, loosely, into the two lower mounting
holes. Installation Instructions
1 INSTALL HOOD SUPPORT
IMPORTANT: Framing must penetrate at least 1-1/2 ″ into vertical studs.
Secure the support to 2 or more vertical studs with 4 screws provided.
• Use duct...
Use and Care Manual - Page 15
... operation, we strongly recommend that it is supported by the soffit. • The soffit should be capable of the hood.
• Lift hood onto mounting screws. Installation Instructions
4 Alternate Mounting Method INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
IMPORTANT: Soffit framing must be secured to...
Use and Care Manual - Page 16
... will prevent proper damper operations. Use larger holes for an airtight
seal. • Use duct tape to span 24″ or more height above the hood.
Remove the screws. Seal connection with wood screws and washers.
Use and Care Manual - Page 17
... • Secure the duct cover to -copper connectors. Insert Tabs Into Slots
8 CONNECT ELECTRICAL
Verify that power is aluminum, be provided by the installer.
Be sure wires are at the... compound and aluminum-to the bracket with 4 screws provided.
See the illustration for the hood connector location. Installation Instructions
7 INSTALL MOTOR
• Align and engage the slots in ...
Use and Care Manual - Page 18
...
11 INSTALL FILTERS
• Remove protective film covering the filters. • Insert the filter into the lower slots at the bottom
of the vertical front panel. • Tap the filter against one side to test all controls.
"C" Clip
Filters
Filter Support
• To remove the filters, grasp the handle, push the...
Use and Care Manual - Page 23
...Electric Company. In Alaska, the warranty excludes the cost of charge, all labor and in materials or workmanship. To know what your home to teach you may be required to bring the product to replace the defective part.
Louisville, KY 40225
23 Staple your home. Proof of the range hood... Cleaning Troubleshooting Tips Consumer Support
GE Range Hood Warranty. Some states do not allow...
Quick Specs - Page 2
JV936D - Stainless steel
Specification Revised 7/09 220955 GE Profile™ 30" Designer Hood JV935/965D
Features and Benefits
• 30" Cooktop
• 600 CFM Rating
• 4-Speed Fan Control
• Dual Halogen Lighting (Off/High/Night)
• Dishwasher Safe Filter Cleaning
• Hidden Controls
Profile
• 7 Sones Rating
• 7" Round Duct Size (Vertical...
Similar Questions
Light Bulbs Flickering
I have this range hood. All of a sudden light bulbs are flickering. How can it be fixed?
I have this range hood. All of a sudden light bulbs are flickering. How can it be fixed?
(Posted by praveenkasam 5 years ago)
Remove And Change Light Bulb On Ge Jvw5301 Range Hood
Page 9 says use a flathead screwdriver to remove ring but does not tell you how to do this. Push, pu...
Page 9 says use a flathead screwdriver to remove ring but does not tell you how to do this. Push, pu...
(Posted by ltindle 6 years ago)
Ge Jvx3300 Range Hood. How Do I Remove The Light Bulb Cover?
There's a little picture showing that you should use a screw driver, but nothing beyond that. I'm af...
There's a little picture showing that you should use a screw driver, but nothing beyond that. I'm af...
(Posted by Dontcallmehowie 7 years ago)
The Lights Beneath The Hood
Are there two lights beneath the hood that can be set on high or low? Are they halogen? I want to b...
Are there two lights beneath the hood that can be set on high or low? Are they halogen? I want to b...
(Posted by ingrid85639 12 years ago)