GE JV694SBB Support Question
GE JV694SBB Support Question
Find answers below for this question about GE JV694SBB.Need a GE JV694SBB manual? We have 2 online manuals for this item!
Question posted by Jchapman3372 on August 22nd, 2021
Ge Jv694sbb Slide Guide Removal
Need to remove slide guides from GE JV694SBB. Have the slide glass removed along with filter and light. Because of the filth this was left in, l really need to remove the slide guide brackets. Not sure thats what they are called. Can anyone help please
Current Answers
Answer #1: Posted by SonuKumar on August 23rd, 2021 8:40 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,648,150
Member since:
May 9th, 2021 Points: 16,648,150
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related GE JV694SBB Manual Pages
Use and Care Manual - Page 1
... INSTRUCTIONS BEFORE USING. Use and Care & Installation Guide
36 ″ Vented Hood
Safety Instructions...Front Cover, 2
Operating Instructions.........2, 3
Automatic Heat Sensor 3 Controls 2
Cleaning 3
Filter 3 Light Bulb Replacement 3
Installation 4-6
Damper/Duct Connector 5 Electrical Wiring 6 Filter Panel 3, 5 Mounting Brackets 5, 6
Consumer Support ....Back Cover
Important Phone...
Use and Care Manual - Page 2
... OF INJURY
TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
A. B.
The fire department is pushed completely in the area where it started.
3.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. LIGHT-The light will turn your
hood unless it .
2. The blower speed is needed for a few minutes to operate it is...
Use and Care Manual - Page 3
... surface in the middle to remove
Light Bulb Replacement
This hood uses an F20T12 fluorescent tube and an FS-2 starter, which are properly seated in the tube holders.
DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS OR SCOURING POWDERS. Filter
Slide the glass visor open.
Glass visor Filter panel
Grasp filter and bend to remove it.
To clean the stainless...
Use and Care Manual - Page 4
...hood to the wall. NOTE: Remove the glass visor from the face to the inside of 24″ above the cooking surface. Rect. 45° elbow
x( ) =
Ft.
31⁄4″ x 10″ 33 Ft. The unit is ducted vertically. For easiest installation, the range hood...hood in the cabinet to horizontal ducting see the instructions. INSTALLATION INSTRUCTIONS
TOOLS YOU WILL NEED... new hood will ...Remove the...
Use and Care Manual - Page 5
... above. VISOR SLIDES
Pull the visor slides out.
Remove the access cover. Insert two (2) screws through the housing and into the opening with the slide control to the housing. Open the filter panel. Install the mounting brackets.
FRONT OF HOOD
Use two (2) screws (provided) to attach the connector to the front.
5.
Hold the left hand mounting bracket in the...
Use and Care Manual - Page 6
... adjustments to ground screw.
Install the mounting brackets (cont.).
12.
VISOR CLAMP
The visor slides each mounting bracket. Secure the access cover with the sides and front edge of the hood. 9. VISOR TRIM
VISOR SLIDE
Slide the glass into the other mounting bracket. Replace the wire box cover. Install the glass visor assembly. Shelves may be able to clear...
Use and Care Manual - Page 7
...provided by possible defects with the product.
• Replacement of the replaceable filters.
• Replacement of house fuses or resetting of circuit breakers.
•..., or call 800.GE.CARES (800.432.2737).
YOUR 36″ HOOD
WARRANTY
Staple sales slip or cancelled check here.
This warranty is needed to the original purchaser and any part of the hood that fails because of...
Use and Care Manual - Page 8
... parts or accessories sent directly to design for a wide range of your warranty, should be referred to be exercised, since improper servicing may also mail in the pre-printed registration card included in the United States GE Appliances Website
GEAppliances.com
Have a question or need arise. For the hearing impaired, please call 800...
Quick Specs - Page 1
....
GE Profile™ Slide-Out Hood
Installation Information and Dimensions (in cabinet to your Monogram,® GE Profile™ or
Listed by
GE® appliance questions, visit our website at
Underwriters
GEAppliances.com or call GE Answer Center®
R
Laboratories
service, 800.626.2000. Flush bottom cabinet
Recessed bottom cabinet
Amp Rating 120V 3.7
Note: Remove glass...
Quick Specs - Page 2
GE Profile™ Slide-Out Hood
Features and Benefits
• Black on black Model • 36" Vented Hood With Cooktop Light • See-Through Glass Visor Slides In and Out • 300 CFM Performance With Variable Speed Fan Control • Auto Heat Sensor • Compact Housing Leaves Ample Shelf Space Behind Cabinet ...
Similar Questions
Remove And Change Light Bulb On Ge Jvw5301 Range Hood
Page 9 says use a flathead screwdriver to remove ring but does not tell you how to do this. Push, pu...
Page 9 says use a flathead screwdriver to remove ring but does not tell you how to do this. Push, pu...
(Posted by ltindle 6 years ago)
Ge Jvx3300 Range Hood. How Do I Remove The Light Bulb Cover?
There's a little picture showing that you should use a screw driver, but nothing beyond that. I'm af...
There's a little picture showing that you should use a screw driver, but nothing beyond that. I'm af...
(Posted by Dontcallmehowie 7 years ago)
Our Electricity When Out Very Briefly. When It Came Back On, The Light On Our
GE range hood now flashes every 10 seconds or so. Is there a reset button? We have removed and repla...
GE range hood now flashes every 10 seconds or so. Is there a reset button? We have removed and repla...
(Posted by Taisam1 7 years ago)
Need A Manual To Install The Button.. Please Help.
(Posted by Anonymous-117001 10 years ago)
The Lights Beneath The Hood
Are there two lights beneath the hood that can be set on high or low? Are they halogen? I want to b...
Are there two lights beneath the hood that can be set on high or low? Are they halogen? I want to b...
(Posted by ingrid85639 12 years ago)