Home » GE » Laundry Dryers » GE GTDP300EMWS

GE GTDP300EMWS Support Question

Find answers below for this question about GE GTDP300EMWS.
Need a GE GTDP300EMWS manual? We have 3 online manuals for this item!

GE Overview Questions Manuals Reviews Videos Research

Question posted by dapp2008 on April 14th, 2014

Where Is Model/serial Tag Located On This Unit

Where is model/serial tag located on this unit?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on April 14th, 2014 2:18 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,407

1,100
points

You can find them on a label on the front of the dryer behind the door.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related GE GTDP300EMWS Manual Pages

Installation Instructions - Page 1

... 2 ELBOWS) 4" DIA. For Bathroom or Bedroom Installation, see section 3). Observe all installation instructions. • Clothes dryer installation must be exhausted to the outdoors. • Use only 4" rigid metal ducting for Installation of this appliance in any location where it must be UL listed and installed in accordance with the instructions found in...

Installation Instructions - Page 2

... above strain relief bracket). Remove the power cord cover located at the electrical box. 2. Keep the green ground screw for installation and service. 1 PREPARING FOR INSTALLATION OF NEW DRYER TIP: Install your dryer before installing your washer. Connect the 2 hot lines to an electric dryer. Properly secure power cord to the equipment-grounding terminal...

Installation Instructions - Page 3

...1. Tighten all conditions noted below . IN CANADA AND IN THE UNITED STATES, THE REQUIRED EXHAUST DUCT DIAMETER IS 4 IN (102mm). Using... the drying times and the energy cost. • Reduce the dryer life. • Accumulate lint, creating a potential fire hazard. ... CAP • Terminate in . Remove the power cord cover located at least 4 ft. Bring power cord through strain relief. ...

Installation Instructions - Page 4

... CABINET. ELBOW HIGHLY RECOMMENDED NOTE: ELBOWS WILL PREVENT DUCT KINKING AND COLLAPSING. 5 LEVELING AND STABILIZING YOUR DRYER STAND THE DRYER UPRIGHT NEAR THE FINAL LOCATION AND ADJUST THE 4 LEVELING LEGS, AT THE CORNERS, TO ENSURE THAT THE DRYER IS LEVEL FROM SIDE TO SIDE AND FRONT TO REAR. The male end of each section...

Installation Instructions - Page 5

..., floors or other enclosed spaces. • Total length of the transition duct. • In Canada and the United States, only the flexible metal(foiltype) ducts that comply with a clamp. 3. Installation Instructions CONNECTING THE DRYER TO HOUSE VENT RIGID METAL TRANSITION DUCT • For best drying performance, a rigid metal transition duct is recommended...

Installation Instructions - Page 6

...to secure the duct in place through the side opening , locate the tab in the base. Pull the duct out of the duct to the dryer internal duct . EXHAUST CAN BE ADDED TO LEFT OR ... that the shortened duct is aligned with 4" duct. Note: Only 4" round rigid metal ducting allowed inside dryer. TAB LOCATION BEND TAB UP 45 o ADDING ELBOW AND DUCT FOR EXHAUST TO LEFT OR RIGHT SIDE OF CABINET •...

Installation Instructions - Page 7

...where you removed the filler plugs). Open the door and remove the filler plugs opposite the hinges. Place dryer in step 1. 4. Cover back opening and connect it UP and OUT. 3. ADDING COVER PLATE TO... top screws from the dryer by moving the door IN and DOWN until the top hinge and the bottom hinge are resting on the top screws inserted in final location. With one hand holding...

Installation Instructions - Page 8

...WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION AFTER SERVICING/INSTALLATION. TO REGISTER YOUR DRYER CALL TOLL-FREE 1-888-269-1192 Prompt registration confirms your right to protection under...an additional two-thirds turn. Installation Instructions 11 CONNECTING INLET HOSES (on some models) To produce steam, the dryer must also connect to the cold water, a "Y" connector is inserted to...

Use and Care Manual - Page 1

... Safety Instructions 2-4 Operating Instructions Control Panel 5, 6 Control Settings 7 Features 8 Loading and Using the Dryer 10-11 Reversing the Door 9 Venting the Dryer 11 Troubleshooting Tips . . . 12, 13 Consumer Support Consumer Support 16 Warranty 15 Owner's Manual Write the model and serial numbers here: Model Serial You can find them on a label on the front of the...

Use and Care Manual - Page 2

.... Safety Instructions Operating Instructions Troubleshooting Tips WARNING! Gas appliances can be properly installed and located in accordance with all shipping materials properly. For your safety, the information in your...could cause permanent damage and invalidate the warranty. Exhaust/Ducting 1 Gas dryers MuST be exposed to temperatures below freezing or exposed to four of ...

Use and Care Manual - Page 3

... (such as cleaning cloths, mops, towels used in or near children. Some rubber materials, when heated, can reduce the flame retardancy of the dryer during subsequent dryer uses. Observe all laundry aids (such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.). There are many highly flammable items used by clothing...

Use and Care Manual - Page 5

... on the label on the front of exhaust ducts. 5 GEAppliances.com You can locate your model. About the dryer control panel. START PUSH TO START FABRIC CARE 3 Heat Settings COTTONS REGULAR HEAT EASY CARE MEDIUM HEAT AIR FLUFF NO HEAT Time Dry Cycle...type of heat used (Electric, Natural or lP gas), size of load, types of fabrics, wetness of clothes and condition of the dryer behind the door.

Use and Care Manual - Page 6

... type of heat used (Electric, Natural or lP gas), 6 size of load, types of fabrics, wetness of clothes and condition of the dryer behind the door. You can locate your model. Throughout this manual, features and appearance may vary from your model number on the label on the front of exhaust ducts. About the...

Use and Care Manual - Page 7

... 1 Fabric Care/Temperature (on some models) or select the Preferred Regular Setting marked with the same color on the Cycle Dial. HEAT MEDIUM, For synthetics, blends, delicates and items labeled permanent press. HEAT, EASY CARE or PERMA PRESS MED. Select lESS DRy if you use the dryer. Timed cycles run for this...

Use and Care Manual - Page 8

... Signal especially when drying fabrics like polyester knits and permanent press. If the dryer drum should be scratched or dented during the WRINklE CARE cycle. This option can only be used to remove the laundry. Cycle Signal Option (on some models) This signal will sound several times during this time to remind you...

Use and Care Manual - Page 10

... Cleaning of the hood move freely when operating. Stainless Steel: To clean stainless steel surfaces, use in all GE Dryers when used in accordance with the hose attachment and reconnect the duct. A partially clogged exhaust can lengthen the drying time... these products away from the outside that there is not covered by some laundry pretreatment soil and stain remover products.

Use and Care Manual - Page 15

...warranties of charge, all labor and related service costs to an Authorized GE Service location. louisville, ky 40225 Troubleshooting Tips Consumer Support 15 Staple your state's Attorney ... and you may also have serial number and model number available when calling for home use the product. Safety Instructions Operating Instructions GE Dryer Warranty. n Replacement of the...

Quick Specs - Page 1

... Center® service, 800.626.2000. ft. GTDP300EM GE® 7.0 cu. ft. ft. Note: Dryer wall outlet must be located within 36" of the side panel to the front. 25-1/2" from front to your dryer. 5.7 cu. Back View Washer/Dryers SC QSart Power Cord Hole 4-1/2 Back View Listed by a 30-amp circuit breaker or...

Quick Specs - Page 2

... instructions packed with your dryer is 52". • Closet doors must be exhausted to the outdoors. • The installation must also be located at least 12" above...sq. rigid metal duct Exhaust hood type B Domestic 2-1/2 dryer models 7.0, 6.0 and 5.8 cu. Dryers must contain a minimum of local codes, with a gas dryer. Specification Created 7/10 370188 A UL-listed flexible metal...

Quick Specs - Page 3

... more flexible installation • Interior dryer light - capacity DuraDrum™ electric dryer Features and Benefits • Auto Dry - Convenient interior light helps you when the load is done, so clothes can be removed before wrinkles set cycles • 4 heat selections - ft. Alerts you easily see clothes • Model GTDP300EMWS -White on white GTDP300EM_GM GTDX300EM_GM...