GE AZ61H12DAB Support Question
GE AZ61H12DAB Support Question
Find answers below for this question about GE AZ61H12DAB.Need a GE AZ61H12DAB manual? We have 1 online manual for this item!
Question posted by jdrb on September 2nd, 2012
Unit Does Not Cool
Worked very well for almost 2 years (installed new in October 2010). Last night stopped cooling. No odd noises or change in operation except for no cool air. I can hear what sounds like the compressor turning on and fan goes to HIGH speed but no cool air, just ambient warm air.
Requests for more information
Request from Chattababy34 on September 13th, 2020 2:30 PM
did u ever get any information on ur unit not cooling? Mine is doing the same thing..
did u ever get any information on ur unit not cooling? Mine is doing the same thing..
Current Answers
Related GE AZ61H12DAB Manual Pages
Owners Manual - Page 1
... #
Serial #
Find these numbers on a label behind the room cabinet on the base pan.
IB-16
Installing the Zoneline ......... 17, 18
Optional Drain Kit
19
Preparation
11
Replacing an Existing Unit? ........ 12
Troubleshooting Tips ...... 20, 21
Normal Operating Sounds ......... 22
Consumer Support
Consumer Support ........
GEAppliances.com
Q
QJ
0
N
0
0_
0_
Safety Instructions...
Owners Manual - Page 2
...it is used.
Replacing an existing unit? SAFETY PRECAUTIONS
This Zoneline must be performed bg a qualified individual.
• These R410A air conditioning sgstems require contractors and technicians to...or connector end. DO NOT use with a new power supply cord obtained from the manufacturer and not repaired.
For details, see the Installation Instructions in this manual. A damaged power ...
Owners Manual - Page 3
... set temperature will decreasein the same manner. MODE--COOL--For cooling FAN--For fan-only operation HEAT--For heating
OPERATION--ON/STOP--Turtnhse unit on or off to STOPand then restart the unit. If the flashing light reappears within 30 minutes, coil for 8 hours before the compressor and stops after the compressor cycles off.
When the outdoor temperature is lower...
Owners Manual - Page 4
...position, some outdoor air will reduce the heating or cooling efficiency. Energy Tip...Air Direction
To change the air direction.
4
Louvesrcrews
Default position Flipthe louver insert 180° replace the screws and the room cabinet. Open position
l
When set at the closed position.
Louverscrews
Remove the room cabinet and flip the louver insert to use ..Seethe Installation...
Owners Manual - Page 5
Auxiliary controls on .To change modes, press AU,_SET('AU" appears on the display).Pressthe mode button on /off / B'_ - Removethe room cabinet. The COOLLED light on the main control will be turned ON or OFFwith the unit controls. This is shown in the second digit of the display for Mode I HEAT
_7
Eu
Load...
Owners Manual - Page 6
...turning the air conditionerONat 85% and OFFat 80%.
ressMODEuntila 6 appears in the seconddigitat thedisplay.PressAUXSETtocontirmyour selectionand exitAUXSETmode,or pressMODEto continue settingotherfunctions.
FAN HEAT
FreezSe entineOl FF
/COOL...WallThermostatP. NOTET: hesefunctions are active wheneverthe unit is
plugged in, evenif the unit is in the STOPposition.Pressthe down arrowfor...
Owners Manual - Page 7
...isusedwhenthe unit is... is OFF. Damage or erratic operation may damage the Zoneline electronics. ...AUXSETmode.
HighSpeed Fan
Green- If the unit isducted,the DuctNode needsto be usedwith remotethermostatoperation...V AConly Solenoid(AZ61only)
Green-
E_] Turnoff and unplugthe unit.
[] Removethe roomcabinet.Seethe ToRemovethe RoomCobinetsection.
[_] Removethe screwfrom the...
Owners Manual - Page 8
... AConly J
Green- Compressor
White- o01 0o 0.1o
I__J
[-- NOTE:ThCe lass2 Nodesetting(Node6) mustbe setto ON"n" for the unitto operatewith a Class2 Remote Wall Thermostat. (Seethe installation instructions supplied with Heat...Forthis reason,the unitswill operate slightlydifferentlywhenconnectedto a remote thermostat.Thefollowingchart showsthe unit operation when connectedto a remotethermostat...
Owners Manual - Page 9
... door is not removable. Room Cabinet and Case Turn the Zoneline off and unplug before cleaning,
i
....
Base Pan
In some areas of the outdoor coil.
ji
To clean the vent filter:
IMPORTANT:
This filter is open,access requiresthe removal of the unit),
In some installations, dirt or other debris may be checked regularly...
Owners Manual - Page 10
...; Decreasecost of operation.
• Saveenergu. • Prevent clogged heat exchanger coils. • Reducethe risk of the unit. To maintain...cooling, heating, airflow and efficiency of premature component failure. Careand cleaning. Air Filters
To remove the air filters:
2 Air filters
Pullup_
Dirty filter--Needs cleaning
Clogged filter--Greatly
reducescooling, heating and airflo_z
Turn...
Owners Manual - Page 11
...unit is in the OFF position, there is not covered under the Warrantg. Disconnect the power to the electrical controls.
Call 800.GE.CARES (800.432.2737) or visit our Websiteat:GEAppliances.com
I Questions? Savethienssetructfionr s
local inspector's use an extension cord with the owner.
• Note to Installer -
Installation Instructions
Zoneline Air Conditioners...
Owners Manual - Page 12
... RAK601/602
Existing ducted installation: Replocement of condensotion forming bu instolling insulotion kit RAKgOIL,ovoiloble where you purchosed the unit. NOTE:There ore severol extro holes in the unit side flonges for
importantinformation,
Use the correct wall case This unit is ploced in o new ducted opplicotion using o duct kit, gou must olwoys turn Mode 7 to operote...
Owners Manual - Page 13
... Rating
15
20 30
Proper GE Power Cord with a power supplg kit or a junction box kit. The device should be installed using one of the following electrical subbases:
Branch Circuit and Unit Amperage Rating
15
20 30
Proper GE Subbase Kit RAK204D15P
RAK204D20P RAK204D30P*
*Not approved for use of 208 or 230...
Owners Manual - Page 14
... inside the providedjunction box must be done in accordance with the following steps.
Use the POWERCONNECTIONCHARTon page 16 to the "MAKE ELECTRICALCONNECTION TO THE UNIT" section.
FOR SUBBASE INSTALLATION
Electrical subbase kits are available to a branch circuit MUSTbe done bg direct connection in accordance with the selected subbase kit must be carefullg...
Owners Manual - Page 15
...bottom and driving the two screws until secure.
Placethe junction box cover in the unit mating connector. Replacethe two screws removed earlier and tighten securelg.
15 Removethe junction...the sides are no loose connections or strag uninsulated wires exposed.
2. Installation Instructions
MAKE ELECTRICAL CONNECTION TO THE UNIT
m REMOVE JUNCTION BOX
1. Note how the tabs on the lower ...
Owners Manual - Page 19
..."A" screw for metal case or
Type"B"screwfor moldecdase
19 Installation Instructions
OPTIONAL--DRAIN KIT INSTALLATION
Dry Air 25 Series models are designed to improve dehumidification by 25...air, there is a greater possibilitg that water will drip from dripping onto external building walls, we recommend the use of RAD10 Drain Kit. To prevent this water from the wall case than with a standard unit...
Owners Manual - Page 20
... and make sure that the yellow connector on the surface
of heating operation
of the heating element.
• This can cause the unit to cycle off due to the compressor overload protector.
• Outdoor grille must have been hot or cold. The air filter is waiting for the compressoroverload protector to reset. Consult your...
Owners Manual - Page 21
... page 5.
The Smart Fan Au×iliarg
• See Smart Fan -
GEAppliances.com
Problem The air is not always cool or hot during operation
The air does not feel worm enough during heating operation
The unit is not blowing out air The electric heating feature does not work
Temperature display flashes
Possible Causes The heat pump is normal.
Owners Manual - Page 22
... the compressor starts at any thermostat setting.
22 During the defrost cycle, both indoor and outdoor fans stop and start. Normal Operating Sounds
pI NG! This will operate in the base pan during high humidity or on rainy days or when the humidity is due to change the room temperature. "CLICK" DRIP
6
WHIRl
You may hear relays...
Owners Manual - Page 23
...year warranty, GEwill also provide, free of the original purchase dote is of the sealed refrigerating sgstem(the compressor,condenser,evaporator and all labor and related service to replace the defective part.
If SOUhave an installation problem, or if the air conditioner...• In commercial locations, labor necessarg to move the unit to a location where it is accessible for any labor or...
Similar Questions
Az61h12dabw1
y does 6 of my units heater blow cold air no heat pumps in my units worked great last year ac great ...
y does 6 of my units heater blow cold air no heat pumps in my units worked great last year ac great ...
(Posted by lancesgirl77 5 years ago)
Ge Portable Air Conditioner Does Not Cool
(Posted by alhein 10 years ago)
How To Get The Hose To Work On A Ge Portable Air Conditioner
(Posted by babkall 10 years ago)
Ge Aem12apw1 12000btu Air Conditioner
This a/c has stopped blowing cold air and its only 2yrs old. I've tried setting the unit on 75deg To...
This a/c has stopped blowing cold air and its only 2yrs old. I've tried setting the unit on 75deg To...
(Posted by Nirpno 10 years ago)