GE 240 COE Support Question
GE 240 COE Support Question
Find answers below for this question about GE 240 COE - Carbon Monoxide Alarm.Need a GE 240 COE manual? We have 1 online manual for this item!
Question posted by attamohammad2003 on December 27th, 2011
240-coe Unit, Date Code 0544t Beeps And Blinks Green Light. Is There Replacement
My 240-COe unit just started beeping every 5 minuts with blinking green light. Once I press reset button, it stays quite for about 24 hours and start beeping again. Can it be fixed or needs to be replaced. What is a good hard wired replacement?
Current Answers
Answer #1: Posted by mike21781 on January 28th, 2012 8:48 AM
mike21781
Member since:
January 28th, 2012 Points: 2,250
Member since:
January 28th, 2012 Points: 2,250
According to GE:
http://www.alarmsbc.com/pdf/gasdetector/esl_250co.pdf
http://www.alarmsbc.com/pdf/gasdetector/esl_250co.pdf
End of sensor life indicator:
The detector uses both a flashing green LED and intermittent sounder chirps to indicate that the detector needs replacing. To silence the detector, push the test/hush button. The detector also begins signaling a trouble when the CO sensor is approaching end-of-life. When connected to a Listed control panel, the trouble relay can report a trouble condition locally at the panel and optionally at the central station, if the system is monitored.Related GE 240 COE Manual Pages
Installation Instructions - Page 1
... wire to the National Electric Code (NEC) and/ or local codes having jurisdiction. The unit beeps 4 times, rests 5 seconds, then repeats the pattern.
The ESL CO alarm alerts the user with fire and/or security devices. Carefully remove the cover from the alarm by detaching one alarm should install an alarm in this document.
ESL 240-COe
Use the following guidelines...
Installation Instructions - Page 2
... properly, the ESL CO alarm will not be tested regularly to press the test button through the Test/Hush verification.
ESL 240-COe
To test the relay contacts and panel, continue to verify that it is functioning properly. The LED should continue to the CO alarm sensitivity limits of UL2034. * Note: Units installed at the top of...
Installation Instructions - Page 3
... internal air. −Vent pipe connections vibrating loose from the open or closed attached garage or near a home.
Important: The alarm automatically resets to produce an alarm.
Do not reenter the premises nor move to your alarm reactivates within a 24 hour period, repeat steps 1-3 and call a qualified appliance technician to save themselves by an open a couple of...
Installation Instructions - Page 4
...rapid beeps every 5 seconds.
Press the TEST/HUSH button to monitor carbon monoxide levels.
CO may not awaken if the alarm is functioning properly. Closed or partially closed doors, could delay or prevent the alarm being activated. We recommend that the sensor may not be present in the hallways between them. Reminder - Installation Date: Distributor
Model Number 240-COe 240-COe...
Similar Questions
What Does It Mean When Your Carbon Monoxide Alarm Beeps And Blinks Green
(Posted by stfox 9 years ago)
Where To Buy Carbon Monoxide Alarm Model 240-coe
(Posted by alewMufa 10 years ago)
How To Change Battery In Carbon Monoxide Alarm 240 Coe
(Posted by alandave 10 years ago)
How To Replace Carbon Monoxide Alarm Battery, 240-coe
(Posted by ihateCuriou 10 years ago)
240 Carbon Monoxide Alarm
my alarm beeps but does not go in to alarn is this a bad unit
my alarm beeps but does not go in to alarn is this a bad unit
(Posted by kenmack69 12 years ago)