Can I Only Charge My Nuvi 66 Let In My Car? I'm Using It For The First Time And

Charging the Device NOTE: This Class III product shall be powered by an LPS power supply. You can charge the battery in the device using any of these methods. • Connect the device to the vehicle power cable. • Connect the device to a computer using a USB cable. The device may charge slowly when connected to a computer. Some portable computers may not charge the device. • Connect the device to an optional power adapter accessory, such as a wall power adapter. You can purchase an approved Garmin AC-DC adapter suitable for home or office use from a Garmin dealer or www.garmin.com.. 4 Gently wipe the screen with the cloth. Avoiding Theft • Remove the device and mount from sight when not in use. • Remove the residue left on the windshield by the suction cup. • Do not keep your unit in the glove compartment. • Register your device at http: / / my .garmin .com. Mounting on Your Dashboard NOTICE The permanent mounting adhesive is extremely difficult to remove after it is installed. You can use an optional mounting disk to mount your device to the dashboard and comply with certain state regulations. See www.garmin.com for more information. 1 Clean and dry the dashboard where you are placing the disk. 2 Remove the backing from the adhesive on the bottom of the disk. 3 Place the disk on the dashboard. 4 Remove the clear plastic cover from the top of the disk. 5 Place the suction cup mount on top of the disk. 6 Flip the lever down (toward the disk). Changing the Fuse in the Vehicle Power Cable NOTICE When replacing the fuse, do not lose any of the small pieces and make sure they are put back in the proper position. The vehicle power cable does not work unless it is assembled correctly. If your device does not charge in your vehicle, you may need to replace the fuse located at the tip of the vehicle adapter. 1 Rotate the end piece À 90 degrees counter clockwise to unlock it. Removing the Device, Mount, and Suction Cup Removing the Device from the Mount 1 Press the release tab or button on the mount. 2 Tilt the device forward. TIP: You may need to use a coin to remove the end piece. 2 Remove the end piece, the silver tip Á, and the fuse Â. 3 Insert a new fast-blow fuse that has the same current, such as 1 A or 2 A. Removing the Mount from the Suction Cup 1 Turn the device mount to the right or left. 2 Apply pressure until the socket on the mount releases the ball on the suction cup.