Garmin GPSMAP 441/441s Support Question
Garmin GPSMAP 441/441s Support Question
Find answers below for this question about Garmin GPSMAP 441/441s.Need a Garmin GPSMAP 441/441s manual? We have 8 online manuals for this item!
Question posted by Marvin7 on May 6th, 2012
Sonar
Last year I purchased a Garman 441s and used it on my 19ft. boat. It worked fine. I just reinstalled it on a 21ft. boat when I checked the sonar it read 000 after a little while it read somwhere around 9ft. the boat is on a trailer no more than a foot and a half off the ground is this normal or do I need to adjust something or will it operate properly once the boat is in the water.
Thanks Vinny
Current Answers
Related Garmin GPSMAP 441/441s Manual Pages
Installation Instructions - Page 1
.... Use this...GPSMAP 400/500 series...GPSMAP 420/430/430x/440/440x/450 GPSMAP 520/525/530/535/540/545/550/555 GPSMAP 421/441/451 GPSMAP 431/531 GPSMAP... 521/526/536/541/546/551/556
NMEA 2000 No No Yes No Yes
NMEA 0183 Yes Yes Yes Yes Yes
Garmin CANet Yes Yes No No No
Sonar...use your Garmin dealer immediately. Mount the ...
Installation Instructions - Page 6
...To 10-32 Vdc* boat supply
23A
3. Connect the black (- Install or check the 3 A fuse (in the in -line fuse holder on the diagram.)
3 A fuse Boat ground
+ -
To the GPSMAP 400/500 series chartplotter
...Power
1.
Notice: The maximum input voltage is necessary to extend the power and ground wires, use the boat fuse block, remove the in -line fuse holder, or on connecting to a NMEA 2000...
Installation Instructions - Page 7
...(in ) wire to use NMEA 0183 data (standard or high speed). Repeat step 2 using the grey and violet wires for more information. Refer to the Power section of your NMEA 0183 device. GPSMAP 400/500 Series Installation ... The maximum current is 100 mA, and a relay is needed to limit the current from the GPSMAP 400/500 wiring harness to the NMEA 0183 in (or Rx/A +) wire on the wiring harness ...
Installation Instructions - Page 8
... your compatible chartplotter(s) as you must purchase an optional CANet Kit. See www.garmin.com for more cable is NMEA 2000-compatible, you want to a single chartplotter, whereas a CANet connection provides full sonar readings, including Ultrascroll™, so you can on your local Garmin dealer or marine dealer. Using the CANet optimizes the performance of...
Installation Instructions - Page 9
... Installation Because water is necessary to carry the sonar signal from the sounder, the transducer must be used for all installations.
➋ ➌
➌ ➊➎
GPSMAP 421, 441, and 451
➌ ➊
GPSMAP 430x and 440x
➍ ➊
GPSMAP 420, 430, 431, 440, and 450
➋ ➌
GPSMAP 530, 535, 540, and 545
➋➊
➊...
Installation Instructions - Page 10
...boat to be working properly, gradually increase the speed of the boat while
observing the operation of the sky.) GPSMAP 420/430/440/450 (s) GPSMAP 520/530/540/550/525/535/545/555 (s): Warm*: Approximately 15 seconds Cold**: Approximately 45 seconds
GPSMAP 421/431/441/451 (s) GPSMAP... to IEC 529 IPX7 standards.
If the sonar signal suddenly is lost . Specifications
Physical Specifications...
Technical Reference for Garmin NMEA 2000 Products - Page 28
... will provide a more -accurate reading. Carefully compare information displayed on your boat according to the tank. While ...fuel to the GFS 10 Installation Instructions.
Select either GPS Speed or Water Speed to specify which speed sensor ...Using Fuel-Level Information With a Garmin Chartplotter or Marine Instrument To receive fuel-level information, connect the wiring harness on your boat...
Owner's Manual - Page 3
...GPSMAP® 431/431s GPSMAP 531/531s GPSMAP 541/541s
GPSMAP 441/441s GPSMAP 536/536s GPSMAP 546/546s
Tips and Shortcuts
• Press HOME from any screen to return to the Home screen.
• Press MENU from any of items on the screen using...: page 28. • Creating and Using Waypoints: page 30. • Configuring System Settings: page 48. • Using Sonar: page 57. • Alarms and ...
Owner's Manual - Page 4
... Using the Keypad 5 Acquiring GPS Satellite Signals 5 Using ...Using the Split Navigation Chart 15 Using Perspective 3D 15
ii
Using Mariner's Eye 3D 16 Using Fish Eye 3D 18 Using Fishing Charts 19 Enabling High Resolution Satellite Imagery 19 Viewing Aerial Photos 20 Animated Tide and Current Indicators 21 Detailed Road and POI Data 21 Using Automatic Guidance 22 Using the Chart/Sonar...
Owner's Manual - Page 8
See "Initializing Unit Settings" (page 3). Getting Started
NMEA 2000®
External GPS antenna Power/Data
GPSMAP 431
Turning the Unit On or Off
To turn on your unit, you turn off the unit, press and ... on the unit, press and release the Power key. Note: The first time you must configure the initial settings.
GPSMAP 441/541
Home Screen
GPSMAP 400/500 Series Owner's Manual
Owner's Manual - Page 11
... indicated. GPSMAP 400/500 Series Owner's Manual Acquiring GPS Satellite Signals...sonar. Press and release to adjust the range of actual satellite signals. RANGE (-/+)-Press to adjust the backlight and day and night modes. Press to zoom in simulator mode.
Warning Do not try to mark a waypoint at your current location.
MARK-Press to navigate using simulator mode, because the GPS...
Owner's Manual - Page 13
... a GPSMAP 441s) with a connected transducer to use sonar features.
• Chart/Sonar-set up the screen to the Home screen.
• Charts-selects Navigation, Fishing, Perspective 3D, Mariner's Eye 3D, Fish Eye 3D, and Split Navigation charts. Understanding the Home Screen
Use the Home screen to the most-current version MapSource or HomePort by clicking Help > Check for...
Owner's Manual - Page 15
GPSMAP 400/500 Series Owner's Manual
Using Charts
Data Bars-show on or off .
Waypoints & Tracks-view, add, and configure waypoints...information about other vessels if your destination (only available while navigating). Data bars
• Cruising-turn the GPS Speed, GPS Heading, Depth, and GPS Position data bar on the cruising data bar.
Select Data Bar Setup to choose different data to...
Owner's Manual - Page 24
...or off to a weather module and you have an "s" series unit (such as fish). Using Charts
Range Rings-toggles the range rings on or off . This setting also affects routes (Route... by your transducer on or off . Fish Symbols (only available if sonar is present)-displays suspended targets (such as a GPSMAP 441s) with a connected transducer to adjust the view.
Safe Depth-adjusts the...
Owner's Manual - Page 27
...region.
To do so, information for the Tides/Currents setting (page 12). GPSMAP 400/500 Series Owner's Manual
Using Charts
An indicator for animated tide station and current direction on the chart.... station appears above the direction indicator. For
21 To access aerial photos from the Navigation chart: Use the Rocker to 2 knots
2 or more . When you move the cursor over the tide ...
Owner's Manual - Page 33
... See "Calling an AIS Target" (page 67).
GPSMAP 400/500 Series Owner's Manual
Using Charts 27 Viewing a List of the AIS boats and is sorted by range. Select Navigation Chart, Fishing Chart, Perspective 3D, or
Mariner's Eye 3D. 3. The AIS list shows the MMSIs or (if the boat is monitoring. Select MENU > Other Vessels > AIS...
Owner's Manual - Page 41
...GPSMAP 441/441s, GPSMAP 536/536s, GPSMAP 541/541s, and GPSMAP 546/546s).
In addition to detailed marine charting, BlueChart g2 Vision has the following features:
• Mariner's Eye 3D-provides a view from the SD card to your PC. NOTE: Autopilot can be used...GPS units and when using HomePort. Note: You cannot transfer BlueChart g2 Vision data from above and behind the boat for backup. GPSMAP...
Owner's Manual - Page 52
...slot on the front of the following:
• Select the file name from the SD card to the
GPSMAP 400/500 Installation Instructions.)
Only the following :
• Select Clone User Data to transfer waypoints, routes...of the following units are NMEA 2000 compatible:
GPSMAP 441/441s GPSMAP 541/541s
GPSMAP 536/536s GPSMAP 546/546s
2. Enter the file name using the Rocker, and press SELECT.
4.
Owner's Manual - Page 63
... what is organized as fishfinders:
GPSMAP 431s GPSMAP 441s GPSMAP 531s GPSMAP 536s GPSMAP 541s GPSMAP 546s
Understanding the Full Screen
Select the Full Screen option to view a full-screen graph of the
transducer's sonar readings.
Sonar information flashes on a circular depth scale. It is beneath your boat. Depth of the sonar return. (When using the white default color scheme, red...
Owner's Manual - Page 84
... acquisition times for a stationary receiver with a clear view of the sky) GPSMAP 431/431s GPSMAP 441/441s GPSMAP 531/531s GPSMAP 541/541s
Warm:* Approximately 1 second Cold:** Approximately 38 seconds
GPSMAP 536/536s GPSMAP 546/546s
Warm:* Approximately 15 seconds Cold:** Approximately 38 seconds
*Warm: your...was turned off, or it has been turned off for more than 2 weeks. GPS Accuracy: Position:
Similar Questions
Gpsmap 441s Power Doesn't Work
my gpa is about 20 years old. I tried plugging the cable in to the back of the unit and it doesn't p...
my gpa is about 20 years old. I tried plugging the cable in to the back of the unit and it doesn't p...
(Posted by Readsmith 2 years ago)
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
Is The Garmin 441s Compatable With Homeport.
I can transfer the homeport data to my computer, but I cannot transfer the mapping from the garmin t...
I can transfer the homeport data to my computer, but I cannot transfer the mapping from the garmin t...
(Posted by skindeep 8 years ago)
How Do I Get My Garmin 441s To Show My Location
my gps is showing that im in miami while im in turks and caicos
my gps is showing that im in miami while im in turks and caicos
(Posted by bradreece1 11 years ago)