Garmin AIS 600 Support Question
Find answers below for this question about Garmin AIS 600.Need a Garmin AIS 600 manual? We have 3 online manuals for this item!
Question posted by amrith54 on February 27th, 2014
Ais 600
Dear Sir Please Tell Me The Srm Connection In Ais Connected To
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Garmin AIS 600 Manual Pages
Technical Reference for Garmin NMEA 2000 Products - Page 3
.../5x6 Series chartplotters ◦ GMI™ 10 ◦ GPS 17x ◦ GFS™ 10 ◦ GRA™... 51 ◦ VHF 200/300 ◦ AIS 300 ◦ AIS 600
Note: PGN information is a checklist. Sensor ...PGN) information for Garmin chartplotters and marine instruments as well as configuration and...NMEA 2000 Fundamentals, provides descriptions of connected NMEA 2000 devices that communicate using...
Technical Reference for Garmin NMEA 2000 Products - Page 4
...
NMEA 2000-Certified Display Device PGN Information...13
NMEA 2000-Certified Sensor PGN Information...18 GPS 17x (GPS Antenna)...18 GFS 10 (Garmin Fuel Sensor)...18 GRA 10 (Garmin Rudder Angle Adapter...)...20 GHP 10 (Marine Autopilot System)...20 GXM 51...21 VHF 200...21 VHF 300...21 AIS 300...22 AIS 600...22
NMEA 2000-Certified Sensor Configuration Information...23 GPS 17x (GPS Antenna)...23 GFS 10...
Technical Reference for Garmin NMEA 2000 Products - Page 7
... understand the following concepts:
• Linear backbone construction (page 4) • Power connection and distribution (page 5) • Proper termination (page 7) • Cable length...)
Fuel sensor
Marine instrument
Chartplotter
Intelligent transducer
Ignition or in-line switch
Fuse
Female terminator
+
- others may require a separate power connection. Consult the installation...
Technical Reference for Garmin NMEA 2000 Products - Page 13
... Dynamic 127489 - Eng Dynamic 127488 - Rudder 130576 - Eng Dynamic 127489 - Eng Dynamic (GPS Speed or Water Speed) Note: The Fuel Economy data type is necessary or a specific combination... of data types that you have installed and configured. Eng Dynamic (GPS Speed or Water Speed) 127505 - GNSS Position, 129284 - COG/SOG, 129029 - GNSS Position, ...
Technical Reference for Garmin NMEA 2000 Products - Page 17
... Garmin NMEA 2000-certified display devices.
Rapid Update
129026 COG & SOG - Rapid Update
129029 GNSS Position Data
129038 AIS Class A Position Report
129039 AIS Class B Position Report
129040 AIS Class B Extended position report
129539 GNSS DOPs
129540 GNSS Sats in View
129794 AIS Class A Static and Voyage Related Data
129808 DSC Call Information
129809...
Technical Reference for Garmin NMEA 2000 Products - Page 22
... 060928 126208 127489 127497 127505
127505
Fluid Level (when calibrated using a Garmin chartplotter or marine instrument)
GRA 10 (Garmin Rudder Angle Adapter)
Transmit
Receive
059392
ISO Acknowledgment
059392
060928
ISO Address Claim
059904
126208
NMEA - GPS 17x (GPS Antenna)
Transmit
Receive
059392 060928 126208 126464 126992 126996 129025 129026 129029 129539 129540
ISO...
Technical Reference for Garmin NMEA 2000 Products - Page 25
...
126996
129038
129040 129798 129799 129799 129808
ISO Acknowledgment ISO Address Claim NMEA Request/Command/Acknowledge Group Function PGN List
Product Information
AIS Class A Position Report
AIS Class B Extended Position Report AIS SAR Aircraft Position Report Radio Frequency/Mode/Power Radio Frequency/Mode/Power DSC Call Information
Technical Reference for Garmin NMEA 2000...
Technical Reference for Garmin NMEA 2000 Products - Page 28
... the fuel-flow rate, you must be powered on the fuel-flow rate. Select either GPS Speed or Water Speed to specify which speed sensor is used on the NMEA 2000 device ...the GFS 10 device that is connected to the fuel tank you want to configure. 2. Using Fuel-Level Information With a Garmin Chartplotter or Marine Instrument To receive fuel-level information, connect the wiring harness on the ...
ML Declaration of Conformity - Page 1
... 66062
Sijhih, Taipei County,
U.S.A
TAIWAN, R.O.C.
GARMIN (Europe) Ltd.
Issued: 06/01/2010 Revised: Page: 1 of 1
DECLARATION of CONFORMITY
Application of Equipment: Model Number(s):
Marine Transceiver Apparatus AIS 600
The undersigned does hereby declare that the equipment complies with the above Directives
Nic Bowler Quality Manager Garmin (Europe) Ltd. Liberty House,
Hounsdown...
Instructions - Page 1
... be connected to your country to ensure that the power output to excessive radiofrequency fields. See www.garmin.com/prop65 for this system, which the AIS 600 is ...Rev. Compare the contents of California to program and install the Garmin® AIS 600 marine Automatic Identification System (AIS) Class B transponder device. If any compass.
Failure to observe these instructions ...
Instructions - Page 2
... using the included mini USB cable.
2. Connecting the AIS 600 to the AIS 600, the MMSI number cannot be reprogrammed if necessary.
1. Launch the AIS 600 Setup Software. To assign an MMSI number to the AIS 600: Note: After you installed the software.
3.
The MMSI number must be programmed by an authorized marine-electronics dealer or installer.
On the Static...
Instructions - Page 3
...
Notes: * The AIS 600 must receive GPS information from a separate antenna, such as a GPS 17x.
** The AIS 600 does not need to be connected to VHF antenna (not included)
AIS 600
RF interconnect cable (included)
GPS 17x GPS antenna* (not included)
VHF radio** (optional - not
included)
SRM cable - not
included)
Silent-mode switch (optional -
AIS 600 Wiring Layout: AIS 600 Connected to...
Instructions - Page 4
AIS 600 Wiring Layout: AIS 600 Connected to a Garmin Chartplotter through NMEA 0183
GA 30 GPS antenna* (included) RF cable to a non-garmin chartplotter, see page 8 for detailed wiring assignments.
AIS 600 Instructions not included)
SRM switch (optional - not
included)
AIS 600 transceiver box
Silent-mode switch (optional - not included) See page 8 for the NMEA 0183 Port 1 input on a ...
Instructions - Page 5
... box. 3. Install and connect the GA 30 GPS antenna (page 6). 5. The AIS 600 will then toggle on the power/data wiring harness is a 5 A, fast-acting fuse.
• If it is necessary to extend the power wires, use a pencil to install the AIS 600 device. Add a silent-mode switch or a Safety Related Message (SRM) switch (optional - Selecting Locations...
Instructions - Page 6
... a clear view of the sky in all , then you must install the included GA 30 GPS antenna and connect it to the AIS 600 according to the GA 30.
7.
Route the cable through the surface-mount bracket.
2. • If the AIS 600 is wired to a non-Garmin NMEA 0183 chartplotter, or not wired to a chartplotter at...
Instructions - Page 7
...
7. Secure the antenna to the adapter with the cable run the cable through a NMEA 2000 network. Connecting a VHF Antenna to the AIS 600
To transmit and receive AIS information, the AIS 600 must be connected to the GA 30 antenna.
4. Connect a marine VHF antenna to www.garmin.com/garmin/cms/us/onthewater/nmea2000, and click on the "Manuals" hyperlink...
Instructions - Page 8
... diagram below to connect the
AIS 600 to a Silent-Mode Switch When in the wiring layout diagram on the AIS 600 and broadcast your position will only receive AIS signals; Wiring the AIS 600 to a Physical Switch to Send a Safety-Related Message (SRM) or Enter Silent Mode (Optional)
Wiring the AIS 600 to a non-Garmin chartplotter. Using the AIS 600
If you will...
Instructions - Page 9
... Class B Extended Position Report AIS Class A Static and Voyage Related Data AIS SAR Aircraft Position Report AIS Safety Related Broadcast Message AIS Class B "CS" Static Data Report, Part A AIS Class B "CS" Static Data Report, Part B
NMEA 0183 Communication Information When connected to 80°C)
Cable:
Foil-shielded, center conductor 18 AWG
AIS 600 Instructions
GA 30 Specifications...
Instructions - Page 10
... transmit without a GPS signal, without an MMSI number, when an AIS base station commands a quiet time, or when the AIS 600 encounters a critical ... due to http://my.garmin.com.
Connect the AIS 600 device to a PC and use the AIS 600 Setup Software to comply with Industry Canada...an AIS message. Flashes when the device transmits an SRM. LED Label All OK RX TX RX Only
Warning
SRM ...
Instructions - Page 11
...the GPS unit. • Consult the dealer or an experienced radio/TV technician for warranty repairs. Garmin makes no charge to the customer for the AIS 600
...Regulatory markings have been applied to this device has been approved for use . • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect...
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
The Driver Files Are Missing From My Cd
the driver files are missing from my cd
the driver files are missing from my cd
(Posted by jkproductions24 6 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 11 years ago)
Connection Between Ais 600 And Chart Plotter 750
How do i get my ais 600 to talk to my chart plotter 750? Instalation correct but soft ware seems at...
How do i get my ais 600 to talk to my chart plotter 750? Instalation correct but soft ware seems at...
(Posted by rlcady 12 years ago)
Ais600 Wiring To Plotter
have connected ais600 to garmin700 plotter and plotter to silva dsc s15 vhf ais starts and goes to a...
have connected ais600 to garmin700 plotter and plotter to silva dsc s15 vhf ais starts and goes to a...
(Posted by smith42488 12 years ago)