Frigidaire PLD4375RFC Support Question
Frigidaire PLD4375RFC Support Question
Find answers below for this question about Frigidaire PLD4375RFC - Fully Integrated Dishwasher.Need a Frigidaire PLD4375RFC manual? We have 3 online manuals for this item!
Question posted by jcsteele38 on March 9th, 2011
Pf Alarm Flashes During Drying Cycle.
The washer washes fine but during the drying/sanitizing cycle the PF alarm flashes which stops the cycle. There have been no power failures. What would cause this?
Current Answers
Related Frigidaire PLD4375RFC Manual Pages
Installation Instructions (English) - Page 1
..., sides and back must be fully enclosed. NOTE: If dishwasher is not necessary to
junction box...occur and cause property damage.
2. Remove any obstruction.) • Anchor the dishwasher. All...and perform best when properly leveled. Figure 7(a). Failure to prevent clogging of the kickplate assembly using...Store
Electric Shock Hazard Disconnect electrical power at least a 2-inch side ...
Installation Instructions (English) - Page 2
... system.
Electrical Supply
1.
Use expansion fasteners if floor is level and securely fastened. Note: If mounting your dishwasher to the countertop or to the power supply until there is not a desirable option, you may occur.
Failure to side by UL and local codes.
Install the Cabinet Seal Kit (Instructions included in the literature...
Use and Care Manual - Page 1
...3
Normal Operating Sounds 4
Operating Instructions 4-8
Preparing and Loading Dishes 9-13
Dishwasher Dispenser and Detergents 14-15
Factors Affecting Performance 15
Care and Cleaning 16
...Record All Information For Future Reference
Brand:
Purchase Date:
Model #:
Solutions to Common Dishwashing Problems...17-19
Consumer Services
Warranty & Service 20
Serial #:
(see Features page ...
Use and Care Manual - Page 2
... will help alert you to the touch when the SANITIZE option has been selected.
Use a 20 ampere fuse if dishwasher is completely empty before running dishwasher.
• Disconnect electrical power to dishwasher before servicing.
• Repairs should be hot to such dangers as instructed in a dishwasher.
• Store dishwasher detergent and rinse agents out of the reach...
Use and Care Manual - Page 3
... filter and spray arms. Soil particles go down the drain as the water is pumped out and replaced with clean water. Next, the dishwasher fills with the cycle being used. The number of water fills will vary with water covering the filter area. Water is then pumped through the spray arms against...
Use and Care Manual - Page 4
.... This happens even when HI-TEMP WASH option has not been selected. Each cycle has a series of all cycles. Select desired CYCLE (See Cycle Chart). Wash Cycle Selections
Note: Cycle times are approximate and will hear is hot. As each time. Add detergent (See Dishwasher Dispenser & Detergents).
3. To start the dishwasher using the same cycle and options selected on the previous...
Use and Care Manual - Page 5
... SCRUB and desired OPTIONS.
gal. 37.5 liters
7.3 gal. 6.1 imp. Select RINSE ONLY. HI-TEMP WASH and SANITIZE will also vary based on all models.
Depending on the dishes. gal. 14.0 liters
2 1 3/4 1 1/2 1 1/4
2 washes 4 rinses
2 washes 3 rinses
2 washes 2 rinses
1 wash 2 rinses
6.1 gal.
1 1/2
5.1 imp. Cycle time and water usage will vary based on the amount of soil on soil...
Use and Care Manual - Page 6
... cleaning. The water temperature in combination with all cycles except CHINA CRYSTAL and RINSE ONLY.
The drying option may not be selected before the wash cycle is started, or anytime during the drying portion of the cycle, power failure or if the incoming water temperature is an interruption of cycle.
HEATED DRY option is available on until the proper water...
Use and Care Manual - Page 7
... select models)
When the SAHARA DRY option is selected, the dishwasher increases the temperature of the drain, select the desired cycle. For best drying performance, select Hi-Temp Wash and/or sanitize.
A light will illuminate when the controls are locked and no new selections can be completely dry at the end of cycle. At the end of the...
Use and Care Manual - Page 8
When the SANITIZE option is selected, the SANITIZED light will also flash.
If one of the following codes "Er", "uF", "uo", or "CE". HI-TEMP WASH and NO HEAT DRY indicator lights will glow when the SANITIZE cycle is finished and remain on until the door is opened . CL Close dishwasher door.
MINUTES......... The DRYING light indicates the drying portion of...
Use and Care Manual - Page 10
...Adjustable Upper Rack (available on select models)
To raise the upper rack, refer to wash a wide assortment of the dishwasher as it is perfect for clean glasses. Also, when the upper rack fills up... the rear of items when you don't have to use this unique feature. As you load your dishwasher, you don't have a full load. B) Pull rack slightly forward as coffee pots, food processors,...
Use and Care Manual - Page 13
Failure to do so may vary from the corresponding slots. 2.
Adding a Dish
To add or remove items after wash cycle starts:
• Unlatch door and wait a few seconds until wash action stops before opening.
• Add the item and wait a few seconds to allow cold air to slowly expand inside dishwasher...silver and stainless to latch and resume cycle.
13 Load silverware in a covered ...
Use and Care Manual - Page 14
... etching.
Moist or caked detergent will cause oversudsing.
• When using automatic dishwashing detergent tabs, place one pre wash cup. Water hardness is closed on the water hardness. China Crystal
1/4 full)
5 teaspoons (Main Wash cup-fill to latch and the dishwasher will continue through the cycle.
14 completely full)
Main Wash Cup- Close the door to line...
Use and Care Manual - Page 15
... since this can cause oversudsing. To check water temperature entering dishwasher: • Turn on setting. The indicator will be completely dry at the end of the cycle.
15 Wipe up...of the cycle indicating that cling and leave spots.
Low water pressure may choose not to 140 washes, depending on hot water faucet nearest dishwasher
for best dishwashing and drying results.
...
Use and Care Manual - Page 16
... is usually mounted on water and electrical power supply.
3. Care of the dishwasher.
Do not use . The filter is self-
To Restore Service:
1. If needed, clean around the tub gasket area with a mild
nonabrasive detergent and water. Fill both detergent cups and run dishwasher through a ULTIMATE SCRUB cycle.
4. Failure to dissolve any buildup.
• Overfill...
Use and Care Manual - Page 17
...Fine antique china and crystal should be at least 120°F (49°C).
• Check for cycle... is pushed in your dishwasher.
Dishes not Dry
• Select heat dry option.
• Make...Dishwashing Problems
Before calling for proper loading-avoid nesting items.
• Home water pressure may be too low- Food Soils Left on Dishes
• Choose another cycle for longer washing...
Use and Care Manual - Page 18
...• There is a noticeable change in soft or softened water causes this problem. (See Removing Spots and Film.)
• Aluminum utensils...wash action switches between the lower and middle spray arms.
Water in Bottom of Tub
• Water left in bottom of tub after cycle is complete is not normal. Dishwasher Leaks
• Use only fresh detergent designed for dishwasher to pause (no heat dry...
Use and Care Manual - Page 19
... the sanitize option been selected? Allow dishwasher to finish.
This is normal.
• Check to see if unit is draining properly. (See Dishwasher Does ...Dishwasher Has an Odor
• Soiled dishes left in a pause.
Do not add detergent.
3. Using no heat dry option will gradually fade over time. Do not load any metal utensils or silverware.
2. Select the NORMAL WASH cycle...
Parts Diagram - Page 1
... door panel. On some models the dry portion of the cycle can be adjusted by turning the arrow indicator from the electrical power source before adjusting or replacing components.
...
Heated Wash/Heated Rinse Sanitize 150°F ±5°F (66°C ±3°C) Hi-Limit Thermostat 200°F (93°C)
Gasket Cross Section Mounting Rib
Tub Interior
Short Turn
Dishwasher will not...
Parts Diagram - Page 2
... (Readout)
ER/CE....Configuration Error ER/uo.....Vent will switch off when door is opened . CLEAN Shows completion of the wash/rinse water. HI-TEMP WASH and NO HEAT DRY/POWER DRY OFF LED's flashing indicates power failure has
occurred. Light will not close ER/uF.....Fan not running
Display Codes (LED)
SENSING Turbidity sensor is filled. (Some...
Similar Questions
Dishwasher Didn't Wash. Light On For Heat Dry And Washing. Can't Get It To Turn
i have tried shutting off the breaker and when it came on the lights were still on and dishwasher wo...
i have tried shutting off the breaker and when it came on the lights were still on and dishwasher wo...
(Posted by swilcher78 8 years ago)
Stops And Displays Pf. Starts Next Cycle Ok, But Stops Again With Pf In Cycle.
I have checked the power OK. It runs Rinse Only cycle without trouble, but will not make it through ...
I have checked the power OK. It runs Rinse Only cycle without trouble, but will not make it through ...
(Posted by gappel 9 years ago)
Frigidaire Professional Series Dishwasher Pld4375rfc Will Not Drain
(Posted by farawindi 10 years ago)
Dishwasher Shuts Off At Random Washings With A Pf Code But No Power Failure
Dishwasher shuts off at random washings with a PF code but there has not been a power failure. This ...
Dishwasher shuts off at random washings with a PF code but there has not been a power failure. This ...
(Posted by roberttoney 11 years ago)
Pf Error Code Randomly Displays And Wash Cycle Stops. I Have Had No Power Failur
(Posted by Markbaker1953 11 years ago)