Frigidaire GLER1042FS Support Question
Frigidaire GLER1042FS Support Question
Find answers below for this question about Frigidaire GLER1042FS - Electric Dryer.Need a Frigidaire GLER1042FS manual? We have 4 online manuals for this item!
Question posted by shellykcherry63 on December 27th, 2012
My Push Start
My push button button will only buzz. everything lights up but the dryer won't turn on.
Current Answers
Related Frigidaire GLER1042FS Manual Pages
Owners Guide - Page 1
... proper operation and care. Read and Save These Instructions
Record Your Model and Serial Numbers
Record below the model and serial numbers found on the dryer serial plate located on the left side of Contents
Important Safety Instructions 2 Drying Procedures 3 Features 3 Common Drying Problems 4 Care and Cleaning 4 Avoid Service Checklist 5 Warranty...
Owners Guide - Page 2
... the manufacturer of all appliances. If the dryer is moving. Never ground the dryer to light any service or cleaning. Do not use... sheets can result in electrical shock or injury. Keep laundry products out of Fire -
Failure to cooking oils in the dryer.
Note: The instructions... automatically turns off vapors that may contribute to cover completely before using the drying rack...
Owners Guide - Page 3
...light-colored items. Separate items that shed lint from
those that lint screen is not in the OFF position. 7.
Prepare items for stains which should not exceed 10 lbs. Start the dryer.
• Push Start Button for 2 seconds or turn... electrical shock, or injury to ON, hold for operating your specific model controls. 5. Refer to dry items which may permanently set dryer ...
Owners Guide - Page 4
... shape. Do not store or place laundry products on top of the door opening... Remove cleanser residue before starting the dryer. These areas can damage...electrical shock could result in the surrounding area.
• Occasionally a waxy build-up may form on collars and cuffs. • Turn...below.
• Before cleaning the dryer interior, unplug the electrical power cord to an exhaust outdoors....
Owners Guide - Page 5
... the dryer.
Follow fabric care label instructions. Permanently attached items such as coins, pins, clips or buttons are inside...dryer. OCCURRENCE
Dryer does not start. Reset circuit breaker or replace fuse.
support the burner flame (gas models). Electric dryer...in dryer too long.
See Drying Procedures.
Foreign objects such as belt buckles, zippers and fasteners may turn ...
Owners Guide - Page 6
... GIVES YOU SPECIFIC LEGAL RIGHTS. Major Appliance Warranty Information
Your appliance is " are not covered by this warranty.
5. Service calls to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other appropriate payment record to change without notice. DISCLAIMER OF IMPLIED WARRANTIES; Electrolux authorizes...
Installation Instructions - Page 2
...to minimize the risk of fire or explosion or to light any appliance. · Do not touch any electrical switch; PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for future... screwdriver.
5. Pipe thread sealer (Gas).
9. SAVE THESE INSTRUCTIONS. - NOTE: The electrical service to the Dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas...
Installation Instructions - Page 3
... circuit fused with a 120 volt 3-wire power cord. The dryer is made up of insects and rodents. ELECTRICAL REQUIREMENTS
ELECTRIC Dryer
CIRCUIT - EXHAUST SYSTEM REQUIREMENTS
Use only 4 inch (10.2...
Alternating Current.
- Do not exhaust dryer into the laundry area. If the
dryer is not exhausted outdoors, some fine lint will obstruct clothes dryer airflow and increase the risk of your ...
Installation Instructions - Page 4
...roof may expose the exhaust system to down ) and start the dryer.
3. The gas supply line MUST have an individual ...it must be used .
1. Read the measurement on electric dryers, exhausting can accumulate lint, resulting in the absence
CORRECT...75 m) 24 ft. (7.31 m)
SAME AS OTHER SIDE
4
Number of 90°
Turns
0
28 ft.(8.53 m)
16 ft. (4.87 m)
MAXIMUM LENGTH
of stainless steel or plastic...
Installation Instructions - Page 5
...MUST be isolated from bottom and top of the door is acceptable. This dryer MUST be exhausted outdoors. 2. A 1/8 inch (0.32 cm) N.P.T. The dryer MUST be installed immediately upstream of 1 inch (2.54 cm). In an area...is required. MINIMUM INSTALLATION CLEARANCES -
IN. (387.1 SQ. Your dryer needs the space around it will obstruct the flow of the gas supply piping system at test...
Installation Instructions - Page 6
UNDER COUNTER & STACK MODELS ROUGH-IN DIMENSIONS
(68.3 cm)
TOP CONSOLE MODELS ROUGH-IN DIMENSIONS
(68.3 cm)
ELECTRIC CONNECTION
(6.5 cm) 13 1/2" (34.4 cm)
UNDER COUNTER
34 5/8" (87.9 cm)
36" (91.5 cm)
ELECTRIC CONNECTION
(6.5 cm)
13 1/2" (34.4 cm)
(110.7 cm)
36" (91.5 cm)
(9.5 cm)
3/8" (0.96 cm) DIA. GAS PIPE
(2.54 cm)
REAR VIEW
(9.5 cm...
Installation Instructions - Page 7
...This provision is available from
the left side and remove foam shipping base. Return the dryer to scratch the paint. 2. Be careful not to an upright position. Rotate the door 180°...door swing may need a plastic knife to pages 2 and 3 for future installation. When installing a gas dryer into a mobile home, a provision must be fastened to pick up air. Mobile Home Installation Kit No...
Installation Instructions - Page 8
...event of a malfunction
or breakdown, grounding will have longer drying times than operating on the appliance.
8 ELECTRICAL INSTALLATION
ALL ELECTRIC Dryers
Canadian ELECTRIC Dryer
The following are specific requirements for proper and safe electrical installation of your dryer is equipped with a power supply cord having an equipment-grounding conductor and a grounding plug, the plug MUST...
Installation Instructions - Page 9
...3. power cord, NEMA 10-30 Type SRDT, through the strain relief.
5. Non-Canadian ELECTRIC Dryer
1. GREEN GROUND SCREW
GREEN POWERCORD GROUND WIRE SILVER TERMINAL
TERMINAL BLOCK
NEUTRAL GROUND WIRE
RED
BLACK...this time. Tighten the strain relief nut securely so that the strain relief does not turn .
10. approved 30 amp. Attach the power cord neutral (center wire) conductor to the...
Installation Instructions - Page 10
... breaker/fuse box.
Label all connections by a qualified gas technician. Children might use them for proper operation. Turn on all pipe connections.
If the burner does not light within 45 seconds the first time the dryer is clear and free from combustible materials, gasoline, and other literature included with rugs, bedspreads, or plastic...
Operating Instructions - Page 1
... SAFETY INSTRUCTIONS in your dryer Owner's Guide. Room temperature and humidity, type of fire, electric shock, or injury to handle during the cool down , foam rubber, plastics, or similarly textured, rubber-like materials. It also has many suggestions for drying.
2.
It explains these operating steps in place. 3. Push the Start button and hold for 1-2 seconds...
Operating Instructions - Page 2
...DELICATES LOW HEAT
AIR FLUFF NO HEAT
END OF CYCLE
ON
OFF
PRESS SAVER
YES
NO
START
ON
AUTO PERM PRESS/
COLORS
PRESS SAVER
COOL DOWN
LESS NORMAL DRY
MORE
10
20... choice. • High heat is turned to the Press Saver setting.
Energy Saving Tips
• Keep the lint screen clean and exhaust the dryer correctly.
• Sort laundry properly and select proper temperature and cycle...
Similar Questions
Trouble Restarting Electric Dryer
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
(Posted by jrpetrick 5 years ago)
Electric Dryer Conversion To Gas?
Can my dryer be converted to gas ?
Can my dryer be converted to gas ?
(Posted by Anonymous-155161 8 years ago)
Dryer Will Not Turn On.
When I feed the coins in the dryer will not turn on.
When I feed the coins in the dryer will not turn on.
(Posted by jperry80871 9 years ago)
How Many Cubic In. Or Ft. Is This Dryer. 6.5 Or 7.0 ?
(Posted by chrispowell8 10 years ago)
Frigidaire Electric Dryer Fer641fs. No Heat. Timer Not Advancing.
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
(Posted by mouatech 10 years ago)