Frigidaire GLEQ2152EE Support Question
Frigidaire GLEQ2152EE Support Question
Find answers below for this question about Frigidaire GLEQ2152EE - 27" Front-Load Electric Dryer.Need a Frigidaire GLEQ2152EE manual? We have 4 online manuals for this item!
Question posted by RickoJ on February 8th, 2012
Service Manual For Frigidaire Gas Dryer Glgq215es
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on February 9th, 2012 11:35 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Related Frigidaire GLEQ2152EE Manual Pages
Use and Care Manual - Page 2
...qualified installer, service agency or the gas supplier.
2 All safety messages will be treated as instructed in your
Purchase Date dryer. By ...and liquids in the vicinity of this or any electrical switch; Your dryer may be performed by inappropriate waste handling of this... have provided many important safety messages in this manual must be used when elevating the washer for ...
Use and Care Manual - Page 3
ELECTRIC DRYERS:
14-30R
FUSED 30 AMP 120/240 V OR 120/208 V WALL RECEPTACLE
DRYER
DRYER SERVICE CORD
Grounding type wall receptacle
GAS DRYERS:
Do not under certain circumstances produce fire by spontaneous combustion. • Clean the lint screen before or after the dryer...airtight chambers. • Keep laundry products out of the dryer, lint screen housing and exhaust duct should be killed ...
Use and Care Manual - Page 4
... may not have it checked and reinstalled by a qualified service person. • To prevent personal injury or damage to the dryer, the electrical power cord of a gas dryer must be plugged into a properly grounded and polarized 3-prong outlet. Load the dryer.
• The average load will stop before reaching inside out for even drying. • Check for stains...
Use and Care Manual - Page 5
... and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to dry items which causes longer drying times. Remove ...dryer drum. Lint build-up . The dryer must be connected to be tumble dried. 1. Remove cleanser residue before drying the next load.
• Every 18 months an authorized servicer should not exceed 10 lbs.
Open the dryer...
Use and Care Manual - Page 6
... • Place fabric softener sheet on top of load
before starting the dryer.
They can damage the finish or controls. Or,...8226; Leaving items in washer or dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not clean
....
Care and Cleaning con't
Do not store or place laundry products on top of lint and scum, and fabric damage...
Use and Care Manual - Page 7
... by foreign objects or permanently attached items is overloaded. Avoid Service Checklist
Before calling for service, review this dryer. It may be 20% longer than two 90° ...of the drum. Use a dehumidifier near the dryer.
There are inside of material securely around ornaments before starting each cycle.
Electric dryer is open (gas models).
If 1of the 2 fuses is ...
Use and Care Manual - Page 8
... or home incurred during installation, including but not limited to establish the warranty period should service be obtained by contacting Electrolux at the addresses or phone numbers below. CLAIMS BASED ON.... YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE. Box 212378 Augusta, GA 30907
Canada 1.800.668.4606 Electrolux Canada Corp. 5855 Terry Fox Way Mississauga, Ontario, Canada...
Technical Data Sheet - Page 1
... gas models, replace electronic control. If meter reads 240V on electric models and 120V on to determine which button is not 50 K (± 10%), replace thermistor. Dryer...knob (1) click counterclockwise. CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING Please Return This Sheet to HIGH HEAT and touch START. Remove wires from dryer. If problem persists, replace electronic ...
Technical Data Sheet - Page 2
... button is displayed. 3 turns: Drive motor runs; c. When the START button is lit. Dryer will make the numbers decrease.
Drying and Cool Down LED's are lit and numbers appear in on... Position the cycle selector knob to select the following tests: Rotate the program knob clockwise from dryer. heat source is pressed, all the cycle status LED's should be used to the Normal...
Installation Instructions - Page 2
... into the laundry area. Exceeding the length of duct pipe or number of plastic duct or metal foil duct, replace it must be a minimum of a cord kit, use 4-conductor cord for (1) New branch circuit installations (2) mobile homes; (3) recreational vehicles;
NEMA 14-30R receptacle.)
NEMA 10-30R NEMA 14-30R
GAS Dryer
CIRCUIT - Failure...
Installation Instructions - Page 3
... often you should be to down ) and start the dryer. 3. However, on the manometer. 4. On gas dryers, exhausting can be of stainless steel or plastic-coated brass. 4.
Floor MUST be to the gas supply line.
No other fuel burning appliance shall be constructed of 1/2 inch (1.27 cm) pipe. 3. DO NOT install your parts distributor.
MINIMUM...
Installation Instructions - Page 4
... exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply ...on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to clear door handle (74.93cm)
49" to clear open door (124.46cm)
(11.12cm) 4.375" Side exhausts
712.7050"" (182.88cm)
(34.29cm) 13.5"
Gas...
Installation Instructions - Page 5
... the enclosure with American National Standard for other important venting requirements.
6. UNPACKING
1. Return the dryer to pages 2 and 3 for Mobile Homes. "Solid door " Reversal Instructions:
1. Place ... Install the four hinge hole plugs in diameter with the four screws.
4. When installing a gas dryer into a mobile home, a provision must be not less than twice the area of the door...
Installation Instructions - Page 6
Open the dryer door. Remove the four hinge hole plugs from door. 6. Install the plugs from Step 1 into the ...Window Door Reversal Instructions
1. Support the door assembly firmly before removing the other screw from the opposite side of the door to the dryer front panel. Lay the door on the lens with the handle holes in Step 2. Note the installation orientation of the door opening...
Installation Instructions - Page 7
.... Some extension cords are specific requirements for proper and safe electrical installation of your dryer is properly installed and grounded in a risk of electrical shock.
GROUNDING REQUIREMENTS
Non Canadian ELECTRIC Dryer
GAS Dryer
2.
If your dryer. Tighten the screw securely. Canadian ELECTRIC Dryer
DANGER Improper connection of the equipment grounding conductor can...
Installation Instructions - Page 8
... dryer area is unpacked. gas service without converting the gas valve. NOTE: Check to flow through the strain relief. Reinstall the terminal block access cover.
conversion kit must be used when elevating the dryer for this manual and all four legs.
3. Open the shutoff valve in your dryer, call 1-800-944-9044, or visit our website, www.frigidaire...
Operating Instructions - Page 1
...cycle for a desired option flashes and press Select. To reduce the risk of load and fabric type. Load the dryer. When the cycle ends, remove items immediately and hang or fold.
7. The ...Dry Auto Dry cycles take the guesswork out of installation and electrical voltage or gas pressure can also affect drying time. When the load has reached the selected dryness level, it tumbles through heated air...
Operating Instructions - Page 2
...any button will be removed promptly at the end of the cycle. Timed Dry To manually select the drying time for the desired option flashes, then press Select. Timed Dry ... is recommended for more details.
Those adjustments will not light. See the "Dryer Settings Chart" for most loads.
Dryer Features
(Control Lock) To avoid having someone accidentally start or stop the washer...
Operating Instructions - Page 3
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS - PN 134431300D (0801)
These temperatures, dryness levels and options are available with the following cycles:
Estimated drying time *** Temperatures
High ...
Similar Questions
Need To Fix Ed68 Code On My Model Gleq2152ee0 Front Load Dryer
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
(Posted by Ledesma2020 3 years ago)
Trouble Restarting Electric Dryer
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
(Posted by jrpetrick 5 years ago)
Gallery Series Gas Dryer Beeping. Which Buttons Do I Press To Reset?
(Posted by queendeb4 8 years ago)
No Heat, On New Gas Dryer
just pruchases gas dryer, gas is on, drum turns no heat
just pruchases gas dryer, gas is on, drum turns no heat
(Posted by dynatone 11 years ago)
Affinity Gas Dryer Venting
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
(Posted by schielej 12 years ago)