Frigidaire FTF2140FS Support Question
Frigidaire FTF2140FS Support Question
Find answers below for this question about Frigidaire FTF2140FS - 27" Front-Load Washer.Need a Frigidaire FTF2140FS manual? We have 2 online manuals for this item!
Question posted by Sissyjody on August 21st, 2012
Access To Drain Pump
My machine is not draing or sPinning on final rinse. Machine is stacKed in a small closet do I have to pull the machines out to access the door to the drain pump? Or is there another way from the front to access the pump?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on August 23rd, 2012 12:46 PM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
1. Unplug the washer
2. Pull the washer out to tilt it back so you can
reach the screws below the front panel and
remove it. (You will need something to catch
the water once the hose is removed from
the bottom of washer)
3. Loosen the bolt with the sliver clamp on the
bottom of the washer. The water will begin to
come out while your loosening the clamp. (Do
not remove any GREEN clamps)
4. Once the water is out, you can stick your hand
inside the hose to clean it out.
Online Outreach Specialist
Related Frigidaire FTF2140FS Manual Pages
Use and Care Guide - Page 2
... not followed.
2 You can be preceded by inappropriate waste handling of this Use and Care Guide the washer serial plate located at the top, inside of the door and the Operating Instructions included with your washer. This Use and Care Guide provides general operating instructions Read and Save These Instructions for
several other...
Use and Care Guide - Page 3
...water flow from service or discarded, remove the washer door to prevent accidental entrapment. •Failure to comply with these warnings could result in ...washer must never be plugged into the washer while parts are packed in 1 load unless specified on or in serious personal injuries. Never ground the washer to INSTALLATION INSTRUCTIONS for such a period, before using laundry...
Use and Care Guide - Page 4
... chemicals such as bras, shoulder pads, hosiery, and belts in the wash load. • Mend rips and tears to persons, read and follow this Owner's Guide are not meant to washer. • Combine large and small items in a mesh bag. Add laundry load to cover every possible condition and situation that can produce dangerous fumes...
Use and Care Guide - Page 5
...8226; Fill to the dispenser chamber. Note: Liquid detergent will drain into the drum.
Fill to time you may be adjusted for small loads. Note: From time to the maximum fill line (MAX.) for... Do not pour undiluted liquid chlorine bleach directly onto the load or into the
washer drum as it stops. • After adding laundry products, slowly close the dispenser drawer. Do not exceed ...
Use and Care Guide - Page 6
... containers and out of each load. An open door could entice children to persons or..., temperature, spin speed, options and features according to avoid on top of washer at any...small children present, leave the door ajar to prevent odor build up and to force the door open . Do not store or place laundry...door or crawl inside seam. • Rinse and wash items after the cycle has ended.
8.
Use and Care Guide - Page 7
...or soak in oxygen bleach and hot water before washing.
Pretreat stain. Rinse with a paste of an entire load, use on paper towels.
Scrape residue from fabric.
For discoloration of granular... for fabric.
Replace towels under stain frequently. Once paint is wet. Rinse.
WATER BASED: Rinse fabric in warm water using bleach safe for fabric. Wash using bleach ...
Use and Care Guide - Page 8
... for a few
minutes to clear lines. •Drain water heater occasionally. •For an ongoing problem, install an iron filter
in the washer to lubricate fibers.
•When ironing, use nonprecipitating... fabric softener to final rinse. •Dry load in dryer. •Remove lint with lint brush or roller.
•See Washing Procedures for fabric.
•Do not overload washer. •Use ...
Use and Care Guide - Page 9
... and other items in compartments and dry compartments. If door or console becomes stained, clean with a nonabrasive household cleanser. Press START and let the washer drain for cold weather care.
Store washer in 1 quart (.95 L) water]. Remove all of accumulated
powders and liquids. Never use a small brush to prevent floor damage. Excess wrinkling, color
transfer...
Use and Care Guide - Page 10
... in future loads
• Hot and cold water hoses are hitting wash drum. To prevent unnecessary noise and damage to prevent siphoning.
Close door completely. Close drawer.
• Heavily soiled items. Wipe drum with candy or meat thermometer. Incorrect wash and rinse temperatures. Unclog drain pipes. Run rinse cycle. If noise continues after spin. Reset circuit...
Use and Care Guide - Page 11
... or mileage expense for service and parts under this warranty. Expenses for making the appliance accessible for repairing or replacing any obligations under this warranty.
5. Damages to the finish of ... 212378 Augusta, GA 30907
Canada 1.800.668.4606 Electrolux Canada Corp. 5855 Terry Fox Way Mississauga, Ontario, Canada
L5V 3E4 Products purchased "as abuse, misuse, inadequate power supply,...
Installation Instructions - Page 1
...For your safety the information in U.S.A. Leave these instructions. Contents
S UBJECT Pre-lnstallation Requirements Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts
PAGE
2 2 2 2 2 3 4 4 4-6 6
Installation and service must be followed to minimize the risk of fire or...
Installation Instructions - Page 2
.... The standpipe height above the floor should be located so the power supply cord is
accessible when the washer is not recommended.
branch circuit fused with ground, 120 volt, single phase, 60 Hz,...SUPPLY REQUIREMENTS
Hot and cold water faucets MUST be between 30 and 120 pounds per minute.
2. DRAIN REQUIREMENTS
I .
POWER SUPPLY- 2 wire, with 15 amp. In the event of malfunction or ...
Installation Instructions - Page 3
... installtion instructions included with the pedestal. et s
3 3,5
=(85, _ )
inches (cm) For under counter installations, no special top is required.
8 ° 5'
{18.8)
9! 3 )
i
L_iO
ware#
Za! For stacking installations, see additional installation instructions included with the...
Installation Instructions - Page 4
... = 0 in. (0 cm) When installed in closet: Front = I .27 cm per foot (I in. (2.54 cm) Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in contact with a maximum slope of the floor may be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) operation.
2. Carefully move the washer to an upright position.
5. UNPACKING
1. Remove...
Installation Instructions - Page 5
...sides and feel for the
slightest movement. I /Ya_her Excessive noise and vibration leveling the washer. STOP RIB
DRAIN HOSE TABS
INSTALLATION
Zevel/ng the I . Carefully connect the other inlet hose to the ...particles that might clog up or down depending on location of the house drain• The hose is shipped in it's
final position, place a level on and check for best performance of the...
Installation Instructions - Page 6
...data sheet are located in this washer are not meant to the standpipe, inlet hose, laundry tub, etc.
Place the hook end of use them for play. Run the washer through a complete cycle. Maximum ...the drain hose in the enclosure package) to cover every possible
condition and situation that will save you time and money.
9. so the hose does not pull out from the force of the washer....
Similar Questions
Frigidaire Front Load Washer Model # Ftf2140fs2 Won't Drain
(Posted by sunHansh 9 years ago)
Frigidaire Front Load Washer Repair Fabric Softener Dispenser Won't Drain Model
ftf2140fs0
ftf2140fs0
(Posted by smteDhow 10 years ago)
Frigidaire Front Load Washer Fabric Softener Dispenser Won't Drain
(Posted by gyafros 10 years ago)
My Front Load Washer Model Number Gltf2940eso Will Not Finish Last Spin Cycle
my Frigidaire front load washer will not finish the last spin cycle. Whats wrong?
my Frigidaire front load washer will not finish the last spin cycle. Whats wrong?
(Posted by wiatrekmartin 12 years ago)