Frigidaire FPGS3085KF Support Question
Frigidaire FPGS3085KF Support Question
Find answers below for this question about Frigidaire FPGS3085KF - 30' Gas Slide-In Range-professional Group.Need a Frigidaire FPGS3085KF manual? We have 4 online manuals for this item!
Question posted by gfisher5530 on March 1st, 2023
F12 Error Code
I have a F12 error code on my Frigidaire oven. Replaced the main oven control board and the F12 error remained. Any solutions?
Current Answers
Answer #1: Posted by SonuKumar on March 1st, 2023 6:35 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,622,290
Member since:
May 9th, 2021 Points: 16,622,290
https://www.manualslib.com/manual/244866/Frigidaire-Gallery-Premier-Fggs3075k.html?page=34#manual
The F12 error code on a Frigidaire FPGS3085KF range indicates a problem with the electronic oven control (EOC) board. This error code can occur due to a communication failure between the EOC board and the user interface board, or it could indicate a fault in the EOC board itself.
Here are some steps you can take to troubleshoot the F12 error code:
Power off the range: Start by unplugging the range or shutting off the circuit breaker that powers it.
Check the wiring: Inspect the wiring connections between the EOC board and the user interface board. Make sure the connections are secure and free from any damage.
Replace the user interface board: If the wiring connections are fine, then the user interface board might be faulty. Replace it with a new one.
Replace the EOC board: If the F12 error code persists even after replacing the user interface board, then the EOC board might be the problem. Replace it with a new one.
Note: It's important to ensure that the range is disconnected from the power supply before attempting any repairs or replacements.
If you're unsure about any of these steps, it's best to consult with a professional technician to avoid any potential safety hazards or further damage to your appliance.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by tanyaaa1212 on March 2nd, 2023 8:56 AM
tanyaaa1212
Member since:
February 7th, 2023 Points: 44,330
Member since:
February 7th, 2023 Points: 44,330
The F12 error code on a Frigidaire oven typically indicates a problem with the communication between the main oven control board and the electronic oven control (EOC) board. If you have already replaced the main oven control board and the error code persists, there are a few other possible causes to consider:
- Electronic Oven Control (EOC) Board: The EOC board is responsible for communicating with the main oven control board and could be the source of the issue. You may need to replace the EOC board if it is not communicating properly with the main oven control board.
- Wiring and Connections: Check all the wiring and connections between the main oven control board and the EOC board to make sure they are secure and not damaged. Any loose or damaged connections can cause communication issues.
- Temperature Sensor: The temperature sensor measures the oven temperature and sends signals to the main oven control board and the EOC board. If the temperature sensor is faulty or has a poor connection, it could cause communication errors.
- Power Supply: Make sure the oven is receiving the correct voltage and that the power supply is stable. A fluctuating power supply can cause communication errors between the boards.
Please mark as helpful
Related Frigidaire FPGS3085KF Manual Pages
Complete Owner's Guide (English) - Page 1
... (If equipped)... 29 Important Safety Instructions 3 Care & Cleaning (Cleaning Chart 30 Features at a Glance 7 Care & Cleaning 31 Before Setting Surface Controls 9 Before You Call 34 Setting Surface Controls 10 Notes 37 Before Setting Oven Controls 11 Major Appliance Warranty 40 Setting Oven Controls 14
www.frigidaire.com USA 1-800-944-9044
www.frigidaire.ca Canada 1-800-265-8352
Complete Owner's Guide (English) - Page 7
...Electronic oven control with window. 17. Right front burner control. 5. Self-cleaning oven interior. 12. Cast iron side grate. 25. Left rear burner control. 3. Storage drawer (some models) or warm & serve
drawer (some models). 9. 1 or 2 Oven ...cancel
0
on·off
Your gas built-in range Features:
1. Cast iron center grate. 26. Warm & serve drawer control (some models). 7.
Complete Owner's Guide (English) - Page 8
... Large 3-piece oven door handle. 14. Left front burner control. 4. Right rear burner control. 6. Automatic oven door light switch. 9. Self-cleaning oven interior. 10. Warm & serve drawer control. 7. 2 Oven interior light with...
on·off
4
5
OFF
OFF
hi
hi
lo
lo
Your gas built-in range Features:
1. Adjustable interior oven rack(s). 13. Cast iron side grate. 22. Easy to clean ...
Complete Owner's Guide (English) - Page 12
... rack (Figure 3 & 4 - Wait until the oven has completely cooled if possible. BEFORE SETTING OVEN CONTROLS
Types of oven racks
Your built-in the lower rack position to facilitate the sliding of the rack when large amount of foods weight on it. Some models). Oven racks may still be used in range may be HOT and may cause...
Complete Owner's Guide (English) - Page 15
... 3 0 pads to 1:30. "CLO" will stay in the display.
2. Press SELF CLEAN to the range has been interrupted, the timer...correct time as described in the display will flash. An ENTRY ERROR tone (3 short beeps) will sound if the entry of day ...control pad is touched (the acceptance beep on the Oven Lockout pad is used to reject the change.
5. Setting OVEN controls
Minimum and Maximum Control...
Complete Owner's Guide (English) - Page 35
... the proper rack position is turned "ON". If you call code error (ex.: F11) an authorized servicer for service, review this list. It may appear out of range until flame is level. If floor is orange.
Surface burners can adequately support range. Surface control knob has not been completely turned to clean ports or slots...
Installation Instructions (All Languages) - Page 1
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER..... Installation and service must be installed with
backguard
35 7/8" (91,1 cm) Min. 36 5/8" (93 cm) Max. long flexible gas connector. WALL
30" Min. (76.2 cm Min.)
These surfaces should be performed by a Massachusetts licensed plumber or gasfitter.
Space
31 1/2"
1/2" min...
Installation Instructions (All Languages) - Page 2
... width (E dimension) of more
than
¼" (0.64 cm) flame retardant millboard
covered with
backguard
G.
TOTAL DEPTH TO FRONT OF RANGE
28 5/16" (71,9 cm)
E.
COOKTOP WIDTH
35 7/8" (91,1 cm) 30" (76,2 cm) 36 5/8" (93 cm)
31 1/2" (80 cm)
D. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the flexible...
Installation Instructions (All Languages) - Page 3
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the ... level height from the floor
to the cooktop voiding the warranty.
H2
H1
H4
H3
4
Slide the unit into the cabinet. Remove the protective channels on illustration 1).
Level the range using the four (4) leveling legs, so
Shave Raised
1 ½" Max. (3.8 cm Max...
Installation Instructions (All Languages) - Page 4
... the burner head and slowly turn the Surface Control knob to the Installer
1. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Important Notes to LITE. tipping of the cooking utensil. Never leave the oven door open when the range is
packed with your range is in an area covered with local codes or, in these instructions with installed properly, grasp...
Installation Instructions (All Languages) - Page 5
...Where a standard 2-prong wall receptacle is installed, it replaced by installing a range hood that projects horizontally a minimum of 5" (12.7...future reference.
1 Electrical connection
IMPORTANT Please read carefully. The oven must have molded edge shaved flat 3/4" (1.9 cm) from each... above the range. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Serial Plate Location
You will not be level...
Installation Instructions (All Languages) - Page 6
....
manual shutoff valve (not supplied) 2. 1/2" nipple (not supplied) 3. 1/2" flare union adapter (not supplied) 4.
To prevent leaks, put pipe joint sealant on pipe when tightening fittings.
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
3 Provide an adequate Gas Supply
When shipped from the factory, this "L" shape piece of metal, it is there to protect the...
Installation Instructions (All Languages) - Page 7
..., open the oven door. This valve should be located in the same room as the range and should be used , be certain connectors are used with Natural gas or LP/ Propane gas.
Replace the drawer, close the door and switch on some models) and open the shutoff valve in the gas supply line. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS...
Installation Instructions (All Languages) - Page 8
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
8 Range Installation
Important Note: Door removal is not a requirement for installation of...be ordered through a Service Center.
Place a level on the anti-tip bracket template
supplied with range door opening and double check for oven door removal instructions. Refer to interfere with a wrench. 3. Make sure they are setup higher...
Installation Instructions (All Languages) - Page 9
... increase flame size. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
10 Check Operation
Refer to the Use and Care Guide packaged with the turn each control to LITE until you can be adjusted individually. They may be as small as possible without extinguishing the flame. Push in and turn knob from the oven before testing.
10...
Installation Instructions (All Languages) - Page 10
... shutter opening size. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
10.6 Operation of Oven Burners and Oven Adjustments
10.6.1 Electric Ignition Burners Operation of electric igniters should be checked after range and supply line connectors have an electric burner igniter.
When the igniter has reached a temperature sufficient to ignite gas, the electrically controlled oven valve will open...
Installation Instructions (All Languages) - Page 11
... and attach with 4 screws provided. Anti-Tip Bracket
Back Edge of range with turned up holes in the oven. For easier installation, 3/16" (0.5 cm) diameter pilot holes 1/2"(1,27... screws packed with the range. 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
11 Anti-Tip Brackets Installation Instructions
To reduce the risk of tipping of the range, the range must be located when installed...
Product Specifications Sheet (English) - Page 1
... be programmed from a 600-BTU simmer to a
17,000-BTU boil quickly.
30" Gas
Product Dimensions
Height (Max.) Width Depth
36-5/8" 30" 28-5/16"
More Easy-To-Use Features
Pro-Select® Controls
Precise control at your schedule. Delay Start
Set your oven to 17,000 5,000 9,500 15,000
1B ased on single rack cooking...
Product Specifications Sheet (English) - Page 2
Slide-In Range
FPGS3085K F 30" Gas
Features
Oven Control / Timing System Surface Type Sealed Gas Burners Grates
Window
Exterior Door Finish Handle Design Exterior Finish (Side Panels) Convection System Oven Cleaning System Drawer Functionality
Pro-Select®
Slide-In Gas Ranges Black Porcelain
Yes
Frigidaire Baseline Continuous Cast Iron
w/Black Matte Finish Extra-Large with Pro-Tint Finish ...
Product Specifications Sheet (English) - Page 3
... for main shutoff ...gas codes.
• Make sure wall coverings around base or beneath lower front panel of range. Range requires fresh air for detailed instructions. 30" Gas Slide-In Range Professional
Slide-In Range
FPGS3085K F 30" Gas
Slide-In Range...FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire...
Similar Questions
F 30 Failure On Range
Which part needs to be replaced on my PLES389ECD Frigidare slide-in range. It gives me an F 30 code.
Which part needs to be replaced on my PLES389ECD Frigidare slide-in range. It gives me an F 30 code.
(Posted by Toddpeet 9 years ago)
My Frigidaire Oven And Range Electronic Control Board Won't Turn It On, Why?
It has an ES 100/105 control board which stays off completely until I turn a knob that controls the ...
It has an ES 100/105 control board which stays off completely until I turn a knob that controls the ...
(Posted by Scarecrow504 10 years ago)
Cancel Light
yellow cancel light stays on gallery 5 burner gass stove
yellow cancel light stays on gallery 5 burner gass stove
(Posted by gaffsonics 11 years ago)
Frigidaire Fpgs3085kf
stove started to show (f11 ERR) and does not work
stove started to show (f11 ERR) and does not work
(Posted by michael51361 12 years ago)
Why Does My New Range Take 15 To 30 Minutes To Preheat??
(Posted by jrandbev 12 years ago)