Flame Adjustment:

Hello Inelson98834 – Who installed the LP conversion kit? If you did yourself, verify that the unit has the appropriate fuel set. Due to liability and safety reasons I strongly suggest contacting a professional to confirm that the electronic is aligned properly, air regulator is correctly adjusted and/or burner have the recommended orifices. However, if you do not want to contact a certified technician, I found some basic troubleshooting steps to help adjust the gas flame (highly recommended to be very cautious).

Screwdriver Sets

Step 1 Find the tube that feeds the burner. There's a burner air adjustment on it that mixes the air and gas.

Step 2 Look to see what type of burner air adjustment you have: It will either be a barrel-shaped chamber or triangle-shaped with a cover plate.

Step 3 Loosen the air-shutter screw on the barrel-shaped type.

This screw is on the end of the barrel closest to the burner.

Step 4 Open the shutter on the barrel-shaped type by turning it counterclockwise; close it by turning it clockwise. Opening it will add more air, which will make the flame higher; closing it will reduce the air in the mix and lower the flame.

Step 5 Loosen the screw holding the plate on the triangle-shaped burner air adjustment. Don't remove the screw - it just needs to be loose enough to move the plate.

Step 6 Move the plate so that the opening is either more open or more closed. More open will make the flame higher whereas more closed will lower the flame.

---

Online Outreach Specialist