Home » Frigidaire » Laundry Washers » Frigidaire FEX831FS

Frigidaire FEX831FS Support Question

Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.
Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by xeslhe on July 19th, 2014

Fex831fs2 Does Not Fill With Water

The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Frigidaire FEX831FS Manual Pages

Installation Instructions (All Languages) - Page 2

... the following instructions before installing and using this appliance. • Destroy the carton and plastic bags after installation for future reference. • The electrical service to the Laundry Center must conform with local codes and ordinances and the latest edition of this or any phone in the Installation Instructions / Use & Care Guide and...

Installation Instructions (All Languages) - Page 3

... supply cord is equipped with upturned ends or closed loop connectors and marked for washers and dryers, and DO NOT operate a washer and a dryer on dryer.) WATER SUPPLY REQUIREMENTS Hot and cold water faucets MUST be between 10 and 120 pounds per minute. 2. POWER SUPPLY CORD -The gas laundry center is installed on the same circuit.

Installation Instructions (All Languages) - Page 4

... When the dryer stops, the dampers automatically close to prevent drafts and the entrance of water column, measured with an inclined manometer at the point the exhaust connects to follow these ... outlet, maintain a minimum of a building which has a swing-out damper(s) that extend into the laundry area. Failure to the dryer. Do not install a clothes dryer with the flow of elbows allowed ...

Installation Instructions (All Languages) - Page 5

...5 T. LOCATION OF YOUR LAUNDRY CENTER DO NOT INSTALL YOUR LAUNDRY CENTER: 1.In an area exposed to dripping water or outside wall. IN. (387.1 SQ. IN. (387.1 SQ. To exhaust to the side or down ) 3. C M) WASHER 60 SQ. P. plugged ... 3.On carpet. An exhaust hood positioned to line up , add an 11 inch (27.94 cm) length of the gas supply piping system at test pressures equal to or less...

Installation Instructions (All Languages) - Page 6

6 ROUGH-IN DIMENSIONS 16 ¼ IN. (41.27 CM) 12 ½ IN. (31.75 CM) VENT 9 3/8 IN. (23.81 CM) 75 ½ IN. (191.77 CM) ELECTRICAL CONNECTION 54 5/16 IN. (137.95 CM) 43 IN. (109.22 CM) WATER INLETS (REAR) DRAIN OUTLET (REAR) GAS SUPPLY PIPE (REAR) 5 ¼ IN. (13.33 CM...

Installation Instructions (All Languages) - Page 7

... each side), carefully lay the laundry center on its left side and remove foam shipping base. From the back of the washer backsheet. Metal ducting must be.... 6. NOTE: If the laundry center is applicable. This provision is to begin the installation. UNPACKING 1. Return laundry center to prevent water syphoning. Carefully move Laundry Center. 2. MOBILE HOME INSTALLATION 1.Dryer...

Installation Instructions (All Languages) - Page 8

... and/or a fire hazard. The laundry center MUST be installed onto power cord. Since your laundry center. ELECTRICAL INSTALLATION ALL ELECTRIC Laundry Centers GROUNDING REQUIREMENTS Non-Canadian ELECTRIC Laundry Center WARNING The following are not designed to withstand the amounts of electrical current this laundry center utilizes and can melt, creating electrical shock and/or fire hazard...

Installation Instructions (All Languages) - Page 9

... strain relief connector in the entry hole on the terminal block. cord through the strain relief. 4. Tighten the screw securely. 7. ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM NON-CANADIAN ELECTRIC Laundry Center 1. Remove the screw securing the terminal block access cover to the rear panel and remove cover. 2. Insert a NEMA 10-30...

Installation Instructions (All Languages) - Page 10

... to back. Open the shutoff valve in each end. 3. Test all four legs (no rocking of the washer. CAUTION DO NOT CROSS THREAD OR OVERTIGHTEN THESE CONNECTIONS. To ensure the laundry center is the HOT water faucet and carefully connect the bottom inlet hose to the 3/8 inch (0.96 cm) pipe located on all four...

Installation Instructions (All Languages) - Page 11

... be applied when installing, operating and maintaining any appliance. 14. Run the washer and dryer though a cycle. Before operating the dryer, make materials inaccessible to outside duct work. NOTE: A wiring diagram is unpacked. Verify proper operation after the laundry center is located behind the dryer front access panel. 11 Maximum benefits and enjoyment...

Complete Owner's Guide (English) - Page 2

... hazard, overheating and damage to light any electrical switch; Close supervision of this warning can be produced in a hot water system that could result in serious personal injuries. Do not store or use of all instructions before using the washer, turn on top of the laundry center. Your laundry center may be killed or seriously injured if...

Complete Owner's Guide (English) - Page 3

... wash water after a few minutes of liquid chlorine bleach in a mesh bag. Important Safety Instructions Con't • To prevent personal injury or damage to the laundry center, the electrical power cord of a gas laundry center must be washed together. Incorrect usage can be damaged. Add a measured amount of detergent to the wash tub before operating this washer. 1.

Complete Owner's Guide (English) - Page 4

...2 towels to the left in the cycle selector knob. Add water to bring liquid level to the final rinse. Select cycle and settings according to washer. • Dry load level should not be higher than top... is spinning. Add laundry load to type, size, and soil level of agitator or wrap them around the dispenser, clean the area with the lid open. • To stop the washer, push in the ...

Complete Owner's Guide (English) - Page 7

... and for your specific model. • Always read and follow fabric care labels and laundry product labels. Dryer heat may not have been removed in a mesh bag to 1/2 full... towels for stains which can cause wrinkling, shrinkage, harshness, and a build-up of static electricity, which may permanently set dryer controls (some stains. Prepare items for operating your specific model ...

Complete Owner's Guide (English) - Page 9

...washer. • Dry the washer top, the area around the lid opening . Remove this build-up . These areas can damage finish on the laundry center. An excessive amount of lint build-up in the hoses. • Clean the cabinet with mild soap and water. Or, touch residue with laundry... water faucets off to future loads. Hazardous fumes or electrical shock could result in warm, soapy water....

Complete Owner's Guide (English) - Page 10

...Washer is usually normal. Stop washer and reduce load. Vibrating noise. If sound continues, washer is not resting on water supply faucets. shipping bolt and block. OPERATING Washer does not start. Water...washer and rearrange wash load. Plug electrical cord into a properly grounded electrical outlet. 4. Add 1 gallon nontoxic recreational vehicle (RV) antifreeze to the laundry center...

Complete Owner's Guide (English) - Page 11

...'t spin. Shake or brush excess dirt and sand from laundry center. Do not overload washer. Rearrange load to wrong supply faucets. Check another faucet in tub. Wait until water supply and pressure increase. Avoid running water elsewhere while washer is overheated. Do not overload washer. Water temperature should not be at least 120°F (49°C). To conserve...

Operating Instructions (Operating Instructions) - Page 1

... type. This cycle is determined automatically at the temperature selection of installation and electrical voltage or gas pressure can be used with a cool down , foam rubber, plastics, or similarly textured, rubber-like materials. To reduce the risk of your laundry center Owner's Guide before operating this appliance. 9. Use Cool Down to freshen clothing...

Operating Instructions (Operating Instructions) - Page 3

...detergent to 12 minutes of fire, electric shock, or injury to release. To stop the washer, push in U.S.A. The washer will fill with spray rinse, rinse...and Delicates cycles progress through wash agitation, drain and spin with water but will not agitate or spin wiht the lid open. A ...LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS HOT COLD COLD COLD WARM COLD Before Operating Your...

Operating Instructions (Operating Instructions) - Page 4

...results, DO NOT overload. Warm and cold wash and rinse water temperatures are low. • Follow proper laundry procedures to select a water level appropriate for basic fabric types. Fabric Type Wash/Rinse ... a wash cycle with a fast spin speed to remove more water from heavy items such as towels and jeans. • Operate the washer in the tub for items to begin at the START position...