Frigidaire FARE1011MW Support Question
Frigidaire FARE1011MW Support Question
Find answers below for this question about Frigidaire FARE1011MW.Need a Frigidaire FARE1011MW manual? We have 4 online manuals for this item!
Question posted by michaeltrimble87 on April 6th, 2013
Dryer Will Not Stop Running
I recently boought a fare1011m dryer it worked fine until last night when it would not shutoff . I had to unplug it to get it to stop. Plus it will not dry the clothes when it does run any suggestion?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on April 8th, 2013 9:27 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello michaeltrimble87 – Based on the symptoms you are describing, the unit could be experiencing quite a few issues: wiring failure, communication problem with the control board, faulty element(s), timer thermostat, or the blower assembly. Have you recently cleaned the ducting vent? Try reprogramming the dryer by unplugging it or flipping the household circuit breaker off. Wait approximately ten minutes and turn the unit back on. If issue persists, and because it could be a number of any one of several underlying causes, I would personally recommend contacting a professional to properly diagnose and repair the unit.
Online Outreach Specialist
Related Frigidaire FARE1011MW Manual Pages
Installation Instructions (English, Español, Français) - Page 1
All about the
Installation
of your Dryer
TABLE OF CONTENTS
Important Safety Instructions 2-3 Accessories 19 Installation Requirements 4-10 Notes 20 Installation Instructions 11-16 Español 21 Reversing Door 17-18
137349800B (1204)
Installation Instructions (English, Español, Français) - Page 2
... rigid metal or
semi-rigid metal exhaust duct work • 3-wire or 4-wire 240 volt cord kit
(electric dryer) • 4 in Canada, the Canadian electrical... or in . (102 mm) clamp
• Gas line shutoff valve (gas dryer) • ½ NPT union flare known to collapse...move or lift the appliance. These conditions will obstruct clothes dryer airflow and increase the risk of fi...
Installation Instructions (English, Español, Français) - Page 3
... level, side-to-side and front-to-back ‰ Cabinet is setting solid on all corners
Gas Supply (Gas Dryer)
‰ Manual shutoff valve present in supply ‰ All connections sealed with approved sealer
and wrench tight ‰ Conversion kit for function
Electrical Power
‰ House power turned ...
Installation Instructions (English, Español, Français) - Page 4
... at 240 volt AC minimum, 30 amp, with 4 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. NEMA 10-30R or NEMA 14-30R receptacle to neutral unless it was manufactured for sale in Canada. GROUNDING CONNECTION - For 4-wire cord connection instructions...
Installation Instructions (English, Español, Français) - Page 5
... stainless steel or plastic-coated brass.
4 The gas supply line MUST have an individual shutoff valve installed in Electrical Installation section. POWER SUPPLY CORD - See "Grounding requirements" in ... pressure testing of the gas supply piping system at test pressures equal to the dryer.
6 The dryer MUST be disconnected from the gas supply piping system during any circumstances, cut, ...
Installation Instructions (English, Español, Français) - Page 6
... the dryer stops, the dampers automatically close to prevent drafts and the entrance of any other obstruction. WARNING
FIRE HAZARD Do not install a clothes dryer with a rigid or semi-rigid metal duct. Also, ensure the present duct is free of insects and rodents. The following are known to follow these instructions can create excessive drying...
Installation Instructions (English, Español, Français) - Page 7
... the screws or rivets, clogging the duct work and creating a fire hazard as well as increase drying times.
All male duct pipe fittings MUST be installed downstream with the flow of a building. INSTALLATION REQUIREMENTS
Exhaust system requirements, continued
WARNING
FIRE HAZARD A clothes dryer must be connected to terminate the duct outdoors...
Installation Instructions (English, Español, Français) - Page 8
... fluff (cool down drafts causing an increase in vent restriction.
• Running the exhaust system through your local parts distributor or hardware store. If the system ...the dryer:
• Only rigid metal duct work should be inspected and cleaned a minimum of free-standing dryer.
8
Although vertical orientation of the exhaust system is less than 0.75 inches of dryer....
Installation Instructions (English, Español, Français) - Page 9
...80 (formerly the Federal Standard for proper ventilation. Rigid metal duct is preferred.
3 If dryer is exhausted through the floor and area beneath the mobile home is acceptable.
3" ... provision is to be unobstructed when a door is required. Installation in a Recess or Closet
1 A dryer installed in diameter with no obstructions. Metal ducting must be 4 inches (10.16 cm) in a ...
Installation Instructions (English, Español, Français) - Page 11
... be purchased. If it will not fit the outlet, have longer drying times than dryers operating on this dryer. The proper wiring and receptacle is properly grounded.
Follow the instructions in ...system, the plug MUST be run with a copper wired receptacle.
Í NOTE
Dryers operating on 208 volt power supply will reduce the risk of the dryer and can result in accordance ...
Installation Instructions (English, Español, Français) - Page 19
... Touch Up Pen - Contact the source where you purchased your model did not include a drying rack or you desire another drying rack, you purchased, a drying rack may have been included in a location supplied with repair, return sheet inside the dryer console. TECH DATA SHEET/ WIRING DIAGRAM
Replacement parts:
If replacements parts are located inside...
Complete Owner's Guide (English) - Page 3
...in inefficient drying and possible fire.
An excessive amount of the dryer.
• Do... not spray any time.
• Do not use an adaptor plug or extension cord or remove grounding prong from electrical power cord. Do not stack or place laundry...A clothes dryer produces combustible lint. WARNING - These substances give off vapors that could be a sign of the dryer....
Complete Owner's Guide (English) - Page 4
...airtight chambers.
• Keep laundry products out of which may occur. Included in this list are not meant to do not reach into the dryer if the drum is removed ... the installer's reference.
The dryer is used near children.
Wait until the dryer has stopped completely before attempting any appliance.
4 PREVENT INJURY AND DAMAGE TO THE DRYER
• All repairs and servicing...
Complete Owner's Guide (English) - Page 6
...ll the drum 1/3 to 1/2 full. Allow the drum to come to a complete stop before drying. IMPORTANT
Clean the lint filter after every load.
6
The average wet load ...will hear two beeps. You will hear one beep before the drum begins to rotate.
• To add or remove items when the dryer is running...
Complete Owner's Guide (English) - Page 7
...cycles, options, or features listed are available on items to be dried. Cycle Selection
Turn the cycle selector in the selector knob again to... desired. Consoles shown above for reference only.
If cycle selection change is running, turning the selector knob to another selection will continue.
Í NOTE
...dryer.
7
For best results
Follow the fabric care label instructions on every ...
Complete Owner's Guide (English) - Page 14
...clothes dryer produces combustible lint. IMPORTANT
Clean the lint filter after every load. Lint build-up . Remove by pulling straight up on the filter restricts air flow, which causes longer drying... below.
• Before cleaning the dryer interior, unplug the electrical power cord to persons or property, comply with a mixture of dryer at the bottom of fire or...
Complete Owner's Guide (English) - Page 15
.... • Remove items when they are slightly
damp to avoid overdrying. • Check that lint filter is clean and in dryer after
cycle ends. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association. PREVENTIVE MEASURES
• Add a few bath towels to small loads for 5-10 minutes.
•...
Complete Owner's Guide (English) - Page 16
... valve is not open .
Drying temperature too high. Scratching or chipping of rigid or semi-rigid metal.
Permanently attached items such as cycle ends. fuses is blown, the drum may be at least 4 inches in place, the duct must not exceed length listed in the dryer circuit. Dryer runs but the heater will be...
Product Specifications Sheet (English) - Page 2
....ca
FARE1011M 06/12
© 2012 Electrolux Home Products, Inc. Electric
Features
Total Capacity D.O.E. (Cu.
Width
27"
C - Dryer
Top Load Laundry - Ft.) Controls Dryer Drum ...Dry Cycles
8
Specialty Cycles
0
Options
Temperature Selections Dryness Level Selections Timed Dry Energy Saver Option
4 0 15, 30, 60, 90
B
C
Optional Accessories
Mobile Home Installation Kit Drying...
Product Specifications Sheet (English) - Page 3
...run...Drying...clothes dryers (not supplied).
• Grounding through neutral link prohibited in recess or closet requiring 0" minimum installation clearance around sides and back of 4-wire system. (For detailed electrical requirements, refer to dripping water or outdoor weather conditions;
Closet installation requires additional 1" minimum clearance between front of door. FARE1011M W
Dryer...
Similar Questions
Dryer Does Not Work Fine
My name is Casey.I have Gas Model Dryer. It worked fine yesterday. But today it does not. Dryer runs...
My name is Casey.I have Gas Model Dryer. It worked fine yesterday. But today it does not. Dryer runs...
(Posted by hiroshinop 7 years ago)
Dryer Stops With The Control And Lock Flashing, And The Load Is Still Damp.
Why does the dryer stops with the control and lock flashing, and the load is still damp.
Why does the dryer stops with the control and lock flashing, and the load is still damp.
(Posted by RicksEmailDrop 7 years ago)
Dryer Stops And Beeps 6 Times
The dryer stops and beeps 6 times, lights flash and does not reset.Cleaned out the lint, front and b...
The dryer stops and beeps 6 times, lights flash and does not reset.Cleaned out the lint, front and b...
(Posted by electqa2002 8 years ago)
How To Solve This Problem Dryer Stop Drying Then The Light Start Blinking
dryer stop drying then it start blinking then u have to start it over then it keep doing it
dryer stop drying then it start blinking then u have to start it over then it keep doing it
(Posted by tsmith137211 8 years ago)
Dryer Stops After 10 Mins, No Heat, But Will Run On 'air Fluff.'
Frigidaire AGQ6000ES2, about 3 years old. The dryer stops after 10 mins after I start it, there is a...
Frigidaire AGQ6000ES2, about 3 years old. The dryer stops after 10 mins after I start it, there is a...
(Posted by morningtreat 10 years ago)