Frigidaire Atf6700fs Washer Turns On Then Turns Off; Error Code E23

When we start the washer it will make some clicking noises as if it is going through a start sequence. This is normal, but then it just shuts off without filling water What I have done:1.) I pressed the start and cancel button together to get an error; Code of E23My manual says E23 is either Drain pump relay on control board failed, wire off pump or pump.2.) I took off the Drain Pump and tested it with a cable I made at work. It ran fine. Reinstalled the Drain Pump and tried to start the washer. I ran a delicate cycle; it started as normal, filled up water and started to wash. After about 5 minutes it just stopped and I was back to square 1. 3.) I ordered a new Control Board and installed it. Same result, start, does not fill water then turns off.4.) I reinstalled the old Control Board. Same result.5.) I took the drain pump out again and cleaned out the trap right before the pump. There were quarters, pennies, a bobby pin and other stuff. I reinstalled the Drain Pump and tried to run a delicate cycle. It ran for about 5 minutes then turned off.6.) I used the cable from step 2 to run the drain pump to get the water out of the machine.7.) I reinstalled the New Control Board, just to make sure. Again same result Start, no water, turn off.8.) I checked the wire from the Drain Pump to the Control Board with a multi meter for continuity. All the wires were fine.