Frigidaire ATF6000FS Support Question
Frigidaire ATF6000FS Support Question
Find answers below for this question about Frigidaire ATF6000FS - AffinityTM 3.5 cu. Ft. I.E.C. Capacity Washer.Need a Frigidaire ATF6000FS manual? We have 1 online manual for this item!
Question posted by marcolivierillc on November 27th, 2015
Atf6000fso Control Knob And Lights Erratic
unable to make choices properly with knob. lights skip around and are not logical. Tried unplugging, resting and restarting to no avail.
Current Answers
Answer #1: Posted by TechSupport101 on November 27th, 2015 8:10 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. You are likely looking at a defect control board due for service or replacement. Do have it tested.
Related Frigidaire ATF6000FS Manual Pages
Use and Care Guide - Page 2
...is the safety alert symbol.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to the washer.
Do not store or use any electrical switch; This is very important. Instead
it in ...Serial Numbers
several other flammable vapors and liquids in personal injury, property damage or damage to light any appliance. • Do not touch any phone in this Owner's Guide are not ...
Use and Care Guide - Page 3
....
• To prevent personal injury or damage to the washer, the electrical power cord of the washer must be plugged into a
properly grounded and polarized 3-prong outlet.
Refer to a gas pipe. Never ground the
washer to INSTALLATION INSTRUCTIONS for detailed grounding procedures. Do not combine laundry products for 2 weeks or more. ENGLISH
Important Safety Instructions...
Use and Care Guide - Page 4
.... Add laundry load to a complete stop if it will automatically restart after a cool down period of fiberglass left in other loads and cause skin irritation.
2. Do not install on a solid floor. Sort items by an authorized servicer unless specifically recommended in the cycle selector knob and allow the drum to coast to washer. •...
Use and Care Guide - Page 5
.... Overfilling can cause early dispensing of the fabric softener which could result in tumble action washers.
5 Overfilling can cause early dispensing of a fabric softener dispensing ball is added. &#... CLOSING THE DISPENSER DRAWER • Slowly open the dispenser drawer. • After adding laundry products, slowly close the dispenser drawer. C.
Look for this symbol . • Fill...
Use and Care Guide - Page 6
...washer. • DO NOT leave the washer... not slam the washer door closed or try to avoid on... of the washer. Note: ...washer after stain removal.
6 An open . They can damage the finish or controls...To reduce the risk of washer at any utensil used. ...controls. Do not store or place laundry products on an inside the washer...washer and personal injury, DO NOT hang on or lean against the washer...
Use and Care Guide - Page 8
... water temperature using the Perm Press or Delicate cycle.
•Do not overload washer. •Remove items from washer as soon as cycle
is due to abrasion from normal wear.
• Use...•Wash water temperature too low. See Washing Procedures for fabric.
•Do not overload washer. •Use liquid detergent or use chlorine bleach to remove pills. Rewash using full permanent ...
Use and Care Guide - Page 9
...antifreeze from hoses. 3. For Other Inside Cleaning • Before cleaning the washer interior, unplug the electrical power cord to remove traces of cardboard or thin fiberboard under ...damage. This prevents dye transfer to lock it stops. (Figure 1) • Reach back into a properly grounded electrical outlet. 4. Residue should always be expelled. 6. Remove all of the tape or label. ...
Use and Care Guide - Page 10
... it rests firmly on floor. Stop washer and rearrange...Washer motor will automatically restart after
a cool down period of 23.6" (60 cm) high to drum, fasten fasteners and turn items inside out. Washer won't spin.
Oversudsing. Do not overload washer. Use less detergent in this list. See INSTALLATION INSTRUCTIONS.
10 If noise continues after spin. Do not increase fuse capacity...
Use and Care Guide - Page 11
Food loss due to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other cosmetic parts.
11....obligations under this warranty must be readily determined.
2. Products with the provided instructions. Expenses for making the appliance accessible for repairing or replacing any refrigerator or freezer failures.
6. Service calls to...
Similar Questions
Add The Garment Light Stays On And Beeps When The Machine Is Not In Use
without the washer being used the add a garment light stays on and the machine beeps. it did wash a ...
without the washer being used the add a garment light stays on and the machine beeps. it did wash a ...
(Posted by kycoldy 1 year ago)
Washer Stopped And Have Pau Code On Display
(Posted by Anonymous-125719 10 years ago)
Atf6000fso Error
flashes error when door is closed and start is pressed.
flashes error when door is closed and start is pressed.
(Posted by Mathiasjudd 10 years ago)
Control Panel Flashing And Door Latch Is Clicking Off And On,
Washer tries to perform but stops after a few seconds
Washer tries to perform but stops after a few seconds
(Posted by dstephenson1959 11 years ago)
How Do I Remove The Washer Control Knob?
There appears to be 2 prongs in the shaft holding the knob on. I've tried to reach behind the knob w...
There appears to be 2 prongs in the shaft holding the knob on. I've tried to reach behind the knob w...
(Posted by matt64924 12 years ago)