Frigidaire AEQ6700FS Support Question
Frigidaire AEQ6700FS Support Question
Find answers below for this question about Frigidaire AEQ6700FS - 27" Electric Dryer.Need a Frigidaire AEQ6700FS manual? We have 5 online manuals for this item!
Question posted by g5grana on December 1st, 2010
Frigidaire Affinity Aeq6700f Dryer
The dryer is not working properly, when I put the clothes in and select the dryer settings the clothes come out damp, worse then when they were put in.
I have tried all dryer settings with the same results. Only after running the dryer for more than 60 minutes have the clothes come out dry.
Any input on how to fix this would be greatly appreciated.
Thanks
GC
Current Answers
Related Frigidaire AEQ6700FS Manual Pages
Use and Care Guide - Page 3
...dryer interior. The interior of all appliances. Fire hazard, overheating and damage to fabrics can result in electrical shock or injury. Do not stack or place laundry... dryer has a drying rack, always replace the lint screen when finished using this Owner's Guide. A clothes dryer...8226; Do not try to the dryer, the electrical power cord of aerosol into a properly grounded and polarized ...
Use and Care Guide - Page 4
... during Extended Tumble at a time. Place the front bar under the lip of static electricity, which should not exceed 10 lbs. Reversible Dryer Door Your dryer is not in a mesh bag to follow fabric care labels and laundry product labels. When items are heatproof and won't damage the drum finish. Failure to prevent tangling...
Use and Care Guide - Page 5
... dryer must be air dried. • Use proper ....
Hazardous fumes or electrical shock could result in dryer after
cycle ends....dryer. These areas can damage the finish or controls.
ENGLISH
Do not store or place laundry products on top of cardboard or thin fiberboard under the front leveling legs to prevent damage to "pills."
• Check that lint screen is normal with a damp cloth...
Use and Care Guide - Page 6
... supply valve is on a 240 volt circuit. See Drying Procedures. Refill or replace tank. Dryer does not have no more than drying on a separate circuit.
Electric dryer is not securely plugged in the dryer circuit. There are not the result of rigid or flexible metal.
Exhaust duct requirements have not been followed. Remove items as...
Parts Catalog - Page 1
BOX 212378 AUGUSTA, GA 30917
Publication No. 5995497798 07/08/21
(EN/SERVICE/WTC) 361
ELECTRIC DRYER
Model No. All rights reserved. AEQ6700FS0
Series
Frigidaire
Market
North America
Color
white
Volts
240
Wiring Diagram
134682200
Owner's Guide
134760100
Installation Instructions 134759900
Operating Instructions 134609300
P16L0043.eps P16V0097.eps P16d0040.eps ...
Parts Catalog - Page 3
..., w/housing/felt Baffle, heater shield Screw, 10-16AB x 0.375 Bracket, top panel mtg., rear Drum, dryer, stainless steel, service kit Glide, drum Screw, quadrex head, 10-14 x 1.00, vane mtg., special Vane... heater housing Bracket, svce panel mtg.
*
134608000 Stacking Kit (not incl w/unit), dryer/washer
* #
5303281153 Rear Bearing Kit, includes 5, 6, 12, 13, 14, 18, 32
Publication No: 5995497798
#...
Parts Catalog - Page 5
.../LINT FILTER
POS. NO 1 2 6 8 # 9 16 20
20* 21 22 25 26 # 27 28 33 34 39 41 43 44 45 46 47 48 48* 49 50 52 53 56 58 #...w/mtg bracket • Lamp Screw, indt pan head, 10-14 x 0.625, quadrex Plug, hinge cutout, natural Nameplate, Affinity, chrome T-Plug, hinge hole Plug, hinge hole, gray Plug, rectangular, gray
Publication No: 5995497798
# Functional Parts
5
* Non-Illustrated Parts
08/07
Parts Catalog - Page 9
...4 7 7* 10 # 11 15 # 20 22 23 # 25 # 27 28 # 34 46 47 48 52
PART NO. 131435200 131451600 131456800 131775600 ...Spacer, idler Thermistor, control Screw, hex head, 1/4-20T x 1.25, spacer mtg., thread cutting Spring, idler arm Idler Arm Assy, w/pulley Belt, dryer Clamp, motor mtg. AEQ6700FS0
MOTOR
POS. Motor & Pulley Assy Screw, pan head, 8-18AB x 0.375 Bracket, motor mtg Seal, exhaust tube Screw,...
Operating Instructions - Page 1
... Select a Timed Dry setting to select the cycle.
Towels Select this Auto Dry cycle for drying.
2. Heavy Duty Select this Auto Dry cycle for sturdy work clothes. Delicates Select ...electrical voltage or gas pressure can also affect drying time. To
INSTRUCTIONS in place. 3. operating this Auto Dry cycle for best drying results. Load the dryer. Select the appropriate cycle and settings...
Operating Instructions - Page 2
... damp or over -drying, not every dryness level is selected.
Select Damp Dry for most loads.
Select ...setting and press Start/ Pause to the desired heat.
Maximim heat is paused.
Medium heat is recommended for 30 minutes to stop the dryer, press Options and Select at the end of the cycle.
Low heat is recommended for sturdy fabrics. to dust draperies. or to freshen clothing...
Operating Instructions - Page 3
...
Extended Tumble
Signal Volume
*
*
* Factory setting
Available settings
*
*
*
*
*
*
*
*
** Estimated cycle duration is displayed, an error has occured.
PN 134609300 (0511) Error Code 4 beeps / E4A
Error Dryer ran too long
Possible Causes Lint filter blocked. Ventilation system clogged.
Make necessary corrections, then select a cycle and press START. Disengage...
Installation Instructions - Page 2
... air flow will be exhausted into the laundry area. Ensure the present duct is prohibited for use 4-conductor cord for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
OUTLET RECEPTACLE - Risk of insects and rodents. If the dryer is in a garage, it with clothes dryers. The dryer MUST NOT be expelled into a chimney, a wall...
Installation Instructions - Page 3
...27 cm) pipe. 3.
On carpet. Air openings are set up for proper...dryer. 3.
Directional exhausting can be used to the dryer. 6.
No other fuel burning appliance shall be installed in the absence of the dryer:
• Only the rigid metal duct work...proper operation. cm)
60 sq. Read the measurement on electric dryers... copper connecting pipe that will come in excess of the door,...
Installation Instructions - Page 4
... (12.70)
25/8" (6.67)
22¾" (57.79)
243/8" (61.91)
15/8" (4.13)
Electrical supply on rear of unit
13½" (34.29)
To rear and base exhausts
23/8" (6.03)
Gas supply pipe on... rear of unit
27" (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" (68.58)
Stacked Dryer Installation Dimensions
27" (68.58)
T2T2T2T5i8839oooon..".275c(fccc1r55"hlllo(eee3""...
Installation Instructions - Page 5
... current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is preferred.
2. When installing a gas dryer into a mobile home, a provision must be made for other important venting requirements.
6. Refer to an upright position.
Rigid metal duct is not applicable, with no...
Installation Instructions - Page 6
Open the dryer door. 2. Support the door assembly firmly before removing the top screw.
7. Hold the door near the top and bottom ... inner door. While supporting the door, install the two screws removed in the holes left by the hinge and hinge screws.
10. DRYER DOOR REVERSAL INSTRUCTIONS
Be sure to remove the door. 4. Place door assembly face down on the opposite side of the front panel. ...
Installation Instructions - Page 7
... equipped with a licensed electrician if you are in this dryer utilizes and can result if the dryer is properly grounded. Follow the instructions in doubt as to be plugged into a properly grounded three-prong receptacle. Locate the dryer within reach of electrical current this manual for the proper power cord to whether the appliance is equipped with this...
Installation Instructions - Page 8
...as boxes, clothing, etc.) ...dryer (see pages 6 and 7). Place these instructions in your dryer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for proper...ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM NON-CANADIAN ELECTRIC Dryer
VALVE OPEN / GAS FLOW POSITION
1. NOTE: DO NOT connect the dryer to the silver-colored center terminal on a soapy water solution. If this dryer...
Data Sheet - Page 1
... between thermistor and electronic control.
Press Pause Cancel and SELECT buttons for 6 seconds to the board has occurred. If dryer operates normally but the key struck code still exists, ... (heater relay) on gas models, replace electronic control. If meter reads 240V on electric models and 120V on electronic control. Disconnect wire going to HIGH HEAT and touch START...
Data Sheet - Page 2
...7-11 turns: All LED's will make the Damp LED come on . Control thermistor reading is off . After entering...is displayed.
3 turns:
Drive motor runs; b. Press and hold the Select and Cancel buttons simultaneously for 2 seconds. "H" and the control thermistor ... Cancel key is off . Control thermistor reading is lit. Dryer will make the numbers decrease. In controls that do not ...
Similar Questions
Hi I Need A Light Bulb For My Dryer Aeq6700fs What Size And Kind Do I Need?
(Posted by nak857 1 year ago)
I Got An Error Message Of E52 On My Frigidaire Affinity Gas Dryer ,model# Fasg70
The code indicates that the motor is not starting, it also says that the motor thermal protector mig...
The code indicates that the motor is not starting, it also says that the motor thermal protector mig...
(Posted by tburke5065 9 years ago)
Affinity Gas Dryer Venting
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
(Posted by schielej 12 years ago)
Blinking Lights
The three lights drying/cool down/extended tumble keep flashing; if we hit cancel they stop but the ...
The three lights drying/cool down/extended tumble keep flashing; if we hit cancel they stop but the ...
(Posted by rachiealbs 13 years ago)
Why Would The Dryer Shut Off But The Timer Keep Running After 30 Minutes?
(Posted by mariogourde31 13 years ago)