2005 Ford F150 Support Question
2005 Ford F150 Support Question
Find answers below for this question about 2005 Ford F150.Need a 2005 Ford F150 manual? We have 10 online manuals for this item!
Question posted by Owllymama on May 28th, 2014
My 2004 F150 The Wrench Light Comes On When I Put It In Reverse
The person who posted this question about this Ford automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Scheduled Maintenance Guide 4th Printing - Page 46
...Axle Maintenance ❑ Rear axles and power take off (PTO) units containing synthetic lubricant and light duty trucks equipped with Ford-design axles are listed below: Maximim Oil Change Interval ❑ ...WSL-M2C192-A, part number FITZ-19580-B or equivalent. change Premuim Gold coolant (whichever comes first) ❑ After initial change may be changed anytime the axle and PTO have...
Owner Guide 5th Printing - Page 14
... Displays when the fuel level in the ignition) and the driver's door is opened . Refer to come on , have the system serviced immediately by your authorized dealer. Key-in-ignition warning chime: Sounds ... and Specifications chapter. Continued driving with this chapter). If the light remains on . Trans Fault: Displays when a transmission problem has been detected and shifting may ...
Owner Guide 5th Printing - Page 22
If the volume is set a station: Select frequency band AM/FM; CD: Press to manually reverse in a CD track. 11. Rewind: Press to enter CD mode. tune to select AM/FM ... of radio stations or CD tracks. If a CD is already loaded into the system, CD play will come back on at a "nominal" listening level when the ignition switch is turned off, the volume will begin where it ended last...
Owner Guide 5th Printing - Page 25
...change which side of the tape is set a station: Select frequency band AM/FM; Rewind: Press to manually reverse in a tape or CD track. 12. Tape direction: Press to eject a CD.
20. tune to enter... the volume is playing. 16. If a CD is already loaded into the system, CD play will come back on at a "nominal" listening level when the ignition switch is turned off, the volume will ...
Owner Guide 5th Printing - Page 29
... Press to load a CD. LOAD: Press to select AM/FM frequency band. 16. FOLDER: press to manually reverse in a CD track. 11. tune to a station, press and hold to autoload up to manually advance in... presets: To set above a certain level and the ignition is turned off, the volume will come back on at a "nominal" listening level when the ignition switch is already loaded into the system...
Owner Guide 5th Printing - Page 45
...you will need to the horizontal line. 6. Turn on each headlamp, then use a 4 mm socket/wrench to turn the adjuster either counterclockwise (to adjust down to activate the left turn signal. • ...as the horizontal reference line. 5. Cover one of the light pattern up to adjust up) aligning the upper edge of the headlamps so no light hits the wall. 4. TURN SIGNAL CONTROL • Push...
Owner Guide 5th Printing - Page 47
...Condensation The headlamps are pressed and the ignition is normal and will clear within 45 minutes of the lamp, the center light, can only be turned ON or OFF by sliding the control. When moist air enters the headlamp(s) through the vents,... . • the instrument panel dimmer switch is rotated up until the courtesy lamps come on. • any door is opened . This condensation is OFF.
Owner Guide 5th Printing - Page 49
...peel the protective cover back from the lower screws and loosen the three retaining screws. 3.
Lights
2. Slide headlamp assembly forward disconnecting the snap attachment at the top center of the headlamp assembly... the bulb only by turning it counterclockwise, then pull it up. 4. Install the new bulb in reverse order.
49
2005 F-150 (f12) Owners Guide (post-2002-fmt) USA (fus) Once the...
Owner Guide 5th Printing - Page 50
...Make sure the headlamp control is in the OFF position and open the hood. 2.
Install the new bulb(s) in reverse order. Replacing tail/brake/turn signal/sidemarker bulbs 1. Open the tailgate to expose the lamp assembly screws and remove ...(fus) At the top and inboard side of the headlamp assembly by turning it up. 4. Lights
Replacing front parking lamp/turn signal/backup lamp bulbs 1.
Owner Guide 5th Printing - Page 51
...Carefully pull the lamp assembly straight rearward from the foglamp bulb. Install the new bulbs in reverse order.
51
2005 F-150 (f12) Owners Guide (post-2002-fmt) USA (fus) ... 3. Install the new bulb(s) in the OFF position. 2. Make sure the headlamp control is in retainers.) 4. Lights
3. Pull the bulb straight out of socket and press in the new bulb. Remove the bulb socket from the ...
Owner Guide 5th Printing - Page 61
...minutes after the ignition switch is turned to the OFF position or until any door is placed in R (Reverse) to adjust the left mirror. 2. Move the control in place.
61
2005 F-150 (f12) Owners ...the mirror. 3. Power side view mirrors To adjust your mirrors: 1. When the mirror detects bright light from the normal (high reflective) state to minimize glare. Return to the center position to lock ...
Owner Guide 5th Printing - Page 69
... Press and hold the two outside buttons releasing only when the indicator light begins to stop and reverse features as for programming and/or operation of the device being programmed ...you wish to Programming in this includes any garage door opener that lacks safety stop and reverse, does not meet current U.S. federal safety standards (this section. This will erase previously ...
Owner Guide 5th Printing - Page 92
...illuminates the exterior of 30 seconds to operate. Enabling/disabling the perimeter lighting feature Your vehicle comes with the dimmer control, or • any position other than the... 1 (OFF/LOCK) position, • the autolamp sensor determines that it is on with the perimeter lighting feature enabled. All vehicle doors must be closed , even if the dimmer control is dark, and •...
Owner Guide 5th Printing - Page 202
...(Reverse), the vehicle will move backward.
D (Overdrive) The normal driving position for the best fuel economy. Hold the brake pedal down while in P (Park). Driving
To put your vehicle. Always come to... the LOCK position and remove the key whenever you leave your vehicle in P (Park): • Come to a complete stop • Move the gearshift lever and securely latch it in P (Park) ...
Owner Guide 5th Printing - Page 204
... Guide (post-2002-fmt) USA (fus) Driving
1 (First) • Provides maximum engine braking. • Allows upshifts by shifting between forward and reverse gears, stopping between shifts in a steady pattern. Press lightly on the accelerator in the neutral position. 3. Press the clutch pedal to the transmission may overheat. Forced downshifts • Allowed in...
Owner Guide 5th Printing - Page 208
... or an increased chance of false detection if the tailgate is not turned off . An indicator light on the rear bumper/fascia) free from the rear bumper with sharp objects). If the tailgate ... the sensors are covered, it may be ON, and the gear selector in R (Reverse) and the ignition is placed in R (Reverse). When the obstacle is down, the RSS tone may indicate a failure in the RSS...
Owner Guide 5th Printing - Page 213
...over 35 mph (56 km/h). Do not rock the vehicle if the engine is not at over . Press lightly on the apron or shoulder of the pavement, slow down or if you do not slow down , but ...while returning to the road surface. • It may be rocked out by shifting between forward and reverse gears, stopping between shifts, in an increased risk of loss of others should be less risky to strike...
Owner Guide 5th Printing - Page 221
... the vehicle if the engine is stuck, shift the transmission in a steady motion between forward and reverse gears. The tires may cause damage to provide maximum airflow. 221
2005 F-150 (f12) Owners Guide...(8 km/h). • Shift transfer case to 4H (4WD High) when plowing larger areas or light snow at a higher temperature than normal because the attached snowplow blade will not need to worry ...
Owner Guide 5th Printing - Page 264
... a computer, some control conditions are maintained by power from the battery. When lifting a plastic-cased battery, excessive pressure on and allow flames, sparks or lighted substances to come near the battery to idle for a minimum of children. Because your eyes when working near the battery, always shield your face and protect your...
Quick Reference Guide 1st Printing - Page 8
...is stopped and the gearshift lever is started , refer to your Owner's Guide. If the light comes on after the engine is engaged, an icon will illuminate if the fuel cap is reached ...a previously set the speed control, press the ON button and release. Also, you .
If the light comes on after the engine is in two programmable positions using the control located on the driver's seat. ...
