1997 Ford Expedition Support Question
1997 Ford Expedition Support Question
Find answers below for this question about 1997 Ford Expedition.Need a 1997 Ford Expedition manual? We have 6 online manuals for this item!
Question posted by Anonymous-127231 on December 23rd, 2013
Stolen Keys
My keys were stolen. How much will it cost to replace them?
Current Answers
Related Manual Pages
Owner's Manual - Page 7
... Illuminates when the fuel level is high. Illuminates when the engine coolant temperature is low. LOW FUEL
Engine coolant temperature Illuminates briefly when the ignition key is turned to Checking and adding engine coolant and What you should know about fail-safe cooling in the Maintenance and care section.
8
Stop the...
Owner's Manual - Page 8
... windshield washer fluid is low. Instrumentation
Low washer fluid Illuminates briefly when the ignition is turned to On. Oil pressure Illuminates briefly when the ignition key is turned to On. The light also illuminates when the battery is not charging properly, requiring electrical system service.
9
Owner's Manual - Page 9
... engine is off. Check engine warning light This light illuminates when the engine's Emission Control System requires service. It will also illuminate when the ignition key is switched on , have the system serviced.
For more information, refer to Supplemental restraints system (SRS) in the Maintenance and care chapter. BRAKE ! If the...
Owner's Manual - Page 11
... anti-theft system is turned to be serviced. High beams Illuminates when the headlamp high beams are turned on .
Fuel reset Illuminates when the ignition key is operating properly. ABS
FUEL RESET
THEFT
Turn signal Illuminates when the left or right turn signal or the hazard lights are on .
12
Owner's Manual - Page 12
... 80
100
70
120
L H 18 C 8
000005
80
140
2
THEFT
3
4 5
ABS
BRAKE
!
10 0
90
1 0 RPMx1000
CHECK ENGINE
0 0 1 0
100
6
LOW RANGE 4x4
FUEL RESET
Turn the ignition key to the ON position and the engine is OFF. The light also illuminates when the air suspension system requires servicing. Safety belt warning chime For...
Owner's Manual - Page 13
Headlamps on warning chime Sounds when the headlamps are on, the ignition is off (and the key is not in the OFF/LOCK or ACC position and the driver's door is opened . INSTRUMENT CLUSTER GAUGES
F...000005
km/h
20
20
80 90
140
10 0
180
MPH
100
14 Instrumentation
Key-in-ignition warning chime Sounds when the key is left in the ignition in the ignition) and the driver's door is opened .
Owner's Manual - Page 39
... the steering wheel and automatic gearshift lever. 3(Off) - shuts off the engine and all accessories without locking the steering wheel. 4(On) - tests the warning lights. Key remains here when engine is not running . 5(Start) - cranks the engine. Controls and features
Positions of the ignition switch 1(Accessory) - allows electrical accessories such as...
Owner's Manual - Page 66
... with your dealer or selected retailers. Your vehicle is equipped with the Ford logo to ensure proper functionality. If both supplied keys are lost or stolen, the vehicle and any other keys must be started. For more information on this indicator and its function, refer to start. Without the use of the anti...
Owner's Manual - Page 67
... or Start. There are several possible explanations: • The new key was not inserted within 15 seconds. • All 16 key codes have already been stored. • The key does not have to be started to 16 keys. Controls and features
• Insert a coded key into the ignition and turn to the On position. •...
Owner's Manual - Page 76
Removing the third row seat From the rear of the detachable buckle.
77 Disengage the lap/shoulder belt from the floor by pressing a key down the slot of the vehicle, with the liftgate open: 1. Press down onto the cushion. 3. Locate the lever at the bottom of lever "1" while pressing ...
Owner's Manual - Page 85
...use the safety belt extension only if the safety belt is located at no cost from your Ford or Lincoln/Mercury dealer.
Use only extensions manufactured by the ... light is illuminated and the reminder chime is sounding ...The driver's safety belt is buckled before the ignition key is turned to On...Then ...The safety belt indicator illuminates for 1-2 minutes and the warning chime sounds for...
Owner's Manual - Page 101
P
• Make sure the parking brake is set. • Make sure the gearshift is in P (Park).
3. Turn the key to the ON position (without turning the key to START.)
102
Starting
2. Make sure the headlamps and vehicle accessories are off.
Owner's Manual - Page 102
... ENGINE
0 0 1 0
100
6
LOW RANGE 4x4
FUEL RESET
Make sure the corresponding lights illuminate briefly. If a light fails to 5 (Start) without pressing the accelerator. Turn the key to illuminate, have the vehicle serviced. • If the driver's safety belt icon is light does not fastened, the illuminate. STARTING YOUR VEHICLE Starting the...
Owner's Manual - Page 116
... 2(Second) to start-up on slippery roads or to the proper speed. Upshifts can be made by shifting to 2(Second) or to Off (3). 2. Turn ignition key to D (Overdrive).
Transmission operates in the On position). Brake-shift interlock The brake-shift interlock feature prevents you cannot move the gearshift out of P(Park...
Owner's Manual - Page 117
... blown and your vehicle until you need to use the above procedure, it to the Roadside emergencies chapter for instructions on replacing fuses. Do not drive your brakelamps may not be functioning. Start the vehicle. Re-insert the ignition key and turn it is possible that the brakelamps are working.
118 Driving
3.
Owner's Manual - Page 125
... distributed, particularly when loading at or near the roof or luggage rack crossbars maximum capacity. Remove the knurled knobs. 2. Pull the crossbar rearward from the key slot. The rear crossbar can be removed by unlocking the levers and pulling the crossbar rearward.
126 To remove the front crossbar: 1.
Owner's Manual - Page 134
Roadside emergencies
1. Check fuel system for a few seconds and return the key to replace the fuses.
Turn the ignition switch to the ON position. Turn the ignition switch to...the OFF position. 5. Use the fuse puller tool provided on the switch. 4. Always replace a fuse with a higher amperage rating can cause severe wire damage and could start a fire.
135 Check the appropriate fuses ...
Owner's Manual - Page 156
... the vehicle, pull the hood release handle located under the center of the instrument panel. 2. Working with the engine off the engine and remove the key. 3. Lift the hood. 4. Set the parking brake fully and ensure the gearshift is closed securely. Maintenance and care
1.
Owner's Manual - Page 187
...
• Install cables securely, verifying that the cables do not touch any wiring, brake lines or fuel lines. • Drive cautiously. FUEL INFORMATION The ignition key must be turned to 3 (Off) or 1 (Acc) during refueling to prevent vehicle damage. • Avoid overloading your vehicle. • Remove the tire cables when they...
Owner's Manual - Page 223
... ...12 Vehicle dimensions ...218 Vehicle headlamp aiming device (VHAD) ...206 Ventilating your vehicle ...105 Voltmeter (see Battery voltage gauge) ...16 Warning chimes headlamps on ...14 key in ignition ...14 safety belt ...13 Warning lights (see Lights) .8,144, 145 Windows accessory delay ...59 Windshield washer fluid and wipers ...179 checking and adding...
Similar Questions
Which Fuse Is For The Key To Start It On A Expedition 97
(Posted by nemamaci 9 years ago)
How To Replace Battery In 2012 Ford Expidition Key
(Posted by kikricc 10 years ago)
Carkey Chip Broke For A 1997 Ford Expedition And Theft Light Flash Rapidly
car dont star i only have one key. i have another key same year can i use that chip for my key to st...
car dont star i only have one key. i have another key same year can i use that chip for my key to st...
(Posted by victorianoyolanda 10 years ago)
How Do I Get The Key Code For My 1998 Ford Expedition
NeedNeeded tI unlock the Door and turn the alarm off
NeedNeeded tI unlock the Door and turn the alarm off
(Posted by Mikepr305 11 years ago)