Electrolux EDW5505E Support Question
Electrolux EDW5505E Support Question
Find answers below for this question about Electrolux EDW5505E - 24 in. Dishwasher.Need a Electrolux EDW5505E manual? We have 2 online manuals for this item!
Question posted by avheli11 on September 3rd, 2013
Unit Will Not Start When Pushing The Start Button.
I set the cycle on the control panel, but when I press the start botton the light does not go on and the unit does not start at all. I have left it for hours but does stillnot start.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on September 4th, 2013 12:55 PM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Good Afternoon. Thanks for posting your concerns online. From what you have briefly described it sounds like the unit is having a communication error from the control panel to the rest of the unit. If you do not notice any lights or sounds indicating the unit has turned on, try resetting the appliance at its power source. If the unit still does not turn on you would require a professional to diagnose the control board and control panel (where you press buttons) for possible repairs.
Online Outreach Specialist
Related Electrolux EDW5505E Manual Pages
Use and Care Manual - Page 4
... 10 General Recommendations 10 10 Place Setting Load 10 12 Place Setting Load 10 Upper Rack 11 Lower Rack 12 Loading the Silver Basket 13 Adjustable Upper Rack 14 Removing the Upper Rack 14
Dishwasher Use 15 Hot Water 15 Detergent 15 Rinse Aid 16
Cycles, Options and Lights 17 Cycles 17 Options 18 Delay 19...
Use and Care Manual - Page 8
... the dishwasher off . To start a cycle, press the START/Cancel pad once then close the door until it latches. After loading the dishwasher and adding detergent, select the desired cycle and options by pressing the pads. OPERATING THE DISHWASHER
1. The indicator lights for an extended period of choosing your last cycle so you do not have been "locked in " after the controls...
Use and Care Manual - Page 18
... Lock Option
Locks control touchpad to automatically start the cycle at the end of some items such as are needed for your dishload. See page 20 All Cycles for instructions.
* Only these cycles have been met, Sanitized light will escape even if Air Dry is selected, towel drying of the cycle. 18 Cycles, Options & Lights
OPTIONS
In addition to...
Use and Care Manual - Page 19
... pad is counting down . 5. The cycle will start or resume immediately. To cancel a Delay and the cycle:
• Press START/Cancel once to drain and turn dishwasher off . Close the door. 2. Cycles, Options & Lights 19
DELAY
The Delay option can be used to automatically start the cycle at times of high household usage (showers, laundry). To set up a Delay:
1. Select the...
Use and Care Manual - Page 20
....
• This option does not lock the door, only the dishwasher controls. IMPORTANT
• When Sanitize is pressed after the controls have been met to achieve sanitization. LIGHTS/DISPLAY
Indicator
Clean Light
Sanitized Light
Description
Illuminates at the end of the cycle and remains lit until the controls are monitored to assure sanitization.
If this feature is run. An...
Use and Care Manual - Page 22
... the electrical supply and prop open the door. To drain, press the START/Cancel pad once to ensure most of the water is removed. Operate the drain twice to activate the dishwasher. Allow the dishwasher to activate the drain. Press START/Cancel again to complete the cycle. When turning the water supply to the home off, the...
Use and Care Manual - Page 23
... home's circuit breaker or fuse box. • Check that the cycle is completed. Problem
Solution
Dishwasher will not fill
• Press the START/Cancel pad to help save you time and money.
Select China cycle and allow it stand overnight. Dishwasher will
dissipate with use a dishwasher cleaning product such as the internal food
disposer chops hard items...
Use and Care Manual - Page 25
...C). • Run hot water at the sink before starting the dishwasher. • Check water hardness and adjust detergent amount accordingly
...dishwasher detergents may stain silver. Check with concave bottoms hold water and require towel drying. If light...loading, scrape off burnt-on the dishwasher interior after the dry cycle
• Be sure Air Dry is...setting. • Check water temperature.
Service Manual - Page 3
... : switch on the appliance, no cycles selected. GEn
GEn
Fig. 1.4 Enter into General Parameters (Hold down buttons for at least
five seconds).
888
888
888
888
888
888
Fig. 1.6 Next Parameter Family OR Increase Parameter Value
(In setting mode only)
DOC.
Dishwashing Systems Platform Electrolux Professional
Electronic Dishwasher SERVICE MANUAL
1. KEYBOARDS
1.1.
Fig. 1.3 Rinse...
Service Manual - Page 4
..., no cycles selected. Is useful keep door open to EMPTY BOILER)
SETTING MODES: To enter into Factory Parameters (Hold down buttons for at least five seconds). FAC TANK BOILER
Fig. 1.5 Enter into one setting mode (Fig... Rinse Pump Manual Activation (used to avoid start cycle in stand-by Electrolux Professional
P.4/88 Dishwashing Systems Platform Electrolux Professional
Electronic...
Service Manual - Page 5
Electrolux
EFS - Detergent Dispenser Activation
dEt
Switch on the dishwasher.
DOC. Press and hold down CYCLE_1 and CYCLE INFINITE keys, after two 'beep' the detergent dispenser starts work for 40 sec.
3. RINSE PUMP MANUAL ACTIVATION
Use this function to empty the boiler (if the dishwasher is not to be necessary activate the dispensers to fill hoses...
Service Manual - Page 6
...dishwasher; • Enter into User Mode
(press...Unit Min Max
[s]
0 240
[s]
0 180
[s]
0 182(*)
[s]
0 62 (*)
Factory Default
90 10 8 4
How change the other duration; The display shows alternatively the symbol dIn and the duration in seconds (Fig.3.2 and 3.3); rIn
Fig. 3.4 Initial rinse aid dosage
24
ª ©
Fig. 3.5 Change duration
dEt
8 DEFAULT
ª ©
rAi
Fig. 3.6 Cycle...
Service Manual - Page 11
.... 5956.446.06
CY2
Cy3
Ln3
...
ª ©
Fig. 6.11 Cycle 2 Parameters:
next Family
Fig. 6.12 Cycle 3 Parameters:
ENTER
©Copyright 2005 by pressing CYCLE_2 key is possible to change the Cycle 2 parameters (Fig.5.8, 5.9) and so on the dishwasher; • Enter into the FACTORY SETTING mode: press and hold down ON/OFF and CYCLE_2 keys for at...
Service Manual - Page 12
Electrolux
EFS - Dishwashing Systems Platform Electrolux Professional
Electronic Dishwasher SERVICE MANUAL
CYCLE DIAGRAM
CYCLE TYME
WASH
IPA Ln Sh
PA
PRE RINSE
Pr
DETERGENT
DEt
RINSE
ri
COLD RINSE
cr
DRAIN
dr
RINSE PAUSE
rPA
FINAL PAUSE
FP
RINSE AID
RAi
DOC. NO. 5956.446.06
©Copyright 2005 by Electrolux Professional
P.12/88
Service Manual - Page 14
...software version.
-
F21 This alarm appears in case of pause after rinse cycle (valid for
dishwashers with incorporated continuous
-
PPL Pulse Per Litre. C 8 When C 8...(DAAS 8E1)
48 = Hyper Terminal (8N1)
Adr Address. Parameter Description
Unit
Min
Max
Factory Default
IPA Initial Pause before start washing (for ALL cycles)
[s]
0
10
0
dLY Delay for the 2nd wash pump (PW only...
Service Manual - Page 15
...176;C]
0
20
10
CFG Configuration Parameters
Sym. rE
Enable "regeneration cycle" key (only for dishwashers with Solid State Relay).
Parameter Description
Unit
Min
Max
Factory Default
tYP Dishwasher Model: 0 = HOOD TYPE & UNDERCOUNTER
1 = POT WASHER 2 = AUTOMATIC POT WASHER
-
0
3
0
3 = MEDICAL LINE DISHWASHER WITH LOCK DOOR/HOOD
DEVICE
boi
Boiler type: 0 = ATMOSPHERIC BOILER...
Service Manual - Page 17
... end of other wash cycles.
Electrolux
EFS - SPECIAL FEATURES
9.1 RESIN REGENERATION CYCLE
TANK BOILER
The regeneration cycle is activated by pressing the button shown in the figure, for the entire duration of the parameter rPA (in the
tank must be accessed by means of the work cycle in the dPA family) the dishwasher inhibits the activation of...
Service Manual - Page 24
...this appliance SOFT START is NOT possible).
Regeneration cycle disabled. PROGRAMMING SHEETS
LS12 - Manual Hood. Enable filling tank by Electrolux Professional
P.24/88 Modify Factory... set to 1). Tank heater works only if boiler temperature reached. Detergent level switches not enabled. Atmospheric boiler. Dishwashing Systems Platform Electrolux Professional
Electronic Dishwasher SERVICE...
Service Manual - Page 75
... CLOSEwith door/hood closed No cycle starts
A cycle fails to start After replacing the main board only the 3rd cycle starts Cycle time longer than that foreseen
Noisy wash pump (only on HT and PP versions)
Check door/hood micro/sensor Check the user interface buttons (have they remained pressed? NO. 5956.446.06
©Copyright 2005...
Service Manual - Page 87
...FREE POSITIONS ON THE BOARD. Dishwashing Systems Platform Electrolux Professional
Electronic Dishwasher SERVICE MANUAL
D Alarms that don't stop the functioning, but suggest to the heating element work properly? Does the possible remote control switch connected to call the service
E 1 E 2 E 3
Communication error
Is the connection between main board and control panel correct? NO. 5956.446...
Similar Questions
How To Reset Electrolux Icon Dishwasher From Control Panel
(Posted by tchdd 9 years ago)
Electrolux Dishwasher Control Panel Does Not Power
(Posted by mrbjaros 9 years ago)
Start Button No Longer Works All Others Work. So I Cant Start
It wont light up so it wont start when you close it
It wont light up so it wont start when you close it
(Posted by jmashos 11 years ago)
Trouble Shoot Help
Can any expert help me to trouble shoot Electrolux safe wash hood type dish washing problem,the mach...
Can any expert help me to trouble shoot Electrolux safe wash hood type dish washing problem,the mach...
(Posted by jdanty 12 years ago)
Won't Start
The lights on the control panel work, but when I touch it nothing happens. So I can't start the dish...
The lights on the control panel work, but when I touch it nothing happens. So I can't start the dish...
(Posted by rossfromnb 12 years ago)