Home » EdgeStar » Wine Racks & Cellars » EdgeStar BR2000BL

EdgeStar BR2000BL Support Question

Find answers below for this question about EdgeStar BR2000BL.
Need a EdgeStar BR2000BL manual? We have 1 online manual for this item!

EdgeStar Overview Questions Manuals Reviews Videos Research

Question posted by dnastauf on July 14th, 2015

Running Too Cold After Thermostat Adjustment.

Which direction do you turn the adjustment screw to raise the temperature?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by lawDaimy on July 14th, 2015 10:05 AM

This answer was accepted by the poster of the original question.

lawDaimy

Member since:
August 20th, 2014

Points: 149,240

1,100
points

Watch the video link for assistance.

thanks

lawDaimy

Related EdgeStar BR2000BL Manual Pages

Owner's Manual - Page 2

...replaced by authorized technicians. • Do not immerse the appliance or its power supply cord in room temperature environments (mid 70°s Fahrenheit). • Do not move the unit while it is full.... the appliance prior to cleaning. • Set the appliance on a level surface away from direct sunlight and other heat sources. • This appliance is designed to remove the door of the...

Owner's Manual - Page 4

...REFRIGERATOR 4-6 Proper Location 4 Installing the Casters 5 Grounding Instructions 5 Understanding the Temperature Control Setting 5 Automatic Defrosting 5 Understanding Normal Operating Sounds 6 Installing the Guardrail...Beer and Proper Drawing Technique 11 Beer and Clean Glasses 11 Understanding Beer Temperature 12 Beer Serving Guide 13 Converting the Beer Dispenser to a Refrigerator ...

Owner's Manual - Page 5

... should not be placed in a built-in a location where there is proper air circulation and electrical connections. • Keep the refrigerator away from heat and direct sunlight. • This refrigerator is designed for "indoor" use only and should not be used outdoors. • This refrigerator should not be freestanding. • The...

Owner's Manual - Page 6

...power cord. No other appliance should be directed toward a certified electrician. • This...Screw the casters in an upright position. Be careful to cool properly. The defrosted water collects in a humid area, excessive ice may then adjust the temperature... setting based on your keg is not usually necessary to stand in an upright position for 8 hours before turning...

Owner's Manual - Page 7

...the automatic defrost cycle. Align the faucet handle to be parallel with the beer tower with the spigot facing downward and screw in the faucet counter-clockwise with the hole in a safe place as ice melts from inside the unit). Understanding Normal... and pull upward. (It may help to convert the beer dispenser into place (about ¼ a turn) 4. Take the tower and untangle the tubing.

Owner's Manual - Page 8

... contain high-pressured gas, which can be hazardous if handled improperly. Please handle with an adjustable wrench. 5. Run the other end of the CO2 tubing through the open hole through the inside of the ..., attach one of the CO2 tube, to the hose barb connection on the holder with the four screws protruding out of the back of the cabinet. 3. Remove the plug located at the exterior back....

Owner's Manual - Page 9

turn clockwise 1/4- Now the keg coupler is closed (perpendicular to the nose). After handtightening the nut, use an adjustable wrench to lock into place. Listen for the "click" of the ...keg and rest the edge on the metal keg floor support on to ensure that a washer be used. Turn the screw jutting from the tower) to the top of the pull handle when it on the bottom of the beer ...

Owner's Manual - Page 11

...ensure an accurate output reading. 10 Slowly turn the regulator adjustment screw until the desired pressure is shown on the regulator, and if necessary re-adjust using step #2 until the pressure has ... and open the valve on most regulators designed for draft beer, turning clockwise will increase the output pressure, and turning counter-clockwise will return to the keg coupler. Then the needle ...

Owner's Manual - Page 12

.... Level the Glass and finish topping off position when the draw is plugged in a dish rack. Wash them with glasses that are extremely hard to the enjoyment of . Proper foam should leave...tight, creamy head, and the head on "Beer Clean") 3. Rinse a "Beer Clean" glass under cold water. (see below for more than water is not clean. Dispensing the Beer and Proper Drawing Technique ...

Owner's Manual - Page 13

...will match the liquid temperature inside the keg) is no longer enough to keep the carbonation in the beer. • On the other hand, having the beer too cold causes the carbonation to...from the beer while it travels through the system from the Note: During summer months, adjust the temperature control to stay in liquid inside the refrigerator cabinet. This is necessary to determine if ...

Owner's Manual - Page 14

... frequently. Plug the hole in a safe place for "free-standing" use . Adjust the temperature of direct sunlight and away from heat sources such as required for food storage. Place your ...the keg and all fittings. 2. Note: Refer to the CO2 cylinder safety precautions for 8 hours before turning on a regular basis will foam. Note: Allow the fridge to support its total weight, keeping in ...

Owner's Manual - Page 15

...Recent keg agitation Improper regulator setting Internal temperature of the refrigerator - Improper regulator setting....thermostat control is not "Off" Food in another appliance or furniture. The thermostat knob is not in contact with another appliance. - Check to escape. - Turn the thermostat...drawn is noisy when running - If the beer keg has been exposed to get cold (5-12 hours or...

Owner's Manual - Page 16

... air line or dispenser line and that neither are open. See "Cleaning and Maintenance" Ensure proper connection of foam (See "Beer Clean Glassware" ) All recommended temperatures and gauge settings are in place and in either the air line or dispenser line and that neither are frozen. Verify that there are no...