How To Use Recover Button On Dish Remote

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on April 12th, 2014 1:18 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,100
points

I would be happy to help if you are still having this issue! The following link will give you steps on how to do this. You just want to choose your receiver on the left! http://www.mydish.com/support/restore-receiver-settings-222k-722k

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 942 : Install : 942 Initial Install
...and 942 using the TV1 audio/video outputs, and attach the UHF remote antenna and...HD resolution (720p or 1080i) that the Recover button works for an initial install on Remote Control 2. Off-Air Antenna: If you ...Remote Control 2 to the same channel as needed: Program each remote TV. If not, you cannot see a picture from the Point Dish/Signal screen and selecting Yes on either remote...
Tech Portal : Remotes : Buttons & Images
... first set up the remote to toggle TV screen formats. Press the FWD ("forward") button to swap the video in a menu. Press the dish button to go back to cancel and go of channels. Press the PIP button to control the TV and, if installed, the VCR. Program information - Number Buttons - Recover Button / Input – Use the RECOVER button if you highlight...
Tech Portal : 3750 : Errors & Troubleshooting
...5000, 111, 322, and 522 receivers use the remote control Recover button to cycle through the DPP Separator on free access usually means the receiver is used for 15 minutes to update old software ... List, Timers, Themes, Search, and Channel Locks. Enhanced Locals channels are not in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels...